On placement/operation
Pre ca u t io n s
WARNING
• Do not leave the player in a location
near heat sources, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
Ad ju st in g t h e a u d io e m p h a sis
(DYNAMIC SOUND SYSTEM)
Se t t in g u p t h e syst e m
Co n n e ct in g t h e Sp e a ke rs
On safety/pow er sources
To prevent fire or shock hazard, do not
expose the player to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified
personnel only.
• Should any solid object or liquid fall
into the player, unplug the player, and
have it checked by qualified personnel
before operating it any further.
• For AC operation, check that the
player’s operating voltage is identical
with your local power supply (see
“Specifications”) and use the supplied
mains lead; do not use any other type.
The voltage selector is located on the
rear of the player (CFS-515S only).
• The player is not disconnected from the
AC power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.
• For battery operation, use six R20 (size
D) batteries.
• Do not place anything within 10 mm of
the side of the cabinet. The ventilation
holes must be unobstructed for the
player to operate properly and to
prolong the life of its components.
• Since a strong magnet is used for the
speakers, keep personal credit cards
using magnetic coding or spring-
wound watches away from the player
to prevent possible damage from the
magnet.
Using the 5 BAND GRAPHIC EQUALIZER
Make sure you turn off the power before making connections.
Use
To adjust
Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet.
Ra d io
MEGA BASS
400 Hz
deep bass sound.
b
a
1
speaking voice, middle frequencies
of instrumental music.
Ca sse t t e -
Co rd e r
The FUNCTION selector is located at
the front.
When you turn on the player, the
OPR/ BATT indicator lights up.
1 kHz
4 kHz
10 kHz
presence of vocals.
• If the player has not been used for a
long time, set it in the playback mode to
warm it up for a few minutes before
inserting a cassette.
brightness of the sound.
]
high treble sounds or to reduce high
frequency noise/ tape hiss.
}
}
2
]
• When the batteries are not to be used,
remove them to avoid damage that can
be caused by battery leakage or
corrosion.
• The nameplate indicating operating
voltage, power consumption, etc. is
located at the rear.
Operating Instructions
If you have questions or problems
concerning your player, please consult
your nearest Sony dealer.
T
F
E
L
T
H
G
R
I
E
K
N
R
Ω
A
6
E
D
E
P
E
C
S
P
A
IM
Using the PRESET MODE
Set the position to
To
DYNAMIC
MANUAL
adjust the sound using the 5 BAND
GRAPHIC EQUALIZER.
1
2
Align the grooves and slide the speaker box down until it
snaps into place a.
SOUND
SYSTEM
MANUAL
Connect the black wires to (–) minus and the red wires to
(+) plus terminals: the right speaker wires to the RIGHT,
and the left speaker wires to the LEFT terminals.
DYNAMIC
DISCO
get powerful, clear sounds emphasizing low
and high range audio.
SOUND
SYSTEM
DISCO
Tip
DYNAMIC
PARTY
get light, bright sounds emphasizing high
and middle range audio.
SOUND
To detach the speakers, unlock the speaker b and slide the speaker box all
the way up and away from the player.
SYSTEM
CFS-515S
CFS-515L
PARTY
Ch o o sin g Po w e r So u rce s
LIVE
get wide-ranging sounds having presence.
DYNAMIC
SOUND
SYSTEM
Sony Corporation © 1999
Printed in Vietnam
To u se t h e p la ye r o n AC p o w e r so u rce (m a in s)
LIVE
Connect the supplied AC power cord to the AC IN jack.
3-862-882-71(1)
No t e
When adjusting the 5 BAND GRAPHIC EQUALIZER, be sure to set the
PRESET MODE to MANUAL. The graphic equalizer will not work in any
other position.
To a d ju st t h e so u n d b a la n ce o f t h e rig h t a n d le ft sp e a ke rs.
Use BALANCE.
Tro u b le sh o o t in g
Sp e cifica t io n s
• Frequency range
CFS-515S
• Battery life
Deck A
Th e re is n o a u d io .
FM Recording: Sony R20P: Approx. 10
hours/ Sony LR20 alkaline: Approx. 20
hours
Playback: Sony R20P: Approx. 3.5
hours/ Sony LR20 alkaline: Approx. 8
hours
• Pow er requirements
CFS-515S
110-120 V/ 220-240 V AC selectable,
50/ 60 Hz
CFS-515L
• Connect the mains lead securely.
• Insert the batteries properly.
• Replace all batteries if they are weak.
• Unplug the headphones.
• Adjust the volume.
• Set FUNCTION to the position you
want to operate.
FM: Saudi Arabia: 87.6-107 MHz
Other countries: 87.6-108 MHz
MW: 530-1,605 kHz
SW1: 2.3-7 MHz
SW2: 7-22 MHz
CFS-515L
FM: 65-108 MHz
MW: 531-1,602 kHz
LW: 153-279 kHz
Capstan
1
to AC IN
No ise is h e a rd .
2
to a wall outlet
• Someone is using a portable telephone
or other equipment that emits radio
waves near the player. Move the
portable telephone, etc., away from the
player.
SW: 5.95-18 MHz
230 V AC, 50 Hz
• IF
FM: 10.7MHz
MW/ LW/ SW: 455 kHz
• Aerials
FM/ SW: Telescope
MW/ LW: Built-in ferrite bar
• Recording system
4-track, 2-channel stereo
• Frequency response
70–13,000 Hz
Playback
head
9V DC, six R20 (size D) batteries
• Pow er consumption
AC 18 W
Pinch
roller
To u se t h e p la ye r o n b a t t e rie s
• Dimensions
Insert six R20 (size D) batteries (not supplied) into the battery
compartment.
Ca sse t t e ca n n o t b e in se rt e d .
• Insert the cassette properly.
Approx. 697 x 211 x 201.5 mm (w/ h/ d)
(27 1/ x 8 3/ 8 x 8 inches) incl. projecting
parts 2and controls, not incl. handle
• Mass
Approx. 5.8 kg (12 lb 13 oz) incl. batteries
• Supplied accessory
AC power cord (1)
To a d ju st t h e vo lt a g e (CFS-515S o n ly)
Th e r REC b u t t o n d o e s n o t
fu n ct io n .
• No cassette is in deck B.
• Make sure the safety tab on the cassette
is in place.
Be sure to set the VOLTAGE SELECTOR (at the rear) to your local power
supply.
• Speakers
Full range: 10 cm (4 inches) dia., 6 ohms,
cone type/ Tweeter: 2 cm (13/ 16 inches) dia.
• Output
Headphones jack (stereo minijack), for
16–68 ohms impedance headphones
• Maximum pow er output
5 W + 5 W
VOLTAGE
SELECTOR
220 - 240V
Design and specifications are subject to
change without notice.
Deck B
Po o r p la yb a ck, re co rd in g o r
e ra sin g q u a lit y.
• Dirty heads. Clean the unit (as shown)
with a cotton swab slightly moistened
with cleaning fluid or alcohol.
• Demagnetize the heads and all metal
parts in the tape path with a
Erase head
Capstan
110 - 120V
commercially available tape head
demagnetizer.
Tip
For customers supplied with an AC plug adaptor, use it if the plug of the
mains lead does not match your mains.
Record/
Playback head
No t e s
Pinch roller
• To use the player on batteries, disconnect the mains lead from the player.
• Replace the batteries when the OPR/ BATT indicator dims or when the player
stops operating. Replace all batteries with new ones.
Cotton sw ab
Download from Www.Somanuals.com. All Manuals Search And Download.
|