READ AND SAVE THESE INSTRUCTIONS
WARNING:Ariskoffireandelectricalshockexistsinallelectricalappliances
andmaycausepersonalinjuryordeath.Pleasefollowallsafetyinstructions.
Use and Care Guide Model 3332S
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and injury to persons, including
the following:
• Read all instructions before using appliance.
• Close supervision is necessary when appliance is used near children.
• This appliance is not for use by children.
• Do not operate any damaged appliance. Do not operate with a damaged cord
or plug, or after the appliance malfunctions, or has been dropped. Do not
disassemble the iron. Return appliance to the nearest authorized service facility
for examination, repair or mechanical adjustment.
• Do not place any part of the unit inor under water or other liquid. Seeinstructions
for cleaning.
• Do not use outdoors or while standing in damp area.
• Do not use appliance for other than intended use.
• The iron should be turned to MIN before plugging or unplugging from outlet.
Never yank cord to disconnect from outlet; instead grasp plug and pull to
disconnect.
• Do not allow cord to touch hot surfaces. Let iron cool completely before putting
away. Loop cord loosely around iron when storing.
• Always disconnect iron from electrical outlet when filling with water or emptying
and when not in use.
• Burns can occur from touching hot metal parts, hot water, or steam. Use caution
when you turn a steam iron upside down — there may be hot water in the
reservoir.
• Do not leave hot iron unattended.
• Position iron carefully on ironing board to avoid it from being knocked over.
SPECIAL INSTRUCTIONS
• This is a high wattage appliance. To avoid a circuit overload, do not operate
another high wattage appliance on the same circuit. If an extension cord is
absolutely necessary, a 10-ampere cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange the cord so that it
cannot be pulled or tripped over.
Download from Www.Somanuals.com. All Manuals Search And Download.
SAVE THESE INSTRUCTIONS
THIS PRODUCT FOR HOUSEHOLD USE ONLY.
FEATU
1. Water tank opening
2. Spray nozzle
3. Spray button
4. Blast of steam button
5. Swivel cord
6. Power on/ready light
7. Auto off/on light
8. Water-level indicator
9. Temperature control dial
10. Steam/dry switch
11. Inox stainless steel soleplate with steam vents
USING YOUR IRON
Note: Before you use your iron for the first time, you should flush the soleplate steam vents to
ensure that no stain is transferred onto fabric from residue possibly left in the vents from the
manufacturing process. To do that, see SELF-CLEANING/FLUSHING.
TEMPERATURE AND STEAM GUIDE
Fabric
Temperature/Steam
Delicates
Nylon
Low
Acetate
Silk
Polyester
Wool
Medium
High
Cotton
Linen
2
Download from Www.Somanuals.com. All Manuals Search And Download.
DIAGRAM 3
DIAGRAM 4
IRONING WITHOUT STEAM
The iron can be used on the NO STEAM dry setting with or without water in the tank. However it
is best to avoid having the tank too full of water while dry ironing.
1. Position temperature control dial to MIN, lowest setting. Diagram 3.
2. Shift the steam setting switch to the NO STEAM setting. Diagram 4.
3. Stand the iron on its heel in an upright position on an iron-safe surface and plug it in.
4. Turn the temperature control dial to the desired setting. Diagram 3.
5. When the indicator light turns off, the iron has reached the desired temperature.
6. If desired, you may still use the spray or burst buttons, as long as there is water in the tank.
7. When finished, turn temperature control dial to MIN, lowest setting, and unplug. Diagram 3.
Allow to cool before cleaning or storing.
NOTE: During ironing, the ready light may turn on again which indicates that the iron is heating up
to maintain the proper temperature.
CAUTION: If the iron has been used for a long time and is hot, DO NOT fill it with water.
IRONING WITH STEAM
When using as a steamiron, be surethe temperature setting onthe control dial is within the STEAM
range to avoid water spotting on a garment.
1. Position temperature control dial to MIN, lowest setting. Diagram 3.
2. With the unit UNPLUGGED, fill the iron with water. (See FILLING THE WATER TANK
instructions.)
3. Stand the iron on its heel in an upright position on an iron-safe surface and plug it in.
4. Turn the temperature control dial to STEAM. Diagram 3.
5. Allowapproximately2minutesfor theirontoreachthedesiredtemperature. (Theindicator light
will turn off.)
6. Shift the steam switch to the STEAM position. Diagram 4. As soon as the iron is held
horizontally, steam will flow through the vents. Placing the iron on its heel in an upright position
interrupts the flow of steam.
7. When finished, turn temperature control dial to MIN, lowest setting and unplug. Diagram 3.
Allow to cool before cleaning or storing.
CAUTION: Avoid coming in contact with escaping steam.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
IRONING WITH EXTRA STEAM
For a penetrating blast of steam to iron faster and to smooth difficult wrinkles, firmly depress the
blast of steam button. Between the individual blasts of steam, pause for at least 5 seconds to let
the iron reheat for maximum additional steam. If water drops escape as you use the blast of steam,
turn the temperature control dial to a slightly warmer setting and wait for the indicator light to go
out.
CAUTION: Avoid coming in contact with escaping steam.
USING THE SPRAY BUTTON
For a mist of water to moisten dry and difficult fabrics such as linen, cotton or wool, or to handle
stubborn wrinkles, press the spray button. The spray function is also handy to moisten creases
accidentally ironed into the fabric.
DIAGRAM 6
DIAGRA
MAX
FILLING THE WATER TANK
1. Unplug the iron before filling.
2. Press the steam switch in the NO STEAM position, and hold the iron upright. Diagram 4.
3. Using the enclosed measuring cup, slowly pour water into the water tank opening. Diagram
5. Afterwards, hold the iron horizontally and look through the water window to check the water
level. (Slightly more than 2 cupfuls with the enclosed measuring cup fills the tank to
maximum.) Diagram 6.
Note: Your iron is designed to use tap water. However, if your water is very hard, it is
recommended you use distilled water. DO NOT use water from home water softening systems
because such water may contain minerals that may harm the iron.
EMPTYING THE WATER TANK
The water tank should be emptied after each use. To do so:
1. Unplug the iron from the electrical outlet.
2. While the iron is still warm, hold the iron over a sink and allow the iron to drain by tipping the
point of the iron down.
3. Gently shake the iron to loosen any water drops that may be trapped. The warmth of the iron
should dry out any remaining water.
Note: If you empty the water tank after the iron has cooled, set the iron in an upright position on
its heel, plug it in and set the temperature dial to maximum heat for 2 minutes. Then unplug the
iron and let it cool before storing it.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
SELF-CLEANING/FLUSHING
Flushing the iron is advised after every 5 usages to prevent harmful mineral build-up that can clog
the iron and prevent it from heating and steaming properly. To flush the iron:
1. Position temperature control dial to MIN, lowest setting. Diagram 3.
2. Shift the steam switch to the NO STEAM position. Diagram 4.
3. Fill the iron’s water tank to its maximum fill line. Diagram 6.
4. Plug the iron in and set the temperature control dial to its highest setting
it heat for 2 minutes.
or linen. Let
5. Set the steam switch to the STEAM position.
6. Place a hand towel over the ironing surface.
7. Holding the iron horizontally 2 inches above the towel, depress the blast of steam button
several times, remembering to pause at least 5 seconds between blasts to allow the iron to
reheat.
8. Pass the iron over a damp cloth to clean the soleplate or use Faultless® Hot Iron Cleaner.
9. When finished, turn temperature control dial to MIN, lowest setting and unplug. Diagram 3.
Allow to cool before cleaning or storing.
STORING THE IRON
Remove the cord from the outlet by grasping the plug rather than pulling the cord and allow iron
tocool. EMPTYthewater tankafter each use, then wrap thecordaround thecooled iron asshown.
Diagram 5. Allow theironto COOL COMPLETELY beforeputting it away. Toprotectthe soleplate,
place the iron in an upright position on its heel.
CLEANING AND CARE
CAUTION: Unplug the iron from the electrical outlet before cleaning. Never immerse an appliance
in water.
To protect the soleplate from scratching, avoid ironing over snaps, zippers, metal buttons, etc.
Also, do not place the iron on metal or rough surfaces. If starch or other residues cling to the
soleplate, use FAULTLESS® Hot Iron Cleaner according to directions. Hot Iron Cleaner is
available at mass merchandise, discount or hardware stores. If these stores are not convenient,
you may order by mail by calling 1-800-892-8022.
Note: DO NOT put any chemical cleaning agents or solvents in the water tank.
IMPORTANT: Any servicing that requires disassembly must be performed by an authorized
service center.
SERVICE INFORMATION
Please refer to warranty statement to determine if in-warranty service applies.
This appliance must be serviced by a Toastmaster authorized service center. Unauthorized
service will void warranty. Consult your phone directory under “Appliances-Household-Small-
Service and Repair”, or call 1-800-947-3744.
If an authorized service center is not available locally, your appliance may be returned postage
prepaid to our National Service Center at the address shown in the warranty statement. Products
must be adequately protected to avoid shipping damage. Surround your appliance with three
inches of protective padding and include a note explaining the problem you have experienced. We
recommend insuring your package. No C.O.D. shipments accepted.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
ONE YEAR LIMITED WARRANTY
Toastmaster Inc. warrants this product, to original purchaser, for one year from purchase date to be free of defects in
material and workmanship.
This warranty is the only written or express warranty given by Toastmaster Inc. This warranty gives you specific legal
rights. You may have other rights which vary from state to state. ANY OTHER RIGHT WHICH YOU MAY HAVE,
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS
LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY.
Defective product may be brought or sent (freight prepaid) to an authorized service center listed in the phone book, or to
Service Department, Toastmaster Inc., 708 South Missouri St., Macon, MO 63552, for free repair or replacement at our
option.
Your remedy does not include: cost of inconvenience, damage due to product failure, transportation damages, misuse,
abuse, accident or the like, or commercial use. IN NO EVENT SHALL TOASTMASTER INC. BE LIABLE FOR INCIDENTAL
OR CONSEQUENTIAL DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts, or allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or exclusions may not apply to you.
For information, write Consumer Claims Manager, at the Macon address. Send name, address, zip, telephone area code
and daytime number, model, serial number, and purchase date.
KEEP DATED SALES RECEIPT FOR WARRANTY SERVICE.
Keep this booklet. Record the following for reference:
Date purchased __________________________ Model number _______________________
Date code (stamped on bottom) _________________________________________________
National Service Center
708 South Missouri St.
Macon, MO 63552
Consumer Service 1-800-947-3744
Consumer Parts 1-800-947-3745
PART NO. 32992P01
Hours: 8:00 a.m. - 4:30 p.m. CST
Download from Www.Somanuals.com. All Manuals Search And Download.
|