Shure Headphones i2c t User Manual

WEARING THE EARPHONES  
INSERTING THE EARPHONES  
I
2c-T  
If the earphone seems to be lacking in low frequency response (bass), check  
the tightness of the seal between the earphone and your ear, or try one of the  
other sleeve options.  
Sound Isolating Earphones  
Wear the earphones as illustrated below.  
These sound-isolating earphones  
with VoicePort inline microphone  
connect to your integrated media  
player cell phone. They feature  
Dynamic MicroDriver technology  
that you can now enjoy at low  
listening levels, even in noisy  
environments.  
Warning: Do not push the earphone sleeve beyond the ear canal opening.  
left ear  
right ear  
Over the ear  
in front  
Make sure that the sleeve completely  
covers the earphone stem. If any part  
of the nozzle is exposed, the sleeve is  
not properly installed.  
©2005, Shure Incorporated  
27EN3209 (Rev. 2)  
Printed in U.S.A.  
CHOOSING AN EARPHONE SLEEVE  
WAX GUARD  
INLINE SWITCH CONTROL  
Your earphones come with a selection of sleeves. Make sure the sleeve you  
use is easy to insert into your ear, fits comfortably, and is easy to remove from  
your ear.  
You should place wax guards on the nozzle of your I2c-T earphones before  
using them. These protective rings are found on an adhesive strip in the fit kit  
that comes with your earphones.  
Push and hold to MUTE cell phone microphone  
To place a wax guard on one of your I2c-T earphones:  
1. Remove the sleeve from the earphone nozzle.  
2. If there is a dirty wax guard on the earphone, peel it off.  
3. Clean the tip of the I2c-T nozzle with an antiseptic or alcohol wipe.  
4. Make sure that the tip of the nozzle is dry, then remove a wax guard from the  
supplied strip and place it on the tip of the nozzle, adhesive side down.  
5. Replace the sleeve on the earphone.  
Flex Sleeves  
Volume  
In small, medium, and large sizes. Made from translucent  
PVC.  
Wax Guard  
Soft Flex Sleeves  
In small, medium, and large sizes. Made from pliable rubber.  
Audio source:  
cell phone  
Stem  
Foam Sleeves  
When using the foam sleeves, compress the sleeve between  
your fingers before inserting it into the ear canal. Hold the  
earphone in place for about ten seconds while the foam  
expands and creates a tight seal.  
media player  
IMPORTANT: Do not place wax guards on sleeves! Wax guards are intended for use on  
the tip of the earphone nozzle only. If wax guards are placed on sleeves they will not  
function properly and may fall off the sleeves into your ears.  
Note: Turn volume control to its lowest setting before switching be-  
tween music and cell phone. Switching to media during a call mutes  
cell phone.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sharp Flat Panel Television LU630E User Manual
Sharp Stereo System MD M2H User Manual
Sony Car Stereo System CDX C460 User Manual
Sony Kitchen Entertainment Center PCV E518DS User Manual
Sony MP3 Player D NE718CK User Manual
Stiga Lawn Mower 13 6113 14 User Manual
Stiga Lawn Mower DIESEL 4WD User Manual
Swann Home Security System DVR4 User Manual
Swisher Lawn Mower ZT17542 User Manual
Symbol Technologies Network Card MRC 921 User Manual