ONE YEAR LIMITED WARRANTY
SI PRODUCTS sells its products with the intent that they are free of defects in manufacture and
workmanship for a period of one year from the date of original purchase, except as noted below.
SI PRODUCTS warrants that its products will be free of defects in material and workmanship under
normal use and service. This warranty extends only to consumers and does not extend to Retailers.
To obtain warranty service on your SI PRODUCTS product, mail the product and your dated sales receipt
(as proof of purchase), postpaid, to the following address:
Wine Preservation System
SI PRODUCTS Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI 48390
No COD's will be accepted.
SI PRODUCTS does not authorize anyone, including, but not limited to, Retailers, the subsequent
consumer purchaser of the product from a Retailer or remote purchasers, to obligate SI PRODUCTS in any
way beyond the terms set forth herein. This warranty does not cover damage caused by misuse or abuse;
accident; the attachment of any unauthorized accessory; alteration to the product; improper installation;
unauthorized repairs or modifications; improper use of electrical/power supply; loss of power; dropped
product; malfunction or damage of an operating part from failure to provide manufacturer’s recommended
maintenance; transportation damage; theft; neglect; vandalism; or environmental conditions; loss of use
during the period the product is at a repair facility or otherwise awaiting parts or repair; or any other
conditions whatsoever that are beyond the control of SI PRODUCTS.
SI Products
Service Center
1.888.856.6781
8:30a.m. – 7:00p.m. (EST)
M – F
This warranty is effective only if the product is purchased and operated in the country in which the
product is purchased. A product that requires modifications or adoption to enable it to operate in any
other country than the country for which it was designed, manufactured, approved and/or authorized, or
repair of products damaged by these modifications is not covered under this warranty.
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE
SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH
RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. SI PRODUCTS SHALL HAVE NO LIABILITY FOR
ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY
REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO BE
DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY.
Mail To: SI Products
Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE,
SI PRODUCTS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU
OF REPAIR OR REPLACEMENT.
This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed
products, including but not limited to sale of such products on Internet auction sites and/or sales of such
products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately cease and
terminate as to any products or parts thereof which are repaired, replaced, altered, or modified, without
the prior express and written consent of SI PRODUCTS.
This warranty provides you with specific legal rights. You may have additional rights which may vary from
state to state. Because of individual regulations, some of the above limitations and exclusions may not
apply to you. For more information regarding our product line in the USA,
Instruction Manual
and Warranty Information
KP-W140
THE SHARPER IMAGE ® name and logo are registered trademarks.
Marketed and distributed by SI Products under license. ©The Sharper Image.
All rights reserved.
IB-KPW140
Download from Www.Somanuals.com. All Manuals Search And Download.
Fig. 1
Wine Preservation System – Operation Instruction
We recommend that you charge your Wine Preserver for at least 12 hours before
using for the first time. Please follow the instructions for recharging as stated below:
1) Charging your Wine Preserver
Wine Preserver
•
•
•
•
Plug end of the adaptor cord into the recharging base and the A/C end into an
electrical outlet.
Place the motorized wine preserver onto the charging base making sure that it is
firmly in position and that it is in full contact with the recharging connection. (Fig.1)
Press the power button once and a red light turns ON indicating that the unit is
charging. It will take approximately 8-10 hours to recharge your Wine Preserver.
When the wine preserver is fully charged, the LED light becomes green. (Fig.1)
Power Button
2) Date Dial
•
Press and hold for 0.5 second on the screen of the LCD date counter to start
the countdown.
•
•
The LCD initially shows “0” with a single increment every 24 hours.
It will automatically change to the 1st day after 24 hours and change to the 2nd
day after 48 hours and so on, up until the 9th day.
•
Press and hold for 0.5 second on the screen of the LCD date counter to turn off.
Note: A 3V button cell battery comes pre-installed into the Date Dial. We
recommended that you always keep the date dial off while not in use for
energy saving.
CHARGE
Battery Replacement
LED Light
Charging Base
•
•
•
Unscrew the four screws from its end cap to remove its top cover as
shown attached.
Take out the date counter module by releasing the snaps and replace
the battery.
Use a single CR927 3V type battery per module only.
Date Dial
AC Adaptor
Silicon Stopper (4)
Screws (4)
5
4
Download from Www.Somanuals.com. All Manuals Search And Download.
3) Sealing the Wine Bottle
Fig. 2
MAINTENANCE
•
Insert the stopper into the mouth of the
bottle, pushing down until it fits firmly.
Position the wine preserver over the
wine bottle and stopper and push
down gently. (Fig. 2)
To Store
You may leave the unit on display or you can store it in its box in a cool, dry place.
To Clean
Use only a soft dry cloth to clean the enclosure of the unit. NEVER use liquids or
abrasive cleaner to clean.
•
•
Press the power button, the battery-
operated wine preserver automatically
removes the air and the blue back
light illuminates to indicate the unit is
powered on. (Fig.2)
•
•
When the seal is completed, the wine
preserver will automatically shut off.
Remove the wine preserver from
the bottle. Press the date dial for
0.5 second; it will automatically count
and change from the 0 day to the
9th day for each 24 hours.
•
Press and hold the date dial to turn off.
NOTE: Always return the wine
preserver to the charging base when
done. This will protect and charge the
unit while not in use.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|