English
Owner’s Record
The model and serial numbers are located on the rear of the unit. Record the
serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Speaker System
Model No.
Serial No.
SS-CR3000
Precautions
2-899-202-11(2)
• Avoid driving the speaker system continuously with a wattage exceeding the
maximum input power of this speaker system.
• Before connecting, turn off the amplifier to avoid damaging the speaker system.
• If the +/– connection is incorrect, the bass tones will seem to be missing and the
position of the instruments becomes obscure.
(2)
• The speaker grille on the SS-CN3000P and SS-SR3000P cannot be removed. Do
not attempt to remove the grille on the SS-CN3000P and SS-SR3000P. If you try
to remove it, you may damage the speaker.
• To connect to speaker terminals (SURROUND, CENTER)
SS-CN3000P
In case color irregularity is observed on nearby TV screen
With the magnetically shielded type of the speaker system, the speakers can be
installed near a TV set. However color irregularity may still be observed on the TV
screen depending on the type of your TV set.
SS-SR3000P
(Right)
SS-SR3000P
(Left)
If color irregularity is observed...
→ Turn off the TV set, then turn it on after 15 to 30 minutes.
If color irregularity is observed again...
→ Place the speakers more apart from the TV set.
+
–
Amplifier
Specifications
SS-CN3000P (Center speaker)
Speaker system
Speaker units
Enclosure type
Full range, magnetically shielded
7.0 cm (2 3/4 in.), cone type × 2
Bass reflex
SURROUND
CENTER
Rated impedance
Power handling capacity
Sensitivity level
8 ohms
SS-CN3000P
• To use the systems as surround speaker system
Maximum input power: 100 watts
85 dB (1 W, 1 m)
Frequency range
Dimensions (w/h/d)
150 Hz - 20,000 Hz
Approx. 430 × 86 × 105 mm
(17 × 3 3/8 × 4 1/8 in.)
including front grill
Approx. 1.6 kg (3 lb 9 oz)
Speaker cord, short (1)
Foot Pads (4)
Mass
Supplied accessories
SS-SR3000P (Surround speakers)
SS-SR3000P
Speaker system
Speaker units
Full range
7.0 cm (2 3/4 in.), cone type
• To put the SS-CN3000P on your
TV set
Please attach a foot pad (supplied)
to each bottom corner of the
speaker, and make sure that the
speaker is completely flat on top of
the TV.
Enclosure type
Bass reflex
8 ohms
Maximum input power: 100 watts
85 dB (1 W, 1 m)
150 Hz - 20,000 Hz
Approx. 110 × 170 × 111 mm
(4 3/8 × 6 5/8 × 4 3/8 in.)
including front grill
Approx. 0.9 kg (1 lb 16 oz)
Speaker cord, long (2)
Rated impedance
Power handling capacity
Sensitivity level
Frequency range
Dimensions (w/h/d)
Foot pads
Mass
Supplied accessory
Design and specifications are subject to change without notice.
• To hang SS-SR3000P with a hook
(not supplied) on the wall
You are responsible for the proper
selection and use of mounting
hardware that you purchase at
hardware stores, and for the proper
and safe mounting of the speakers.
4.6 mm
10 mm
• To install SS-SR3000P on the
speaker stand (not supplied)
It is recommended to use the optional
WS-FV11 or WS-FV10D speaker stand
(available only in certain countries).
Be sure to detach the screw A from
the speaker and use it during
installation. For details, refer to the
operating instructions supplied with
the speaker stand.
Hook
Screw A
2007 Sony Corporation Printed in Malaysia
Download from Www.Somanuals.com. All Manuals Search And Download.
|