Battery
Charger
Models:
JG-2516
25 AMP Fully Automatic Battery Charger
For 16 Volt Racing Batteries
Owner's Manual
–Save–
Important Safety Instructions
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
A.
GENERAL BATTERY SAFETY
• Pins on plug of extension cord are the same number,
size, and shape as those of plug on charger.
• Extension cord is properly wired and in good electrical
condition.
1. Before you use your battery charger, be sure to read all
instructions and cautions printed on:
• Battery Charger
• Battery
• Wire size is large enough forAC ampere rating of charger,
as specified below:
• Vehicle or unit using battery
2. Use battery charger on LEAD ACID type rechargeable
batteries only, such as used on race cars. Charger is not
intended to supply power to low-voltage electrical system
other than in an automotive application.
Length of cord (feet):
AWG size of cord:
25
18
50
16
100
12
150
10
WARNING: Do not use battery charger for charging dry-
cell batteries that are commonly used with home appliances.
These batteries may burst and cause injury to persons and
damage to property.
11. Always charge battery in a well-ventilated area.
NEVER operate in a closed-in or restricted area without
adequate ventilation.
3. Use only attachments recommended or sold by
manufacturer. Use of non-recommended attachments may
result in fire, electric shock, or injury.
WARNING: Risk of explosive gas.
12. Locate charger as far away from battery as DC charger
cables permit.
4. When disconnecting the battery charger, pull by the plug
not by the cord. Pulling on the cord may cause damage to
cord or plug.
5. Locate battery power cord so it cannot be stepped on, tripped
over, or subjected to damage or stress.
13. Do not expose charger to rain or snow.
14. NEVER charge a frozen battery. If battery fluid (electrolyte)
is frozen, bring into a warm area to thaw before charging.
15. NEVER allow battery acid to drip on charger when reading
specific gravity or filling battery.
6. Do not operate charger with damaged cord or plug. Have
cord replaced immediately.
16. NEVER set a battery on top of charger.
17. NEVER place charger directly above battery being charged.
Gases from battery will corrode and damage charger.
18. NEVER touch the battery clamps together when the charger
is energized.
19. NEVER crank engine with charger attached to battery.
WARNING: Battery chargers get hot during operation and
must have proper ventilation. Air needs to flow around entire
charger. Do not set on flammable items like carpeting,
upholstery, paper, cardboard, etc. Will damage leather and
melt plastic and rubber.
7. Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to a
qualified professional for inspection and repair.
8. Do not disassemble charger. Take it to a qualified
professional when service or repair is required. Incorrect
reassembly may result in electric shock or fire.
9. To reduce risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning.
10. Do not use an extension cord unless absolutely necessary.
Use of an improper extension cord could result in fire or
electric shock. If an extension cord must be used, make
sure that:
JEG’S HIGH PERFORMANCE
Delaware, OH 43015
Send Warranty Product Repairs to: Schumacher Electric Corporation, 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485
00-99-000534/0605
1
Download from Www.Somanuals.com. All Manuals Search And Download.
F.
OPERATING INSTRUCTIONS: CHARGING BATTERY OUT OF THE VEHICLE
When charging battery out of the vehicle, take care to determine the battery type. To reduce risk of a spark near battery, follow these
steps when battery is outside vehicle. WARNING: A spark near battery may cause battery explosion. WARNING: When removing battery
from vehicle or boat, disconnect grounded post first. When disconnecting, make sure all accessories are off, so as not to cause an arc.
(NOTE: A marine (boat) battery must be removed and charged on shore. (To charge on board requires special equipment designed for
marine use.) WARNING: When reinstalling battery, attach the ground post first.
1. Perform these steps with the ON/OFF switch in the OFF
NEGATIVE
POSITIVE
position.
BATTERY CHARGER
2. Check polarity of battery posts. Battery case will be marked
BATTERY
by each post: POSITIVE (POS, P, +) and NEGATIVE (NEG,
N, -). NOTE: The positive battery post usually has a larger
+ -
diameter than the negative post.
POWER
CORD
24", 6 GUAGE
CABLE
3. Attach a 24-inch long (or longer) 6-gauge (AWG) insulated
battery cable to NEGATIVE (NEG, N, -) battery post.
(Purchase cable separately.)
TO GROUNDED
POWER OUTLET
4. Connect POSITIVE (RED) charger clamp to POSITIVE
(POS, P, +) battery post. Rock clamp back and forth to
make good connection.
FIGURE 1: CONNECT NEGATIVE BATTERY CLAMP
TO 24-INCH CABLE END
5. Position yourself and free end of 24-inch cable as far away
from battery as possible. Then connect NEGATIVE (BLACK)
charger clamp to free end of cable. WARNING: Do not face
battery when making final connection. Rock clamp back
and forth to make a good connection.
8. When battery is fully charged, push ON/OFF switch to OFF,
unplug charger from AC power source.
9. When battery is fully charged and charger is unplugged,
(1) remove clamp from end of 24-inch long cable connected
to NEGATIVE battery post, then (2) remove clamp from
Positive battery post, in that order.
FIGURE 1 shows the connection.
6. Plug charger AC cord into 120 volt outlet.
7. Select ON position on ON/OFF switch.
10. Clean and store battery charger.
G.
OPERATING INSTRUCTIONS: CHARGING BATTERY IN VEHICLE
When charging battery in vehicle, take care to determine the battery type and which pole is grounded. To reduce risk of a spark near
battery, follow these steps when battery is inside vehicle. WARNING: A spark near the battery may cause battery explosion.
1. Perform these steps with the ON/OFF switch in the OFF
GR
(
position.
2. Position AC power cord and DC charging cords to reduce
risk of damage by hood, door, or moving engine parts.
3. Stay clear of fan blades, belts, pulleys, and other parts that
can cause injury.
4. Check polarity of battery posts. Battery case will be marked
by each post: POSITIVE (POS, P, +) and NEGATIVE (NEG,
N, -). NOTE: The positive battery post usually has a larger
diameter than the negative post.
FIGURE 2: CONNECTION TO NEGATIVE
GROUNDED BATTERY
5. Determine which post of battery is grounded (connected)
POSITIVE GROUNDED POST
to chassis. NOTE: The negative post is normally grounded.
6B. For positive-grounded vehicle, connect NEGATIVE (BLACK)
clamp from battery charger to NEGATIVE (NEG, N, -)
ungrounded post of battery. Connect POSITIVE (RED)
clamp to vehicle chassis or engine block away from battery.
Connect to a heavy-gauge metal part of the frame or engine
block.
NEGATIVE GROUNDED POST
6A. For negative-grounded vehicle, connect POSITIVE (RED)
clamp from battery charger to POSITIVE (POS, P, +)
ungrounded post of battery. Connect NEGATIVE (BLACK)
clamp to vehicle chassis or engine block away from battery.
Connect to a heavy-gage metal part of the frame or engine
block.
7. Plug charger AC cord into a grounded 120 volt outlet.
8. Select the ON position on the ON/OFF switch.
WARNING: Do not connect clamp to carburetor, fuel lines,
or sheet-metal body parts. NOTE: Attach clamps to battery
post and twist or rock back and forth several times to make
a good connection. This tends to keep clamps from slipping
off terminals and helps to reduce risk of sparking.
9. When battery is fully charged, push the ON/OFF switch to
OFF, unplug charger from AC power source.
10. Remove charger clamps from (1) chassis and (2) battery
post, in that order.
FIGURE 2 shows connections for a negative-grounded
battery.
11. Clean and store battery charger.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
H.
TROUBLESHOOTING
PROBLEM
POSSIBLE
SOLUTION
Red LED doesn't light
Charger is not plugged in
AC outlet is dead.
Plug in.
Plug in a lamp or other appliance to check for
voltage.
Charger will not turn ON when
properly connected to power.
Battery recently used in vehicle and is
fully charged.
Battery doesn't need charging.
Have battery checked.
Charger will not turn OFF.
Battery has problem and will not take
full charge.
Battery is connected to application that
draws a small current (such as a
vehicle's dome light).
Requires more time to charge: continue
charging..
I.
MAINTENANCE/CLEANING INSTRUCTIONS
Little maintenance is required for the battery charger.
3. Have any cracked or frayed cords replaced by a qualified
professional.
1. After use, wipe all battery corrosion and other dirt or oil
from clamps, cord, and the charger case. Use a dry cloth.
4. Store battery charger in a clean, dry area.
2. Coil charger cords to prevent damage.
LIMITED WARRANTY
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND
THE MANUFACTURER NEITHER ASSUMES NOR
AUTHORIZESANYONE TOASSUME OR MAKEANY OTHER
OBLIGATION TOWARDS THE PRODUCT OTHER THAN
JEG’S HIGH PERFORMANCE, 101 JEGS PLACE,
DELAWARE, OH 43015 MAKES THIS LIMITED WARRANTY
TO THE ORIGINAL PURCHASER AT RETAIL OF THIS
PRODUCT. THIS LIMITED WARRANTY IS NOT
TRANSFERABLE.
THIS
EXPRESS
LIMITED
WARRANTY.
THE
MANUFACTURER MAKES NO WARRANTY OF
MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS
PRODUCTAND EXPRESSLY EXCLUDES SUCH FROM THIS
LIMITED WARRANTY.
JEG’S HIGH PERFORMANCE warrants this battery charger
for one year from date of purchase at retail against defective
material or workmanship. If such should occur, the unit will
be repaired or replaced at the option of the manufacturer. It is
the obligation of the purchaser to forward the unit together
with proof of purchase, transportation and/or mailing charges
prepaid to the manufacturer or its authorized representative.
SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR LENGTH OF IMPLIED WARRANTY SO THE
ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY
TO YOU.
This limited warranty is void if the product is misused,
subjected to careless handling, or repaired by anyone other
than the manufacturer or its authorized representative.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
The manufacturer makes no warranty other than this limited
warranty and expressly excludes any implied warranty
including any warranty for consequential damages.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|