3-800-622-21 (2)
WARNING
Be fo re Yo u Be g in
IMPORTANT SAFEGUARDS
To p re ve n t fire o r sh o ck
h a za rd , d o n o t e xp o se
t h e u n it t o ra in o r
m o ist u re .
Thank you for choosing the Sony CD clock radio!
The CD clock radio will give you many hours of
reliable service and listening pleasure.
Before operating the CD clock radio, please read
these instructions thoroughly and retain them for
future reference.
For your protection, please read these safety instructions completely before operating the
appliance, and keep this manual for future reference.
Carefully observe all warnings, precautions and instructions on the appliance and described in
the operating instructions supplied with the appliance by Sony.
INSTALLATION
Wa t e r a n d Mo ist u re
Do not install the appliance near water: for example, near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool.
Fe a t u re s
• You can wake up to CD, radio and buzzer with
the snooze function.
He a t
Do not install the appliance near sources of heat such as radiators, heat registers, stoves, or
other appliances that produce heat.
CD Clo ck Ra d io
• You can wake up to any track on CD.
• Dual alarm
• Three-inch disc can be played without an
adaptor.
• Self power back-up: Even if the power supply
is interrupted, the time setting and the memory
will be backed up for 1 minute without
batteries.
Ve n t ila t io n
Slots and openings in the cabinet and in the back or bottom are provided for necessary ventilation.
To ensure reliable and safe operation of the appliance, and to protect it from overheating, these
slots and openings must never be blocked or covered.
Do not place the appliance on a bed, sofa, rug or other similar surface which may block the slots
and openings.
Operating Instructions
This symbol is intended to
alert the user to the presence of
uninsulated “dangerous
voltage” within the product’s
enclosure that may be of
sufficient magnitude to
constitute a risk of electric
shock to persons.
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet, unless
proper ventilation is provided.
Ca rt s a n d St a n d s
Pre ca u t io n s
Do not install the appliance on an unstable table, shelf, cart or stand. Use only a cart or stand
recommended by Sony.
An appliance and cart combination should be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cart combination to overturn.
• Operate the unit on the power sources
specified in “Specifications”.
• The nameplate indicating voltage, etc. is
located at the bottom.
• Disconnect the cord by grasping the plug.
Never pull it by the cord.
• Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
• The unit is not disconnected from the AC
power source (mains) as long as it is connected
to the wall outlet, even if the unit itself has
been turned off.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit
on a surface (a rug, a blanket, etc.) or near
materials (a curtain) which might block the
ventilation holes.
• Should any liquid or solid object fall into the
unit, unplug the unit and have it checked by a
qualified personnel before operating it further.
• When the casing becomes soiled, clean it with a
soft cloth dampened with a mild detergent
solution. Never use abrasive cleansers or
chemical solvents, as they may mark the
casing.
Wa ll o r Ce ilin g Mo u n t in g
If your appliance can be mounted to a wall or ceiling, mount it only as recommended by Sony.
This symbol is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
USE
Po w e r So u rce
Connect the appliance to a power supply only of the type described in the operating instructions
or as marked on the appliance.
Gro u n d in g o r Po la riza t io n
* The graphical symbols are on the bottom
enclosure.
Do not defeat the grounding or polarization feature of the AC power cord. If your AC receptacle
will not accept the power cord plug, contact your electrician to install a proper AC receptacle.
AC Re ce p t a cle
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
Check to make sure that the AC receptacle holds the power cord plug firmly and securely. If the
power cord plug is loose, contact your electrician to replace the defective and unsafe AC
receptacle.
Po w e r-Co rd Pro t e ct io n
INFORMATION
Route the power cord so that it is not likely to be walked on or pinched by having objects placed
on it, paying particular attention to the plugs, receptacles, and the point where the cord exits from
the appliance.
ICF-CD810
Sony Corporation 1995 Printed in Malaysia
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
Wh e n n o t in u se
Unplug the power cord of the appliance from the outlet when left unused for a long period of
time.
To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord.
If you have any question, please consult your
nearest Sony dealer.
Fo re ig n Ob je ct s
Ow n e r’s Re co rd
Be careful that foreign objects and liquids do not enter the enclosure through openings.
Cle a n in g
The model number and the serial number are located on the rear.
Record the serial number in the space provided below. Refer to these numbers
whenever you call upon your Sony dealer regarding this product.
Sp e cifica t io n s
CD player section
System: Compact disc digital audio system
Laser diode properties: Material: GaAlAs
Wavelength: 780 nm
Clean the appliance only as recommended by Sony.
ANTENNAS
Ou t d o o r An t e n n a Gro u n d in g
Model No. ICF-CD810
Serial No.
Emission duration: Continuous
If an outdoor antenna or cable system is installed, follow the precautions below.
An outdoor antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can come in contact with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE
TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT
WITH THEM IS ALMOST INVARIABLY FATAL.
Laser output: Less than 44.6 µW*
*This output is the value measured at a
distance of about 200 mm from the objective
lens surface on the optical pick-up block with
—Reorient or relocate the receiving antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
7 mm aperture.
+1
Frequency response: 20 – 20,000 Hz
Wow and flutter: Below measurable limit
– 1.5
dB
Be sure the antenna system is grounded so as to provide some protection against voltage surges
and built-up static charges. Section 810 of the National Electrical Code provides information with
respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode.
—Consult the dealer or an experienced radio/
TV technician for help.
Radio section
Frequency range:
FM: 87.5 – 108.0 MHz
AM: 530 – 1605 kHz
CAUTION
The use of optical instruments with this
product will increase eye hazard.
General
An t e n n a Gro u n d in g Acco rd in g t o t h e Na t io n a l
Ele ct rica l Co d e
Speaker: Fullrange: 7.7 cm (3 1/
inches) 4 ohms
8
Pow er outputs: 1.2 W + 1.2 W (at 10% harmonic
distortion)
Pow er requirements:
120 V AC, 60 Hz
Dimensions: Approx. 286×200×104 mm (w/ h/ d)
(Approx. 11 3/
projecting parts and controls
8
× 7 7/
8
× 4 1/
inches) incl.
8
Antenna Lead-in Wire
Mass: Approx. 1.7 kg (3 lb 12 oz)
Design and specifications are subject to change
without notice.
Antenna Discharge Unit
Ground Clamps
(NEC* Section 810-20)
Grounding Conductors
(NEC* Section 810-21)
Electric Service
Equipment
Ground Clamps
Power Service Grounding
Electrode System
—NEC National Electrical Code—
(NEC* Art 250 Part H)
SERVICE
Unplug the appliance from the wall outlet and consult qualified service personnel when:
-the power cord or the plug has been damaged.
-a solid object or liquid has fallen into the cabinet.
-the appliance has been exposed to rain or moisture.
-the appliance does not appear to operate normally or exhibits a marked change in performance.
-the appliance has been dropped, or the enclosure damaged.
Do not attempt to service the appliance beyond that described in the operating instructions. For
all other servicing refer to qualified service personnel only.
Download from Www.Somanuals.com. All Manuals Search And Download.
|