®
MOTOCROSS
Congratulations! You are the proud owner of the AIR HOGS®
Motocross Bike. Your AIR HOGS® Motocross Bike can travel
distances of up to 120 feet and race at scale speeds of up to
150MPH (1:9 Scale). Your bike is also equipped with a
wheelie bar, so you can perform pop-a-wheelies!
PLEASE READ THESE INSTRUCTIONS BEFORE USE!
PROBLEMS? PLEASE DO NOT TAKE YOUR
AIR HOGS® MOTOCROSS BIKE BACK TO THE STORE!
CALL SPIN MASTER TOLL FREE AT:
IMPORTANT
1-800-622-8339
A. SELECTING YOUR LOCATION:
D. PERFORMING A
The Air Hogs® Motocross Bike performs best on
POP-A-WHEELIE:
1. Pressurize your bike’s engine, as explained
FLAT SMOOTH SURFACES, free of bumps and other
obstructions. Do not play on harsh or rocky surfaces.
Do not play on or near roadways. Always consult
your guardian before playing to ensure the area in
which you would like to play is clear and safe!
in section B.
2. Lower the wheelie bar into place, as shown (d).
d
B. PRESSURING THE ENGINE:
1. BEFORE PUMPING, ROTATE THE REAR TIRE UNTIL
THE PISTON IS SET AT THE FRONT OF THE PISTON
WINDOW (see CORRECT drawing).
IF THE PISTON IS AT THE BACK OF THE PISTON
WINDOW, THE AIR WILL LEAK OUT OF THE BIKE
DURING PUMPING! (see INCORRECT drawing).
e
2. Attach the bike to the pump, as shown (a).
3. Place the bike on a
3. Lay bike on its side, as shown (b).
smooth flat surface.
4. Place one foot on each side of the pump base and
grasp the pump handle with both hands (b).
5. Pump air into the bike.
4. Raise the front end of
the bike into the air so
that only the rear
6. Push button to unlock pump clip and remove bike from pump.
wheel and the wheelie
bar are resting on the
ground (e).
PISTON
PISTON
5.Give your bike a firm
push in the direction
you want to go,
f
PISTON
PISTON
AT FRONT
AT BACK
remembering to guide
the bike with your
hand for1-2 feet before
releasing,as explained
above (f).
INCORRECT
CORRECT
b
a
Troubleshooting Guide:
PUMP
CLIP
Problem
1. Cannot pump bike.
Cause
Solution
1. Air intake on bike and/or
pump nozzle is clogged.
1. Use a toothpick to gently clean
dirt/foreign material out of the air
intake/pump nozzle.
IMPORTANT: It will take 25 pumps to pressurize your bike. Pull the pump
handle ALL THE WAY up and push it ALL THE WAY down to complete
each of the 25 pumps. Incorrect pumping will result in lower than expected
performance. FOR SAFE USE, DO NOT EXCEED 25 PUMPS.
2. Engine will not start.
2A. No air in bike.
2A. Pump up bike as detailed in
section B above.
2B. Did not push bike along
ground to start engine.
2B. Give bike a firm push along the
ground to start the engine.
2C. Piston is at the back of the 2C.Rotate rear tire until piston
window. in this position, the air moves to the front of the window.
will leak out of the toy and the
C. STARTING YOUR BIKE:
c
1. Set the bike on a long flat
engine will not start.
surface.
3. Bike will not go straight.
3A. Wheels are turned.
3A. Be sure to straighten the front
and rear wheels before releasing
the bike.
2. Straighten the front and
rear wheels.
3B. You are not guiding
the bike for 1-2 feet before
releasing.
3B. Be sure to guide the bike with
your hand for 1-2 feet before
releasing, as explained in C3 above.
3. Give the bike a firm push
forward and continue to
guide the bike on a straight
path for 1-2 feet before
releasing. (c).
4. Bike will not perform a
pop-a-wheelie.
4. Wheelie bar is not down.
4. Lower wheelie bar into position
as explained in D2 above.
IMPORTANT: It is important to guide the bike on a straight path for
1-2 feet after the engine starts. This is to stabilize the bike and continue it
on a straight course.
TIP: If you are having trouble making the bike go straight without
falling over, try using the wheelie bar. The wheelie bar helps to
balance the bike. This is similar to training wheels on a bicycle.
Note: With practice, your runs will become straighter and longer
and you will no longer need the assistance of the wheelie bar.
Spin Master Toys,
AIR HOGS® is a registered trademark of Spin Master Toys™.
All rights reserved.
450 Front Street West, Toronto,
Ontario, Canada M5V 1B6
Telephone: 1-800-622-8339
Email: [email protected]
AIR HOGS® MOTOCROSS BIKE © 2002 Spin Master Toys.
All rights reserved.
43020 ENG REV 1
Download from Www.Somanuals.com. All Manuals Search And Download.
|