Scotts Water Dispenser XR650R User Guide

XR 650R Front-Mount stabilizer kit  
1. This kit was designed for use on the Baja 1000 race bikes and has been in the winner’s circle many times over.  
2. If mounted properly it will give you years of trouble free service. Follow the instructions please.  
3. This front mount kit requires re-locating the odometer! (Optional odometer mount is available from Scotts and  
4. This kit is designed to fit with the Scotts Triple clamp only! Since the clearances are very close, we cannot be  
responsible for other triple clamp manufacturer’s dimensions and options. We’ve gone to great lengths to make  
our product fit easily and function correctly when using our stabilizer with our upper triple clamp.  
5. Remove the stock top triple clamp.  
6. Remove the stock odometer and cable and discard or relocate to the right upper triple clamp pinch bolts with the  
optional Scotts stainless steel remote odometer bracket (see photo). This same remote bracket can be used for  
various computers such as the Trail tech computers also. It’s been made specifically to accommodate the stock  
odometer for relocation.  
7. Before installing the frame bracket, examine the head tube area to be sure no obstructions will prohibit the  
installation of the frame bracket. A burr or raised area on the aluminum could fracture the frame bracket.  
8. Install the new billet one-piece frame bracket checking the fit all the way around the backside of the frame  
where the frame casting may vary in size. It’s vital that our bracket seat evenly all the way around the head  
tube if you expect it to stay on. A few extra minutes to make sure all the very small casting flaws are out of the  
way will insure many years of quality use.  
9. The frame bracket must sit down flush with the top of the head tube. If it protrudes above the surface of the  
head tube, you must file the casting flaws until it’s flush or you will jeopardize the brackets strength and ability  
to stay tight. If not flush, you may also experience interference from the triple clamp bolts on the under side to  
the top of the frame bracket. Review the photos. which shows the proper installation clearances.  
10. If the frame bracket will not drop down flush with the head tube you may need to file the knub or casting area  
just behind the head tube where the slag or imperfections disallow the frame bracket to drop down all the way.  
File in a fashion that keeps the head tube shape (round) but allows the frame bracket to drop down until flush.  
These are rare cases and normally need very little filing.  
11. Once the bracket is mounted flush, reinstall the triple clamp and be sure it swings clearly both ways to the stops.  
12. Keep the clutch cable and any wires routed below the frame bracket so they are not “pinched” by the rotating  
triple clamp. Street legal kits on XR’s will need the wires zip tied up away from the rotating triple clamp. Be  
sure to turn the bars from lock to lock and verify the cables or wires won’t get tangled in the tower or damper  
linkarm.  
13. Mount the Stabilizer to the triple clamp and align the linkarm slot to the vertical tower on the frame bracket.  
14. Sit on your bike and be sure the frame bracket is aligned when the wheel is pointing straight ahead.  
15. Tighten all the triple clamp bolts and the steering head nut.  
16. Do not over tighten the pinch bolt on the frame bracket, because it normally fits very tight anyway, just normal  
tension on the 8mm bolt is plenty. Over tightening the bolt can cause the bracket to fracture.  
17. If you have replaced the handlebars be sure the width is narrow enough to prevent the throttle cables from  
pulling tight at full lock. The stock XR bars are 31” wide, any wider could pull on the throttle cables.  
18. Keep the floating tower pin greased, so it stays free to float in the vertical tower assuring alignment.  
19. Check your stabilizer manual for initial settings and how to adjust your stabilizer. Call us if you have questions.  
XR650R FWD mount instructions 03/02/06 4601-10  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Radio Shack Cordless Telephone 43 3577 User Guide
Radio Shack Motorized Toy Car 63 4324 User Guide
RCA Car Stereo System ANT1275F QSG 00 User Guide
Ricoh Digital Camera FV L200B1 User Guide
Rikaline GPS Receiver BT Q880 User Guide
Roberts Radio Clock Radio CR960 User Guide
Samsung Cell Phone DECT 8000 User Guide
Samsung MP3 Player YP U2R User Guide
Sanyo CRT Television DS19204 User Guide
Seagate Laptop ST2000NM0014 User Guide