Notes on CDs
Information
Owner's Record
English
Remote
The model number and serial number are located
at the rear.
•
Before playing, clean the CD with a
cleaning cloth. Wipe the CD from the
center out.
Precautions
On safety
Troubleshooting
General
The power does not come on.
• Connect the AC power adaptor to a wall outlet
securely.
Specifications
For customers in the USA
The remote does not function.
• Replace the battery in the remote with new
one if it is weak.
• Make sure that you are pointing the remote at
the remote sensor on the player.
• Remove any obstacles in the path of the
remote and the player.
• Make sure the remote sensor is not exposed to
strong light such as direct sunlight or
fluorescent lamp light.
• Move closer to the player when using the
remote.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
WARNING
Record the serial number in the space provided
below. Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No. ZS-D10
•
•
•
As the laser beam used in the CD player
section is harmful to the eyes, do not
attempt to disassemble the casing. Refer
servicing to qualified personnel only.
Should any solid object or liquid fall into
the player, unplug the player, and have it
checked by qualified personnel before
operating it any further.
Discs with non-standard shapes (e.g.,
heart, square, star) cannot be played on
this player. Attempting to do so may
damage the player. Do not use such discs.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 6-ohm loads, both channels driven
from 1 000 - 10 000 Hz; rated 3.5 W per
channel-minimum RMS power, with no
more than 10 % total harmonic distortion
in AC operation.
To prevent fire or shock hazard, do
not expose the player to rain or
moisture.
Serial No.
There is no audio.
• Make sure the function you want to use
appears in the display window.
• Adjust the volume.
For customers in the USA
Please register this product on line at http://
Proper registration will enable us to send you
periodic mailings about new product,
services and other important announcements.
Registering your product will also allow us to
contact you in the unlikely event that the
product needs adjustment or modification.
Thank you.
Personal
Audio
• Unplug the headphones when listening
through speakers.
Other specifications
•
•
Do not use solvents such as benzine,
thinner, commercially available cleaners
or anti-static spray intended for vinyl LPs.
Do not expose the CD to direct sunlight or
heat sources such as hot air ducts, nor
leave it in a car parked in direct sunlight as
there can be a considerable rise in
After trying the above remedies, if you still have
problems, unplug the AC power adaptor. After
all the indications in the display disappear, plug
the AC power adaptor. If the problem persists,
please consult your nearest Sony dealer.
Noise is heard.
CD player section
System
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wave length: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance
of about 200 mm from the objective lens surface
on the optical pick-up block with 7 mm
aperture.)
Spindle speed
200 r/min (rpm) to 500 r/min (rpm)
(CLV)
Number of channels
2
Frequency response
20 - 20 000 Hz +1/–2 dB
Wow and flutter
Below measurable limit
• Someone is using a portable telephone or
other equipment that emits radio waves near
the player. tMove the portable telephone,
etc., away from the player.
System
Cleaning the cabinet
•
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.
This symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
— Reorient or relocate the receiving antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Operating Instructions
CD Player
The CD does not play or “no dISC”
lights in the display even when a CD
is in place.
• Place the CD with the label surface you.
• Make sure that the CD compartment is closed.
• Clean the CD.
• Take out the CD and leave the CD
compartment open for about an hour to dry
moisture condensation.
• Make sure “Cd” appears in the display.
• The CD-R/CD-RW was not finalized. Finalize
the CD-R/CD-RW with the recording device.
• There is a problem with the quality of the CD-
R/CD-RW, recording device, or application
software.
temperature inside the car.
•
•
Do not stick paper or sticker on the CD,
nor scratch the surface of the CD.
After playing, store the CD in its case.
On power sources
— Consult the dealer or an experienced radio/
TV technician for help.
If there is a scratch, dirt or fingerprints on the
CD, it may cause tracking error.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
•
For AC operation, use the supplied AC
power adaptor; do not use any other type.
This class B digital device complies with part 15
of the FCC rules. Operation is subject to the
following two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may cause undesired
operation.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
About CD-Rs/CD-RWs
This player can play CD-Rs/CD-RWs
recorded in the CD-DA format*, but
playback capability may vary depending on
the quality of the disc and the condition of
the recording device.
CAUTION
Polarity of the plug
The use of optical instruments with this product
will increase eye hazard.
•
The player is not disconnected from the
AC power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.
* CD-DA is the abbreviation for Compact
Disc Digital Audio. It is a recording
standard used for Audio CDs.
WARNING
The sound drops out.
Noise is heard.
• Reduce the volume.
Radio section
Frequency range
FM: 87.5 - 108 MHz
AM: 531 - 1 611 kHz (Taiwan model)
530 - 1 710 kHz (Other models)
Antennas
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on the
appliance.
Replace the AC power adaptor with model AC-
CD10 only, if replacement is necessary.
•
•
•
Unplug the player from the wall outlet
when it is not be used for an extended
period of time.
When the batteries are not to be used,
remove them to avoid damage that can be
caused by battery leakage or corrosion.
The nameplate indicating operating
voltage, etc. is located at the rear.
Music discs encoded with copyright
protection technologies
This product is designed to play back discs
that conform to the Compact Disc (CD)
standard. Recently, various music discs
encoded with copyright protection
technologies are marketed by some record
companies. Please be aware that among
those discs, there are some that do note
conform to the CD standard and may not by
playable by this product.
ZS-D10
• Clean the CD, or replace it if the CD is badly
damaged.
• Place the player in a location free from
vibration.
• Clean the lens with a commercially available
blower.
• The sound may drop out or noise may be
heard when using poor quality CD-Rs/CD-
RWs or if there is a problem with the
recording device or application software.
For customers in Canada
To prevent electric shock, match wide blade of
plug to wide slot, fully insert.
FM: Telescopic antenna
AM: Built-in ferrite bar antenna
©2003 Sony Corporation
Printed in China
General
Speaker
3-251-193-91 (1)
Full range: 8 cm (3 1
(2)
⁄
in.) dia., 6 Ω, cone type
On placement
4
•
Do not leave the player in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or mechanical
shock.
Input
Lens
LINE IN jack (stereo minijack):
Minimum input level 330 mV
Outputs
Headphones jack (stereo minijack):
For 16 - 68 Ω impedance headphones
If you have any questions or problems
concerning your player, please consult your
nearest Sony dealer.
Power Sources
•
•
Do not place the player on an inclined or
unstable place.
B
Do not place anything within 10 mm of
the side of the cabinet. The ventilation
holes must be unobstructed for the player
to operate properly and prolong the life of
its components.
OPTICAL DIGITAL OUT (CD) (optical output
connector):
A
Wavelength 630 - 690 nm
Power output
4 W + 4 W (at 6 Ω, 10% harmonic
distortion)
Power requirements
For Personal Audio System:
DC IN 10V jack accepts: Supplied AC power
adaptor for use with: 120V AC, 60 Hz
For remote control:
3 V DC, 2 size AAA (R03) batteries
Dimensions
•
•
If the player is left in a car parked in the
sun, be sure to choose a location in the car
where the player will not be subjected to
the direct rays of the sun.
Since a strong magnet is used for the
speakers, keep personal credit cards using
magnetic coding or spring-wound watches
away from the player to prevent possible
damage from the magnet.
1 to DC IN 10V
Radio
Reception is poor.
• Reorient the antenna to improve FM
reception.
2 to a wall outlet
Approx. 530 × 195 × 127 mm (w/h/d)
⁄ ⁄4 × 5 inches)(incl. projecting parts)
(20 7 8 × 7 3
Mass
On operation
Approx. 2.5 kg (5 lb. 8 oz)
Supplied accessory
AC power adaptor (1)
Remote control (1)
•
If the player is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lenses inside the CD player section.
Should this occur, the player will not
operate properly. In this case, remove the
CD and wait about an hour for the
moisture to evaporate.
Connect the AC power adaptor A.
• Reorient the player itself to improve AM
reception.
Design and specifications are subject to change
without notice.
Preparing the remote B
Insert two size AAA (R03) batteries (not supplied).
Optional accessories
Sony MDR headphone series
Replacing batteries
With normal use, the batteries should last for about six months. When the remote no longer
operates the player, replace two batteries with new ones.
The audio is weak or has poor quality.
• Move the player away from the TV.
• If you are using the remote while listening to
AM radio, noise may be heard. This is
unavoidable.
The picture of your TV becomes
unstable.
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
Download from Www.Somanuals.com. All Manuals Search And Download.
|