Notice for the customers in the
U.S.A.
The following FCC statement
applies only to the version of this
model manufactured for sale in
the U.S.A. Other versions may
not comply with FCC technical
regulations.
11
3-293-641- (1)
Basic Operations
Notes
CAUTION
When placing or removing the iPod, handle the iPod in the same
Adjusting the sound
Listening to the radio
e following CAUTION marking is located on the rear
exterior.
angle as that of the iPod connector
on the unit and do not twist
or sway the iPod to prevent connector damage.
Do not carry the unit with an iPod set on the connector. Doing so
may cause a malfunction.
When placing or removing the iPod, brace the unit with one hand
and take care not to press the controls of the iPod by mistake.
To remove the iPod Dock Adaptor, pull it up with your fingernail or
a flat object using the slot inside the adaptor.
Micro HI-FI
Component
System
1
2
3
Select “TUNER FM”or “TUNER AM.”
To adjust the volume
Press VOLUME +/ (or VOL +/ on the unit)
Press FUNCTION +/ (or FUNCTION on the unit)
.
repeatedly.
NOTE:
To add a sound effect
is equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. ese limits are designed
to provide reasonable protection against harmful
interference in a residential installation. is equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Select the tuning mode.
To
Press
Press TUNING MODE
appears.
repeatedly until “AUTO”
Before disconnecting the iPod, pause playback.
Generate a more dynamic DSGX
sound (Dynamic Sound
Generator X-tra)
on the unit.
. You can fast
While playing video, you cannot use
/
rewind (fast forward) by holding down
/
.
Tune in the desired station.
To change the volume level, use VOLUME +/ (or VOL +/ on the
unit) . e volume level does not change even if adjusted on the
Press +/ (or TUNE +/ on the unit) . Scanning
stops automatically when a station is tuned in, and
then “TUNED” and “STEREO” (for stereo programs
only) appear.
Set the sound effect
EQ
repeatedly to select
iPod.
“BASS” or “TREBLE,” and
then press +/
to adjust the level.
is system is designed for iPod only. You cannot connect any other
portable audio players.
To use an iPod, refer to the user’s guide of your iPod.
Sony cannot accept responsibility in the event that data recorded to
iPod is lost or damaged when using an iPod with this unit.
repeatedly
Operating Instructions
is symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a risk
of electric shock to persons.
CMT-BX20i
Playing a CD/MP3 disc
Changing the display
To stop automatic scanning
1
Select the CD function.
.
Press (stop) (or /CANCEL on the unit)
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
is symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
To
Press
Press FUNCTION +/ (or FUNCTION on the unit)
Printed in China
© 2008 Sony Corporation
To tune in a station with a weak signal
If “TUNED” does not appear and the scanning does not
repeatedly.
Change
DISPLAY
repeatedly when the
when the system is
information on the system is on.
2
Place a disc.
Press (open/close)
with the label side up on the disc tray.
display1)
stop, press TUNING MODE
repeatedly until “AUTO”
on the unit, and place a disc
accompanying the appliance.
and “PRESET” disappear, and then press +/ (or TUNE
Check the clock
when the system
is off2)
DISPLAY
+/ on the unit)
repeatedly to tune in the desired
off3). e clock is displayed for 8
seconds.
CAUTION
station.
Owner’s Record
WARNING
e use of optical instruments with this product will
increase eye hazard.
e model and serial numbers are located on the rear of
the unit. Record these numbers in the space provided
below. Refer to them whenever you call upon your Sony
dealer regarding this product.
To reduce static noise on a weak FM stereo
station
1) For example, you can view CD/MP3 disc information, such as;
track or file number during normal play.
track or file name (“ ”) during normal play.
artist name (“ ”) during normal play.
CAUTION
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
Press FM MODE
repeatedly until “MONO” appears
Except for customers in the U.S.A.
and Canada
to turn off stereo reception.
album or folder name (“
”) during normal play.
Model No.
Serial No.
total playing time while the player is stopped.
2) e clock is displayed continuously while the iPod is being charged.
To close the disc tray, press (open/close)
on the
To reduce the risk of fire, do not cover the ventilation
opening of the apparatus with newspapers, tablecloths,
curtains, etc.
Do not place the naked flame sources such as lighted
candles on the apparatus.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
As the main plug is used to disconnect the unit from the
mains, connect the unit to an easily accessible AC outlet.
Should you notice an abnormality in the unit, disconnect
the main plug from the AC outlet immediately.
To turn off the clock display, press DISPLAY
charging the iPod”).
e STANDBY indicator
off.
(See “To stop
is appliance is classified
as a CLASS 1 LASER
product. is marking
is located on the rear
exterior.
unit.
Playing the iPod
Note to CATV system installer:
is reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
Do not force the disc tray closed with your finger, as
this may damage the unit.
3)
on the unit lights up when the system is
1
Select the iPod function.
3
Start playback.
Press FUNCTION +/ (or FUNCTION on the unit)
Notes on the display information
Characters that cannot be displayed appear as “_”.
e following are not displayed:
total playing time for a CD-DA disc depending on the play mode.
total playing time and remaining playing time for an MP3 disc.
e following are not displayed correctly:
folder and file names that do not follow either ISO9660 Level 1,
Level 2 or Joliet in the expansion format.
e following is displayed:
repeatedly.
Press (play) (or CD (play/pause) on the
.
unit)
2
Place the iPod.
Except for the U.S.A., Canadian,
Australian and New Zealand
models
To
Press
Pause playback
(pause) (or CD (play/
pause) on the unit)
.
e nameplate is located on the bottom exterior.
To resume play, press the button
again.
ID3 tag information for MP3 files when ID3 version 1 and version
2 tags are used (up to 62 characters).
Stop playback
(stop) (or /CANCEL on the
is manual mainly explains operations using the
remote, but the same operations can also be performed
using the buttons on the unit having the same or similar
names.
Do not expose batteries or apparatus with battery-installed
to excessive heat such as sunshine, fire or the like.
.
unit)
Select a folder on an
MP3 disc
+/ (select folder)
.
Using optional audio components
Select a track or file
/
(go back/go forward)
3
Start playback.
.
To connect an optional headphones
Press (play) (or iPod (play/pause) on the
Connect headphones to the PHONES jack
unit.
on the
Find a point in a
track or file
Hold down
/
(rewind/
during playback,
and release the button at the
.
unit)
Before using the system
fast forward)
To control the iPod
You can control your iPod with the following buttons on
the remote or unit.
To connect an optional component
To use the remote
Hooking up the system securely
desired point.
Connect additional audio component to the AUDIO
Slide and remove the battery compartment lid , and
Select Repeat Play
REPEAT
repeatedly until
“REP” or “REP1” appears.
IN jack
on the unit using an audio analog cord (not
insert the two supplied R6 (size AA) batteries, side
first, matching the polarities shown below.
supplied). Turn down the volume on the system, and
then select the AUDIO IN function.
To
Press
When carrying this system
Antennas
Pause playback
(pause) (or iPod
(play/pause) on the unit)
1
Remove a disc to protect the CD mechanism.
To change the play mode
or
Find a location and an orientation that provide
good reception, and then set up the antenna.
Keep the antennas away from the speaker cords
and the power cord to avoid picking up noise.
Press PLAY MODE
stopped. You can select normal play (“
files in the folder on the disc), shuffle play (“SHUF” or
repeatedly while the player is
2
Press FUNCTION +/ (or FUNCTION on the unit)
(stop)
.
”
for all MP3
repeatedly to select the CD function.
Scroll up/down the
iPod menus
/
. You can scroll up or
down the iPod menus much like
the Click Wheel operations of
the iPod or the drag up-or-down
operations of the iPod touch.
3
4
Hold down VOL +
and press
appears.
and DSGX
on the unit,
“
SHUF*”), or program play (“PGM”).
on the unit until “STANDBY”
* When playing a CD-DA disc,
(SHUF) Play performs the same
operation as normal (shuffle) play.
AM loop antenna
After “LOCK”appears, unplug the power cord.
Notes on Repeat Play
Select a track
/
(go back/go forward)
All tracks or files on a disc are played repeatedly up to five times.
“REP1” indicates that a single track or file is repeated until you stop
Notes on using the remote
or chapter of
. To fast-forward or fast-
With normal use, the batteries should last for about six months.
Do not mix an old battery with a new one or mix different types of
batteries.
it.
audiobook/podcast
rewind, hold down the button.
Choose the selected
item
Notes on playing MP3 discs
/
(enter) (or ENTER on
If you do not use the remote for a long period of time, remove the
batteries to avoid damage from battery leakage and corrosion.
Do not save other types of tracks or files or unnecessary folders on a
the unit) . You can choose the
selected item much like the center
button on the iPod or the touch
operation of the iPod touch.
disc that has MP3 files.
Folders that have no MP3 files are skipped.
MP3 files are played back in the order that they are recorded onto
the disc.
To set the clock
Use buttons on the remote to set the clock.
e system can only play MP3 files that have a file extension of
Find a point in a
track or chapter of
audiobook/podcast
/
(fast rewind/fast
1
2
Turn on the system.
“.MP3”.
forward)
during playback, and
Press (power)
.
If there are files on the disc that have the “.MP3” file extension,
but that are not MP3 files, the unit may produce noise or may
malfunction.
release the button at the desired
point.
Select the clock set mode.
Press TIMER MENU . If the current mode appears
on the display, press
“CLOCK SET?” and then press
Speakers
Speaker cord (Red/)
Left speaker
e maximum number of:
folders is 255 (including the root folder).
MP3 files is 511.
Return to the
previous menu or
select a menu
/TOOL MENU
/
Insert only the stripped
portion of the cord.
/
repeatedly to select
(return) . You can return to the
previous menu or select a menu
much like the Menu button on
the iPod or the touch operation
of the iPod touch.
.
(enter)
MP3 files and folders that can be contained on a single disc is 512.
Power
3
Set the time.
folder levels (the tree structure of files) is 8.
Compatibility with all MP3 encoding/writing soſtware, recording
device, and recording media cannot be guaranteed. Incompatible
MP3 discs may produce noise or interrupted audio or may not play
at all.
For models with a voltage selector, set VOLTAGE
SELECTOR to the local power line voltage.
Speaker cord (Black/)
Right speaker
Press
press
/
repeatedly to set the hour, and then
(enter) . Use the same procedure to set the
FM lead antenna
(Extend it horizontally.)
minutes.
Connect the power cord to a wall socket.
If the plug does not fit the wall socket, detach the
supplied plug adaptor (only for models equipped with
an adaptor).
To use the system as a battery charger
You can use the system as a battery charger for the iPod
when the system is both on and off.
White side for North
American model
e clock settings are lost when you disconnect the
power cord or if a power failure occurs.
Notes on playing multisession discs
If the disc begins with a CD-DA (or MP3) session, it is recognized as
a CD-DA (or MP3) disc, and other sessions are not played back.
A disc with a mixed CD format is recognized as a CD-DA (audio)
disc.
To display the clock when the system is off, press
e charging begins when the iPod is placed on the unit’s
DISPLAY . e clock is displayed for about 8
connector . e charging status appears in the iPod
seconds.
or
display. For details, see the user’s guide of your iPod.
To use the iPod
To stop charging the iPod
Insert an iPod Dock Adaptor into the unit’s connector
before use.
Remove the iPod. If you stop charging the iPod when
the system is off, press DISPLAY
disappears in the display.
until the clock
For details on the supplied iPod Dock Adaptors, refer to
the instructions supplied with the Dock Adaptors.
Brown side for other regions
Wall socket
Download from Www.Somanuals.com. All Manuals Search And Download.
|