3-045-044-13 (1)
Location of controls
Operation
Additional Information
Lo ca t in g a sp e cific t ra ck
No t e s o n d iscs
Listening to a CD
— Automatic Music Sensor (AMS)
Precautions
• This unit cannot be used with a car audio
without an FM tuner.
• If your car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the unit to cool off before
operating it.
• If no power is being supplied to the unit,
check the connections first. If everything is in
order, check the fuse.
If you use the discs explained below, the sticky
residue can cause the CD to stop spinning and
may cause malfunction or ruin your discs.
During CD playback, press either side of
(AMS) for each track you w ant to skip.
AMS
1 Adjust the selected transmitting frequency
AMS
w ith an FM tuner.
SHUF
REPEAT
DSPL
OFF
Do not use second-hand or rental CDs that have
a sticky residue on the surface (for example from
peeled-off stickers or from ink, or glue leaking
from under the stickers.
(88.3 MHz/88.5 MHz/88.7 MHz/88.9 MHz/
89.1 MHz/89.3 MHz/89.5 MHz/89.7 MHz/
89.9 MHz)
To locate preceding
tracks
To locate succeeding
tracks
Co m p a ct Disc
Pla ye r
2 Insert a CD.
There are paste residue
Ink is sticky
Playback starts automatically.
•Connecting this unit may cause some car
battery wear when your car has no ACC
(accessory) position on the ignition key switch.
Lo ca t in g a sp e cific p o in t in a t ra ck
— Manual Search
Label side up
Do not use rental CDs with old labels that are
beginning to peel off.
During playback, press and hold either
side of (AMS) for about tw o seconds.
Release w hen you have found the desired
point.
1 AMS (Automatic Music Sensor) .
6 Reset button
7 Display w indow
If you have any questions or problems
concerning your unit that are not covered in this
manual, please consult your nearest Sony dealer.
button
Stickers that are beginning
to peel aw ay, leaving a
sticky residue
2 AMS (Automatic Music Sensor) >
Operating Instructions
8 SHUF (shuffle play) button
9 REPEAT (repeat play) button
0 DSPL (display mode change) button
qa OFF button
button
AMS
No t e s o n h a n d lin g CDs
3 Disc insertion slot
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum
sound, handle the disc by its edge. To keep the
disc clean, do not touch the surface.
Do not use any discs with labels or stickers
attached.
The following malfunctions may result from
using such discs:
— Inability to eject a disc (due to a label or
sticker peeling off and jamming the eject
mechanism).
— Inability to read audio data correctly (e.g.,
playback skipping, or no playback) due to
heat shrinking of a sticker or label causing a
disc to warp.
4 Z (eject) button
If a CD is already inserted, press u to start
playback.
5 u (play/pause) button
If pressed during playback, the CD will
pause. If pressed again, playback will
continue.
To search backw ard
To search forw ard
Note
If “
Elapsed playing time
” or “
” appears in the display,
you have reached the beginning or the end of the
disc and you cannot go any further.
Note
To play back an 8 cm (3 in.) CD, use the optional
Sony compact disc single adapter (CSA-8).
Do not stick paper or tape on the labeled
surface.
3 Adjust the volume w ith the volume
control on the car audio.
Labels are attached
Playing a CD in various
modes
Pla yin g t ra cks re p e a t e d ly
— Repeat Play
Getting Started
To
Press
Owner’s Record
The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.
Stop playback
Eject the CD
Z or (OFF)
Z
Do not expose the discs to direct sunlight or heat
sources such as hot air-ducts, or leave them in a
car parked in direct sunlight where there can be
a considerable rise in temperature inside the car.
Resetting the unit
Before operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press the reset button with a pointed object, such as a ball-point pen.
Wh e n yo u p la y 8 cm (3 in .) CDs
Press (REPEAT) during playback.
“REP” appears in the display.
Use the optional Sony compact disc single
adapter (CSA-8) to protect the CD player from
damage.
Notes
• Be sure to press (OFF) to turn this unit off when
you want to listen to FM radio.
When the current track is over, it will play again
from the beginning.
Model No. CDX-1000RF Serial No.
No t e s o n m o ist u re co n d e n sa t io n
• When CD playback is stopped, you may hear some
noise from the speakers. To prevent this from
happening, turn the volume down before stopping
CD playback.
• If you leave the ejected disc in the disc insertion
slot after you have pressed Z, the disc will
automatically retract into the unit after about 15
seconds in order to protect it.
AMS
SHUF
REPEAT
DSPL
OFF
On a rainy day or in a very damp area, moisture
may condense on the lenses inside the CD
player. Should this occur, the unit will not
operate properly. In this case, remove the disc
and wait for about an hour until the moisture
evaporates.
To return to normal playback mode, press again.
Pla yin g t ra cks in ra n d o m o rd e r
— Shuffle Play
Reset button
Notes
Press (SHUF) during playback.
“SHUF” appears in the display.
• Pressing the reset button will erase the clock setting and some memorized program and memory functions.
• When you connect the power supply cord to the unit or reset the unit, wait for about 10 seconds before you
insert a disc. If you insert a disc within these 10 seconds, the unit will not be reset, and you will have to press
the reset button again.
Before playing, clean the discs with a
commercially available cleaning cloth. Wipe
each disc from the center out.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic
spray intended for analog discs.
CDX-1000RF
Sony Corporation 2000 Printed in Korea
To return to normal playback mode, press again.
Ch a n g in g t h e d isp la y it e m
Each time you press (DSPL) during CD
playback, the item changes as follows:
Maintenance
Elapsed playing time b B Track number
Fu se re p la ce m e n t
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse
blows again after replacement, there may be an
internal malfunction. In such a case, consult
your nearest Sony dealer.
Changing the transmitting
frequency
Because this unit processes CD playback sound
through an FM tuner, there may be interference
noise during CD playback. In this case, change
the frequency of the modulated RF signal
transmitted from the unit. The initial setting is
88.3 MHz.
Changing the output level
You can select the output level of the CD player.
Normally the initial output level is adequate;
change the level if necessary.
Warning
Welcome !
Thank you for purchasing the Sony Compact
Disc Player. This unit lets you enjoy a variety of
features.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
1 Press (REPEAT) for tw o seconds.
Wa rn in g
2 Press (REPEAT) again.
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Initial setting
1 Press (REPEAT) for tw o seconds until
Features
•Easy connection to any car audio with an FM
tuner
•Dashboard installation for easy CD disc
changing
•8X digital sampling filter for clear CD audio
•Quick recovery function to minimize
disturbance from skips
•Repeat play function for playing tracks
repeatedly
•Shuffle play fucnion for playing tracks in
random order
frequency appears.
3 Press either the left or right side of (AMS)
to select the output level.
2 Press either the left or right side of (AMS)
to select the frequency.
To decrease the output level
Specifications
Each time you press (AMS), the frequency
changes as follows:
. : ,
CD p la ye r se ct io n
Ge n e ra l
Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
> : 88.3 MHz t 88.5 MHz t 88.7 MHz t
88.9 MHz t 89.1 MHz t 89.3 MHz t
89.5 MHz t 89.7 MHz t 89.9 MHz t
. : 88.3 MHz t 89.9 MHz t 89.7 MHz t
89.5 MHz t 89.3 MHz t 89.1 MHz t
88.9 MHz t88.7 MHz t 88.5 MHz t
System
Compact disc digital audio
system
Outputs
Line output
To increase the output level
Power requirements
12 V DC car battery
(negative ground)
2 A (at disc loading)
Approx. 178 × 50 × 173 mm
(7 1/8 × 2 × 6 7/8 in.)
(w/h/d)
Signal-to-noise ratio
Frequency response
Wow and flutter
Laser Diode Properties
Material
Wavelength
Emission Duration
Laser output power
90 dB
> : ,
10 – 20,000 Hz
Below measurable limit
Current drain
Dimensions
— Reorient or relocate the receiving antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Pro b le m
Ca u se /So lu t io n
GaAs + GaAlAs
4 Press (REPEAT) for more than tw o
CD cannot be loaded.
•Another CD is already loaded.
•The CD was forcibly inserted upside down.
785 ~ 815 nm (Typ.800 nm)
Continuous
Mounting dimensions
Approx. 182 × 53 × 159 mm
(7 1/4 × 2 1/8 × 6 3/8 in.)
(w/h/d)
Approx. 1.1 kg (2 lb. 7 oz.)
Parts for installation and
connections (1 set)
Compact disc single adapter
CSA-8
seconds.
3
Press (REPEAT) for more than tw o seconds.
Less than 0.5 mW*
Play does not begin.
CD is automatically ejected.
CD w ill not eject.
Dirty disc.
Mass
Supplied accessories
Note
* This output is the value measured at a distance of
0.7 mm from the objective lens surface on the
Optical Pick-up Block.
— Consult the dealer or an experienced radio/
TV technician for help.
Be sure to set the frequency of your FM tuner to the
newly selected frequency.
The ambient temperature exceeds 50°C (122°F).
Press the Z button for two seconds.
Press the reset button.
Optional accessories
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
The operation buttons do not
function.
Rotary commander
RM-X4S
Source selector
XA-107
BUS cable (supplied with an
RCA pin cord)
RC-61 (1 m), RC-62 (2 m)
•The unit is installed at an angle of more than 60°.
•The unit is not installed in a sturdy part of the car.
The sound skips due to
vibration.
CAUTION
The use of optical instruments with this product
will increase eye hazard.
Erro r d isp la ys
The following indications will flash for about five seconds.
Design and specifications are subject to change
without notice.
Disp la y
Ca u se
So lu t io n
A CD is dirty or inserted upside
down.
Clean or insert the CD correctly.
The CD player cannot be operated
because of some problem.
Press the reset button or Z.
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony dealer.
Download from Www.Somanuals.com. All Manuals Search And Download.
|