Sunbeam Styling Iron HS9500 User Manual

SALON FINISH

HAIRSTYLING IRON WITH

CERAMIC TECHNOLOGY

Instruction Booklet

HS9500

Please read these instructions carefully

and retain for future reference.

Download from Www.Somanuals.com. All Manuals Search And Download.

Contents

Sunbeam’s Safety Precautions

Features of your Hairstyling Iron

Using your Hairstyling Iron

Help Line

Care and Cleaning

Download from Www.Somanuals.com. All Manuals Search And Download.

Sunbeam’s Safety

Precautions

SAFETY PRECAUTIONS FOR YOUR SUNBEAM

HAIRSTYLER

• This hairstyler must not come into contact with water

or any other liquid.

• Always switch off your hairstyler at the power outlet

and remove the plug when not in use.

• Do not store your hairstyler near tubs, basins, baths or

other vessels containing water or any other liquid.

• When the hairstyler is used in the bathroom, unplug it

after use as the proximity of water presents a hazard

even when the unit is switched off.

• Do not touch heating plates when in use as they will

become extremely hot.

• Do not use this hairstyler if hair is treated with

flammable products such a hair spray.

NOTE - This styler reaches very high temperatures very

quickly. Once the styler is plugged in and switched on,

DO NOT touch the plates with your fingers.

DO NOT allow the plates to touch the skin.

Sunbeam are very safety conscious when designing and

manufacturing consumer products, but it is essential

that the product user also exercise care when using an

electrical appliance. Listed below are precautions which

are essential for the safe use of an electrical appliance:

• Read carefully and save all the instructions provided

with an appliance.

• Always turn the power off at the power outlet before

you insert or remove a plug. Remove by grasping

the plug - do not pull on the cord.

• Turn the power off and remove the plug when the

appliance is not in use and before cleaning.

If you have any concerns regarding the performance

and use of your appliance, please visit

www.sunbeam.com.au or contact the Sunbeam

Consumer Service Line.

Ensure the above safety precautions are understood.

Download from Www.Somanuals.com. All Manuals Search And Download.

Sunbeam’s Safety Precautions

continued

• Do not use your appliance with an extension cord

unless this cord has been checked and tested by a

qualified technician or service person.

• Always use your appliance from a power outlet of

the voltage (A.C. only) marked on the appliance.

• Close supervision is necessary when your appliance

is being used near children or infirm persons.

• Never leave an appliance unattended while in use.

• Young children should be supervised to ensure that

they do not play with the appliance.

• Do not use an appliance for any purpose other than

its intended use.

• Do not place an appliance on or near a hot gas

flame, electric element or on a heated oven. Do not

place on top of any other appliance.

• Do not let the power cord of an appliance hang over

the edge of a table or bench top or touch any hot

surface.

• For safety reasons and to avoid maintenance by

unskilled persons, some appliances are ‘sealed’

using tamperproof screws. Such appliances should

always be returned to the nearest Sunbeam

Appointed Service Centre for adjustment or repair if

required.

• Do not operate any electrical appliance with a

damaged cord or after the appliance has been

dropped or damaged in any manner. If damage

is suspected, return the appliance to the nearest

Sunbeam Appointed Service Centre for examination,

repair or adjustment.

• For additional protection, Sunbeam recommend

the use of a residual current device (RCD)

with a tripping current not exceeding 30mA in

the electrical circuit supplying power to your

appliances.

• Do not immerse the appliance in water or any other

liquid unless recommended.

Download from Www.Somanuals.com. All Manuals Search And Download.

Features of your

Hairstyling Iron with

Ceramic Technology

Finger rest

Variable temperature

control

Handle

Download from Www.Somanuals.com. All Manuals Search And Download.

Solid ceramic

straightening plates

On/off switch

On/off neon light

indicator

Swivel cord

Download from Www.Somanuals.com. All Manuals Search And Download.

Using your Styler

Ceramic Heater

Your hairstyler has a ceramic heater. This can be

seen working by the high intensity red indicator

light. The light comes on to show it is working and

remains static for a few seconds. It then flashes

rapidly and when the maximum temperature is

reached the light will slow to a steady flash.

If the styler is being used on a high heat setting

and you switch to a lower setting, the light will go

out until the plate temperature reduces. It will then

work as normal.

• Before you start to style your hair, comb through

so that there are no tangles.

• For best results, hair must be completely dry.

• Plug in to a suitable supply and switch the unit

on. The neon light will come on.

• There is no need to pre heat the styler. The styler

will get very hot very quickly so do not touch the

plates with your fingers.

• Use the variable heat control to adjust the heat

to suit your hair type. Turn the dial clockwise to

increase the heat and anticlockwise to decrease.

Use a lower heat on young or fine hair and a

higher temperature on thick or curly hair.

• The maximum temperature reached is 200

degrees and the minimum is 150 degrees.

• Apply a styling lotion. We recommend PPS

professional products.

• Beginning at the back, use clips to section the

hair. Take a section approximately 5cms wide

and comb or brush it through. Working from root

to the ends, place the section between the plates

and squeeze the handle shut. Be careful not to

touch your skin.

• Hold the styler in place for 3 to 5 seconds

depending on your hair type (3 seconds for fine

hair and up to 5 seconds for thicker hair).

Download from Www.Somanuals.com. All Manuals Search And Download.

• Once the hair is heated, carefully slide the styler

along the direction of separated hair making sure

that the hair is heated and straightened all the

way to the ends.

• Select another section of hair and repeat the

process until all the hair has been straightened.

• Finish with a few drops of D Frizz Smootheez

Serum from PPS.

• Switch off the appliance and remove the plug

from the power outlet. Allow to cool completely

before storing.

Creating flicks

• Once the hair is heated, as you work towards the

end of the section of hair, lift the styler up and

out to create flicks.

• For a more choppy look, choose pieces at

random.

Auto off function

For added safety, your hairstyler will automatically

switch off after approximately 40 minutes. If

you want to continue styling, simply use the on/

off switch. Switch to the off position and then

immediately to the on position.

Please note that this is an added safety feature.

Always switch off after use and unplug from the

mains.

Download from Www.Somanuals.com. All Manuals Search And Download.

Care and Cleaning

• After use, remove the plug from the power outlet

and allow the hairstyler to cool before storing.

• The ceramic plates and the outside of the styler

can be wiped with a soft cloth.

• Do not wrap the cord around the appliance when

not in use.

• Store in a dry place.

Help Line

If you have any additional questions about using

the Hairstyling Iron with Ceramic Technology,

please call the Sunbeam help line in Australia on

1800 025 059. In New Zealand, please call

0800 786 232.

Download from Www.Somanuals.com. All Manuals Search And Download.

‘Sunbeam’, is a registered trademark of Sunbeam Corporation.

Made in China. Due to minor changes in design or otherwise,

the product may differ from the one shown in this leaflet.

Backed by Sunbeam‘s 2 Year Replacement Guarantee and

National Service Network.

(INCORPORATED IN N.S.W.) A.C.N. 000 006 771

Sunbeam Corporation is a division of GUD Holdings Ltd.

For more information or advice on this or any other

Sunbeam appliance, visit www.sunbeam.com.au or

contact the Sunbeam Consumer Service Line.

Australia 1800 025 059

New Zealand 0800 786 232.

Download from Www.Somanuals.com. All Manuals Search And Download.

Consumer Hotline

Australia

1800 025 059

New Zealand

0800 786 232

www.sunbeam.com.au

is a registered Trademark of Sunbeam

Corporation Limited. ACN 000 006 771.

Download from Www.Somanuals.com. All Manuals Search And Download.

Sony Camcorder PDW F800 User Manual
Sony Digital Camera CCU D50P User Manual
Sony Ericsson Cell Phone K530i User Manual
Sony Ericsson Cell Phone W580c User Manual
Sony MP3 Player 4 185 044 111 User Manual
Sony Speaker System CMT HX9DAB User Manual
Speco Technologies Security Camera CVC 3805 User Manual
Stamina Products Exercise Bike UX2 User Manual
Strong Pools and Spas Swimming Pool Vacuum Victory Spa User Manual
Sunbeam Electric Heater HE6100 1000W User Manual