|
SNOW CAB #1694921
FOR
Regent, LT 200 Series,
500 Series Lawn Tractors,
2500 Series Lawn Tractors
PARTS LIST – ASSEMBLY INSTRUCTIONS
IMPORTANT !
READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE
CAUTION !
REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR TRAILER
WARNING !
THIS CAB WILL NOT PROTECT OPERATOR FROM INJURIES CAUSED BY ROLLOVER,
COLLISION, OR OTHER ACCIDENTS
11574506
1
Download from Www.Somanuals.com. All Manuals Search And Download.
For Replacement Parts and Accessories Contact:
Original Tractor Cab Co., Inc.
P.O. Box 97 6849 W. Front St.
Arlington, IN 46104
Phone 765-663-2214
Fax
765-663-2101
Email [email protected]
Visit us on the web to see our other products.
Cabs for Lawn Tractors, Garden Tractors, Compact Tractors, Snow Blowers, Utility Vehicles
Sunshades for Tractors, Mowers, & Utility Vehicles
Storage Covers for Lawn and Garden equipment. .
LIMITED WARRANTY
COVERED BY WARRANTY
ORIGINAL TRACTOR CAB CO., INC., (the "Company") warrants to the owner that each new product listed below is merchantable and free of defects in
workmanship and material.
During the warranty period, the dealer from whom the product was bought, or the Company, will provide, free of charge, parts and the shipping costs of parts
necessary to correct any defect in workmanship and material.
WARRANTY PERIOD
The company products listed below are warranted for the stated period from the date of the original purchase:
1. Cabs for tractors and snow removal equipment
2. Company manufactured accessories for above cabs
3. Sunshades for lawn and garden tractors
4. Repair parts
1 Year
1 Year
1 Year
1 Year
OWNER'S RESPONSIBILITIES
The owner of a new Company manufactured product must do the following to qualify for warranty service:
1. Retain the original invoice or other proof of purchase to avoid unnecessary difficulties in determining eligibility for warranty work.
2. Notify the dealer from whom the product was bought, or the company, as soon as possible after discovery of a possible defect, and provide proof of original
purchase.
To notify the company write to: Original Tractor Cab Co., Inc., P.O. Box 97, Arlington, IN 46104.
3.the owner may, upon notification by the Company, be required to return the defective part, or parts, to the Company for inspection and warranty service.
NOT COVERED BY WARRANTY
The following are not covered by this warranty:
1. Transportation charges to and from servicing dealer or the Company;
2. New products that have been subject to misuse, negligence or accident, or have been altered or repaired in a manner not authorized by the company;
3. Windshield wipers, lights, or accessories that are warranted separately by their respective manufacturers, except Company agrees to make available to
the owner whatever warranty benefits may be made available to the Company by the manufacturers.
All implied warranties, except to the extent prohibited by any applicable law, shall have no greater duration than the warranty period for the
applicable product, some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.
The Company’s' liability arising out of warranties representation, instructions, or defects from any abuse, shall be limited exclusively to repair
or replacing parts under the condition in the warranty, and in no event will Company be liable for incidental or consequential damages. Some
states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you.
This warranty gives you specific legal rights, and you may also have rights that vary from state to state.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Carton Contents: Snow Cab #1694921
Key # Part #
1
Qty. Description
Front Panel Frame
11594
11593
11595
11596
10004
10002
10003
11597
11598
10750
10751
11050
11051
10001
11600
11599
10749-B
10000
11601
11603
11602
11604
9820
11605
786
788
1514
730
4580
1093
2945
60182
4902
1
2
1
1
2
1
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
14
6
4
20
2
2
2
2
2
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Foot
Foot Pocket Guard, RH
Foot Pocket Guard, LH
Front Post
Top Frame Brace, RH
Top Frame Brace, LH
Rear Cross Bar Bracket
Rear Cross Bar
Rear Post, RH
Rear Post, LH
Rear Boxing Post, RH
Rear Boxing Post, RH
Top Frame
Rear Curtain
Front Panel Vinyl
Windshield
Plastic Top
Door, RH
Door Bottom, RH
Door, LH
Door Bottom, LH
Door Hardware Package
Hardware Package (contents listed below)
1/4”-20 x 5/8” HHCS
1/4”-20 x 3/4” HHCS
1/4” Flat Washer
1/4” Lock Nut
5/16”-18 x 1 3/4” RHMS
5/16”-18 x 1 1/4” HHCS
5/16”-18 Hex Nut
5/8” O.D. x 1/2” Spacer
Plastic Protector
Optional Cab Accessories:
#10120 Safety Glass Windshield
#10121 Hand Operated Wiper
#10122 Electric Wiper
# 9855 Flashing Amber Caution Light
#11133 Rear View Mirror, R or L Mount
(Available only from Original Tractor Cab)
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 1; See Figure 1:
Identify the steel parts by using Figure 1.
Figure 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 2; See Figure 2 & 2A:
Install Front Panel Frame (1)
1
A. Remove the bolt at reference A on both
sides of the tractor. Place the Front Panel
Frame over the dash from behind. Insert two
5/16” x 1 1/4” bolt inwards through the holes in
the Front Panel Frame Legs.
B. Place a 5/8” O.D. x 1/2” spacer over the bolt.
Insert the bolts into the holes at reference A.
Tighten just enough to keep the frame upright.
A
Figure 2
A
Figure 2A
Step 3; See Figure 3:
Install right Foot (1)
A. Insert a 5/16” x 1 3/4” full thread screw into
the clamp of one of the Feet.
.
B. Place the clamp over the edge of the step
plate as shown in Figure 3A Tighten the bolt just
enough to hold it in place. Repeat this step on
the left side.
Figure 3A
Figure 3
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 4; See Figure 4:
Install right & left Front Posts (5) and right & left
Top Frame Braces (6 & 7).
Note: Bent ends of Top Frame Braces will point
rearwards and lay flat when properly installed.
5
7
A. Insert a 1/4” x 3/4” bolt forward through the
tab on the post, the end of the Front Panel
Frame and then the lower end of the Top Frame
Brace. Add a nut. Tighten just enough to hold
the braces up.
6
B. Insert a 1/4” x 3/4” bolt outwards through the
lower hole in the foot, the lower hole in the post
and then the right Foot Pocket Guard (shorter
than left). Add a nut. Tighten enough to hold
the Foot Pocket guard as shown.
C. Insert a bolt out through the upper hole in
the Foot and Post. Place a door hinge from the
Door Hardware Package over the bolt and add
a nut. Do not tighten at this time.
D. Repeat on left side of tractor.
Figure 4
Step 5; See Figure 5:
Install Rear Cross Bar Brackets (8) and Rear
Cross Bar (9)
B
A. Remove the bolts at Reference B.
B. Place the Rear Cross Bar Brackets over the
holes as shown. Replace the bolts. Do not
tighten at this time.
8
C. Place the tabs welded to the Rear Cross Bar
over the brackets as shown. Insert two bolts
down through the holes and add locknuts. Do
not tighten at this time.
9
Figure 5
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 6; See Figure 6:
Install right and left Rear Posts (10 & 11)
and right and left Rear Boxing Posts (12 & 13).
NOTE: When properly installed Rear Post
latch plates will face forward with the notch to
the outside
.
A. Insert a 1/4” x 3/4” bolt outwards through the
Rear Cross Bar, right Rear Post and then the
right Boxing Post,. Add a nut. Tighten enough
to keep the parts upright.
B. Repeat step 6A on the left side with left
Posts.
Figure 6
Step 7; See Figure 7:
Install Top Frame (14)
14
A. Place the top frame onto the bent ends of
the posts.
B. Insert eight bolts up through the Rear
Boxing Posts, the Rear Posts, Top Frame
Braces and the Front Posts. Add nuts. Do not
tighten at this time.
Figure 7
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 8: See Figure 8:
Install the Doors for frame / door alignment.
A. Follow the instructions in the Door Hardware
Package to install the Door Bottoms and the
Door Latches.
B. Install, close and latch both Doors.
C. Tighten all bolts from previous steps at this
time. Add two 5/16” nuts to the Front Panel
Frame leg bolts at reference A. Tighten
securely.
Note: If door latch rod does not line up with
notch in latch plate loosen the Foot clamp and
move Foot forward or rearward to raise or lower
the rod. Tighten the clamp.
D. Remove the Doors to complete the
installation.
Figure 8
Step 9: See Figure 9:
Install Windshield (17) and Front Panel Vinyl
(16).
17
A. Place the Windshield and Front Panel Vinyl
face up on a clean flat surface. Press the hook
and loop fastener together.
16
B. Lay the rod sewn into the top of the
windshield over the top frame. Close the snap
flaps around the corners of the top frame.
C. Secure the ties to the cross bar and close
the snap flaps around the posts.
D. Lock the brake pedal down. Fit the vinyl
around the Foot Pocket Guards and Pedals.
Connect the hook and loop fastener under the
step plates .
Figure 9
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 10: See Figure 10:
Install Rear Curtain (15).
A. Lay the rod sewn into the vinyl over the rear
of the Top Frame. Close the snap flaps at the
corners.
B. Close the snap flaps over the Rear Posts
and Rear Cross Bar.
C. Secure the ties to the Rear Cross Bar.
D. Place a notched Plastic Protector over the
bent ends of each rear post. (See inset)
15
Figure 10
Step 10: See Figure 10:
Install Doors and Top (18).
18
A. Install doors per the instructions in the door
hardware package. Connect the hook and loop
fastener strips on the lower door & front panel.
B. Make sure that the rods sewn into the
windshield and rear curtain are lying over the
top frame. Place the top over the top frame.
C. Place four1/4” flat washers over each of four
bolts. Insert bolts inwards add locknuts and
tighten.
Figure 10
10
Download from Www.Somanuals.com. All Manuals Search And Download.
|