Quick Start Guide
Portable 150Mbps Wireless N Travel Router / Access Point - USB Powered
AP150WN1X1U
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
2. Enable WPS mode.
PT: Guia do usuário - pt.startech.com
Packaging Contents
• 1 x Travel Router
• 1 x USB Cable
• 1 x RJ45 Cable
• 1 x Carrying Pouch
• 1 x Instruction Manu
3. Once enabled, a single press of the button will activate it.
Reset
In order to reset the device to factory defaults:
Note: All previously configured settings will be deleted after performing a reset
1. Ensure the AP is connected to a power source.
2. Press and hold the reset button for 8 seconds, then release.
System Requirements
• Available USB port (or wall charger) for power
Installation
specifications
Product Overview
Default Settings
SSID: AP150WN1X1U
LAN IP Address: 192.168.16.254
Username / Password: admin / admin
Wireless Access Point
In AP mode, the AP150WN1X1U acts as a wireless transmitter which adapts a wired
network signal into WiFi, so that other wireless devices like smartphones and tablets
within range can share the wired connection.
RJ45 Interface
WPS/Reset Button
Mode Selector Switch
USB Interface
Widely used in: Hotel rooms, school dormitories, etc.
LED Indicators
Off: No Wi-Fi signal
Solid: Wi-Fi signal broadcasting
Flashing: Activity
WiFi
Off: No RJ45 connection detected
Solid: RJ45 connection detected
Flashing: Activity
WLAN
Off: No power supplied to the device
Solid: Connected to a USB power source
POWER
1. Adjust the switch on the device to AP Mode.
2. Connect one end of the included Ethernet cable to the RJ45 port of the AP, and
WPS / Reset Button
the other to the hotel wall jack/switch.
WPS
3. Connect one end of the included USB cable to the USB port of the AP, and the
other to a USB power source (e.g. laptop, USB wall charger, etc.).
4. Connect your wireless devices to the “AP150WN1X1U”SSID and open your web
browser to access the Internet.
NOTE: If the hotel Internet connection requires a password or has a captive portal
login, contact the front desk to obtain that information.
WPS mode is disabled by default because it requires a secured wireless network to be
used.
1. Once you have selected an operating mode and are connected to the
web interface (details in the following sections of this manual), configure
your desired wireless security protocol and key.
Manual Revision: 01/27/2014
Download from Www.Somanuals.com. All Manuals Search And Download.
|