TM-STPRO
XY Stereo Microphone
Powering the microphone
Description
ere are two ways to power the TM-STPRO:
TASCAM’s TM-STPRO is a stereo X/Y microphone
perfectly suited to capture detailed studio and live
performances. is back-electret condenser micro-
phone captures a wide stereo image with rich sound
quality. e balanced XLR output is perfect for con-
necting to TASCAM recorders like the US-144, DP-02
and 2488neo. A switchable low cut filter is provided to
remove low frequency rumble during recording. e
TM-STPRO includes a 16’ stereo XLR cable for flexible
microphone placement. Also included are a microphone
stand clip, wind screen, AA battery and protective carry
pouch.
1.
Turn on the Phantom Power switch on your micro-
phone preamp. You should switch on phantom power for both
channels of the TM-STPRO. Phantom power sends 48 volts
to the microphone over the cable and is commonly found on
professional mixers and recorders.
2.
Install a AA battery to power the microphone. An
alkaline AA battery provides approximately 400 hours of op-
eration under normal circumstances. ere is no power switch
on the TM-STPRO, so you need to remove the battery when
you are finished using the microphone.
Installing the battery
1.
2.
3.
Unscrew microphone body cover
Remove the body shell
Insert the battery, taking note of the polarity
e great-sounding TM-STPRO makes stereo recording
easy and affordable for anyone.
Specifications
Battery Precautions:
Model:
TM-ST PRO
•
•
•
Insert the battery correctly
Elements:
Back Electret Condenser
X/Y Stereo
Do not charge the included AA battery
Remove the battery if the microphone will not
be used for a long period of time
Type:
Frequency Response:
Sensitivity @ 1Pa:
Impedance:
Maximum SPL:
Dynamic Range:
Power:
30 Hz - 20k Hz
-47 dBV
•
If the battery leaks, clean the battery holder
before inserting a new battery
200Ω, BALANCED
126 dB SPL
102 dB
Using the Low Cut Filter
Phantom Power or AA Battery
2 mA
e low-cut filter switch is located on the top of the micro-
phone. To switch on the low cut filter, move the switch to the
down position (indicated by the
to the up position for full bass response (indicated by the
icon). e low cut filter attenuates frequencies below 150Hz at
a cutoff slope of 6dB per octave.
Consumption:
Connector:
Weight:
Integral 5-pin XLR-M
320g/11.3 oz.
icon). Move the switch
To permanently set the microphone for flat response, so that
it cannot be accidentally switched to rolloff mode, use the
switch protector located under the switch. Unscrew the philips
screw holding the switch protector in place, rotate it so it faces
upward, then replace the philips screw.
Included Accessories:
•
•
•
•
•
16’ Stereo XLR5-F to dual XLR3-M cable
Microphone Stand Clip
AA Battery
Windscreen
Protective Pouch
Download from Www.Somanuals.com. All Manuals Search And Download.
|