4-139-836-14(1)
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
Dispose of used battery promptly. Keep away
from children.
Never touch the wire of the external FM
antenna during a thunderstorm. Furthermore,
immediately disconnect the AC power cord
from the radio.
Compatible iPod/iPhone
models
Owner’s Record
e model number and the serial number are located on the
bottom.
Record the serial number in the space provided below. Refer
to them whenever you call upon your Sony dealer regarding
this product.
Preparing the remote
commander
About the backup
battery
Compatible iPod/iPhone models are as follows.
Update your iPod/iPhone to use the latest
software before you use it.
Before using the card remote commander for the
first time, remove the insulation film (See Fig.
-).
To keep accurate time, this unit contains a
CR2032 battery inside of the unit as a backup
power source.
NOTES ON LITHIUM BATTERY
Important Safety
Instructions
Wipe the battery with a dry cloth to assure a
good contact.
Model No. ICF-C7iP
iPod touch (4th generation)
iPod touch (3rd generation)
iPod touch (2nd generation)
iPod touch (1st generation)
iPod nano (6th generation)*
iPod nano (5th generation)
iPod nano (4th generation)
iPod nano (3rd generation)
iPod nano (2nd generation)
iPod nano (1st generation)
iPod with video
The battery keeps the clock operating in the event
of a power interruption.
Be sure to observe the correct polarity when
installing the battery.
1) Read these instructions.
Serial No.________________________________
2) Keep these instructions.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
3) Heed all warnings.
Knowing when to replace the
battery
For customers who purchased this product in the
USA
4) Follow all instructions.
Please register this product on line at
Proper registration will enable us to send you
periodic updates about new products, services, and
other important announcements. Registering your
product will also allow us to contact you in the
unlikely event that the product needs adjustment
or modification. ank you.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
If you have any questions or problems concerning
your unit, please consult your nearest Sony dealer.
When the battery becomes weak, “” appears in
the display.
7) Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
If a power interruption occurs while the battery is
weak, the current time and alarm will be erased.
Replace the battery with a Sony CR2032 lithium
battery. Use of another battery may cause a fire or
explosion.
Troubleshooting
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than the
other. A grounding type plug has two blades
and a third grounding prong. The wide blade
or the third prong are provided for your safety.
If the provided plug does not fit into your
outlet, consult an electrician for replacement
of the obsolete outlet.
10)Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the apparatus.
11)Only use attachments/accessories specified by
the manufacturer.
iPod with color display
iPod with click wheel
iPod classic
FM/AM
Should any problem persist after you have made
the following checks, consult your nearest Sony
dealer.
WARNING
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or
moisture.
To reduce the risk of fire, do not cover the
ventilation of the apparatus with newspapers,
tablecloths, curtains, etc. And do not place lighted
candles on the apparatus.
To reduce the risk of fire or electric shock, do not
expose this apparatus to dripping or splashing,
and do not place objects filled with liquids, such
as vases, on the apparatus.
Note
iPod mini
If “AM 12:00” flashes in the display when the unit
is connected to AC outlet for the first time, the
battery may be weak. In this case, consult your
Sony dealer.
Clock Radio
The clock flashes “AM 12:00” due to a power
interruption.
The battery is low. Replace the battery. Remove
the old battery and install a new one.
The radio, iPod or buzzer alarm does not
sound at the preset alarm time.
Check that alarm “A” or alarm “B” is properly
displayed.
iPhone 4S
iPhone 4
iPhone 3GS
iPhone 3G
iPhone
Replacing the battery
* The iPod nano (6th generation) cannot be
controlled by the remote when the command of
“MENU,” “,” “,” and “ENTER” is pressed.
Notes
1 Keep the AC plug connected to the AC
outlet, remove the screw that secures the
battery holder at the bottom of the unit
using a screwdriver, and remove the
battery holder (See Fig. -).
Operating Instructions
ICF-C7iP
The radio or alarm of iPod is activated but no
sound comes on at the preset alarm time.
Check the alarm volume setting.
In these Operating Instructions, “iPod” is used
as a general reference to functions of iPod on an
iPod or iPhone, unless otherwise specified by
the text or illustrations.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
The and VOL + buttons have a
tactile dot.
2
Replace a new battery in the battery holder
with the side facing up (See Fig. ).
There is no sound from the iPod.
Make sure the iPod is securely connected.
Adjust the VOLUME.
Dream Machine is a trademark of Sony Corporation.
-
Do not expose the batteries (battery pack or
batteries installed) to excessive heat such as
sunshine, fire or the like for a long time.
The connector of the unit is for sole use with an
iPod. If you use devices that do not match with
the connector, connect to the AUDIO IN
terminal of this unit with the supplied audio
connecting cable.
Sony cannot accept responsibility in the event
that data recorded to an iPod is lost or damaged
when using an iPod connected to this unit.
12)Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus
combination to avoid injury from tip-over.
3 Insert the battery holder back into the
unit and secure it with the screw (See
Fig. -).
4 Press iPod&iPhone, RADIO BAND,
AUDIO IN or SNOOZE/DATE/SLEEP
OFF to turn “” off in the display.
Note
When you replace the battery, do not disconnect
the plug from the AC outlet. Otherwise, the
calendar, current time, alarm and station presets
will be erased.
The iPod cannot be operated with this unit.
Make sure the iPod is securely connected.
As the main plug is used to disconnect the unit
from the mains, connect the unit to an easily
accessible AC outlet. Should you notice an
abnormality in the unit, disconnect the main plug
from the AC outlet immediately.
The iPod cannot be charged.
Make sure the iPod is securely connected.
When daylight saving time begins, the clock
does not employ the daylight saving time
automatically.
Make sure the clock is set correctly.
Press and hold CLOCK and SNOOZE/DATE/
SLEEP OFF simultaneously for at least
2 seconds to activate the Automatic DST
function.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
13)Unplug this apparatus during lightning storms
or when unused for long periods of time.
14)Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
For the state of california, USA only
Perchlorate Material –special handling may apply, See
Perchlorate Material: Lithium battery contains
perchlorate
Connecting the
antenna
No Power No Problem is a trademark of Sony Corporation.
CAUTION
©2009 Sony Corporation
Printed in China
To connect the AM loop
antenna
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
The shape and the length of the antenna is
designed to receive AM signals. Do not dismantle
or roll up the antenna.
CR2025
Specifications
Section for iPod
DC out: 5V
1 Remove only the loop part from the
plastic stand.
2 Set up the AM loop antenna.
MAX: 500mA
is symbol is intended to alert the user
to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that
may be of sufficient magnitude to constitute
a risk of electric shock to persons.
Radio section
Frequency range
Band Frequency
Channel step
87.5 MHz – 108 MHz 0.1 MHz
530 kHz – 1 710 kHz 10 kHz
is symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Features
FM
When to replace the battery
Wake or sleep to iPod/Radio
AM
With normal use, the battery (CR2025) should
last for about six months. When the remote
commander no longer operates the unit, replace
the battery with a new one (See Fig. -).
Dual Alarm
CR2032
General
Speaker
FM/AM 2-band digital synthesized tuner
30 Station Presets (20 FM. 10 AM)
Brightness Control (High/Mid/Low)
Extendable Snooze system from 10 to 60 min
No Power No Problem alarm system to keep
the clock and the alarm operating during a
power interruption with a CR2032 battery
installed
3 Connect the cords to the AM antenna
NOTE
Approx. 3.8 cm (1 1/2 inches) dia. 8 Ω
terminals.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
Cord (A) or cord (B) can be connected to
either terminal.
Input
Notes
AUDIO IN jack (ø 3.5 mm stereo minijack)
Power output
0.8 W (at 10% harmonic distortion)
Power requirements
120 V AC, 60 Hz
For clock back up: 3V DC, one CR2032 battery
Do not attempt to charge the battery.
If you are not going to use the remote
commander for a long time, remove the battery
to avoid any damage that may be caused by
leakage and corrosion.
Insert the cord while
pushing down the
terminal clamp.
Only insert up
Precautions
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
Dimensions
to here.
B
A
Approx. 115 mm × 124.7 mm × 97.1 mm (w/h/d)
Play the unit on the power source specified in
“Specifications.”
(4 9/16 × 4 15 16 × 3 7/8 inches) not including
/
projecting parts and controls
To disconnect the AC power cord (mains lead),
pull it out by the plug, not the cord.
Mass
The unit is not disconnected from the AC
power source (mains) as long as it is connected
to the wall outlet, even if the unit itself has been
turned off.
Approx. 510 g (1 lb 1.9 oz) including power
supply unit
Supplied accessories
Remote commander (1)
AM loop antenna (1)
Audio connecting cable (1)
Universal Dock Adapter for iPhone (1)
Universal Dock Adapter for iPhone 3GS &
iPhone 3G (1)
Universal Dock Adapter for iPhone 4S & iPhone 4
(1)
4 Make sure the AM loop antenna is
of the following measures:
— Reorient or relocate the receiving
antenna.
connected firmly by pulling softly.
Since a strong magnet is used for the speaker,
keep personal credit cards using magnetic coding
or spring-wound watches away from the unit to
prevent possible damage from the magnet.
Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit on
a surface (a rug, a blanket, etc.) or near
materials (a curtain) which might block the
ventilation holes.
Adjusting the AM loop antenna
Find a place and an orientation that provide good
reception.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Do not place the AM loop antenna near the
unit or other AV equipment, as noise may
result.
If the time in the display is
incorrect after the battery is
changed (Reset)
— Consult the dealer or an experienced radio/TV
technician for help.
Tip
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Design and specifications are subject to change
without notice.
Adjust the direction of the AM loop antenna for
best AM broadcast sound.
Press the Reset button with a pointed device. The
Reset button is in the small hole located near the
battery holder.
Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by qualified
personnel before operating it any further.
To clean the casing, use a soft cloth dampened
with a mild detergent solution.
WARNING
Replace the battery for the clock backup with a
Sony CR2032 lithium battery, and the battery
for the remote commander with a Sony CR2025
lithium battery. Use of another battery may
present a risk of fire or explosion.
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset
to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.
Download from Www.Somanuals.com. All Manuals Search And Download.
|