4-270-283-44(1)
How to use
Specifications
Receiver
Wearing the headset
(see fig. )
Type:
Closed, dynamic
Operating Instructions
Manual de instrucciones
Driver unit:
Wear the earpiece marked in your
right ear and the one marked in
your left ear.
9 mm, dome type (CCAW)
Stereo
Headset
Power handling capacity:
100 mW (IEC*)
Impedance:
There is a tactile dot on the unit
marked to distinguish the left side.
16 Ω at 1 kHz
Sensitivity:
How to use the cord slider
(see fig. -)
Move up and down to change the split
position of the cord.
100 dB/mW
Frequency response:
8 – 22,000 Hz
DR-EX12iP
Cord:
Plug:
1.2 m (47 1/4 in), Y-type
Four-conductor gold-plated
stereo mini plug for iPod
with remote function
Approx. 3 g (0.11 oz)
without cord
How to use the remote
and microphone for an
iPod (see fig. -)
You can control a connected iPod
product.
Mass:
©2010 Sony Corporation Printed in Thailand
Microphone
Open circuit voltage level:
– 42 dB ( 0 dB=1 V/Pa)
Parts and controls
Supplied accessories
Earbuds (S × 2, M × 2, L × 2)
Card warranty (1)
English
Stereo headset
Volume +
Increases the volume of the connected
iPod product.
Operating Instructions (1)
Center button
Plays/pauses a track of the connected
iPod product with a single press. Skips
to the next track with a double press.
Skips to the previous track with a triple
press. Starts the “VoiceOver*” feature
with a long press (if available).
Press once to answer the call. Press
again to end.
WARNING
* IEC = International Electrotechnical
Commission
Design and specifications are subject
to change without notice.
To reduce the risk of fire or electric
shock, do not expose this
apparatus to rain or moisture.
To reduce the risk of electrical
shock, do not open the cabinet.
Refer servicing to qualified
personnel only.
Precautions
Hold down for about two seconds to
reject an incoming call.
Please keep your headset clean at all
When you let go, two low beeps
confirm the call was rejected.
Volume –
times especially inside the rubber
earbud. (see fig. )
You are cautioned that any changes or
modifications not expressly approved
in this manual could void your
If any dust or ear wax inside the
earbud, you may experience some
listening difficulties.
Listening with headset at high
volume may affect your hearing. For
traffic safety, do not use while
driving or cycling.
The earbuds may deteriorate due to
long-term storage or use.
Install the earbuds firmly onto the
headset. If an earbud accidentally
detaches and is left in your ear, it
may cause injury.
Decreases the volume of the connected
iPod product.
authority to operate this equipment.
Microphone
* Availability of the “VoiceOver” feature
depends on iPod and its software version.
Compatible iPod/
iPhone/iPad models
How to install the earbuds
correctly (see fig. )
If the earbuds do not fit your ears
correctly, low-bass sound may not be
heard. To enjoy better sound quality,
change the earbuds to another size, or
adjust the earbuds position to sit on
your ears comfortably and fit your ears
snugly.
If the earbuds do not fit your ears, try
another size. When you change the
earbuds, install them firmly on the
headset to prevent the earbud from
detaching and remaining in your ear.
You can use the unit with only the
following models supporting remote
control. Update your iPod, iPhone or
iPad to the latest software before use.
In the Operating Instructions, iPod,
iPhone and iPad are collectively
described as “iPod” except in special
cases.
S
Note on static electricity
In particularly dry air conditions, mild
tingling may be felt on your ears. This
is a result of static electricity
accumulated in the body, and not a
malfunction of the headset.
The effect can be minimized by
wearing clothes made from natural
materials.
iPod touch (5th generation)
iPod touch (4th generation)
iPod touch (3rd generation)
iPod touch (2nd generation)
iPod nano (7th generation)
iPod nano (6th generation)
iPod nano (5th generation)
iPod nano (4th generation)
iPod classic 120GB 160GB (2009)
iPod shuffle (4th generation)
iPod shuffle (3rd generation)
iPhone 5
2 lines
3 lines
M
To check the transparent
Optional replacement earbuds can
be ordered from your nearest Sony
dealer.
earbud sizes
The transparent earbud sizes are
distinguished by a line pattern
(see fig. -).
L
To check the black earbud sizes
The black earbud sizes are
distinguished by the inside color
(see fig. -).
iPhone 4S
iPhone 4
iPhone 3GS
iPad (4th generation)
iPad (3rd generation)
iPad 2
Black earbud sizes (inside color)
Small
S
Large
iPad
iPad mini
4 lines
M
(Green)
L
(Orange)
(Light blue)
Sectional View
To detach an earbud
On copyright
(see fig. -)
While holding the headset, twist and
pull the earbud off.
iPad , iPhone , iPod , iPod classic
,
®
® ®
®
iPod nano , iPod shuffle , and iPod
®
®
Tip
touch are trademarks of Apple Inc.,
®
If the earbud slips and cannot be detached,
wrap it in a dry soft cloth.
registered in the U.S. and other
Colored parts
countries.
“Made for iPod,” “Made for iPhone,”
To attach an earbud
and “Made for iPad” mean that an
(see fig. -)
electronic accessory has been designed
to connect specifically to iPod, iPhone
or iPad, respectively, and has been
certified by the developer to meet
Apple performance standards. Apple is
not responsible for the operation of
this device or its compliance with
safety and regulatory standards.
Push the parts inside of the earbud into
the headset until the projecting part of
the headset is fully covered.
Cleaning the earbuds
Remove the earbuds from the headset,
and wash them with a mild detergent
solution.
Features
Easy-to-use remote control (only for
iPod, iPhone and iPad).
In-line microphone for hands-free
phone calls of iPhone.
400 kJ/m3 high power neodymium
magnets produce high-resolution
treble and midrange with powerful
bass.
Hybrid silicone rubber earbuds for
secure fit and long-term wearing
comfort.
Download from Www.Somanuals.com. All Manuals Search And Download.
|