INFRARED WOODEN SAUNA ROOM INSTRUCTION MANUAL
Read all instructions carefully before using the wooden infrared sauna room
IG-520 BH
P R E C A U T I O N S F O R U S E . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
PA R T S N A M E S . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
REA D B E F O RE I N S TA L L AT I O N .. . ... ... . .. .. . ... . .. . .. .. . ... . .. .. . .. . ... . .. .. . .. 3
INSTALLATION OF SAUNA ROOM BODY ..............................................4-7
CONTROL PANEL INSTRUCTION ...............................................8
C O L O R L I G H T T H E R A P Y S Y S T E M . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
WARNINGS AND SUGGESTIONS FOR USE..........................................10
C L E A N I N G A N D S TO R A G E .. . .. . . .. . . . . . . . . . .. . . . .. . . .. . ... . . .. . . .. . . .. . . .. . . . . . 1 0
S P E C I F I C AT I O N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 0
S A U N A C I R C U I T D I A G R A M . . . . . . .. . . . .. . .. . . .. . . . .. . .. . . . . . . . .. . .. . . .. . . . .. . .. . 11
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS NAMES
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
READ BEFORE INSTALLATION:
※ Each panel is heavy. Be careful to avoid injury when installing, especially the top panel.
※ Two adults are required for the installation of sauna room.
※ There is a “+” button or a “–” button at the sides of each panel, which will be
installed
correspondently with one “+” to one “–” in following way when installing: The panel with
“+”button should be lifted up about 4 inches (10cm) higher than the panel with the “-“ button
(Refer to Picture 1); place the “+” panel against the panel with “–”button (Refer to Picture
2),and then slide down the panel with “+”button until the two panels are equal in height
(Refer to Picture 3). If they are not equal in height or there is an obvious gap between the
two panels, that means they are not properly attached, and you should try again.
The panels should be installed in the following order:
※ Floor Panel→Back Panel→Left Side Panel→Right Side Panel→Bench Support Panel
→Bench Surface Panel→Front Panel→Top Panel
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION OF SAUNA ROOM BODY
1. Place the floor panel in the desired location on a level surface (Note: The floor panel must be
level before installing wall and ceiling panels. If the surface is not level you may need to
shim the bottom panel to get level.)
※ Make sure lines/grooves of the flooring of the floor panel are parallel with the front wall.
2. Place back panel in the slot of floor panel.
3. Place the left side panel in the slot of floor panel.
4. Place the right side panel in the slot of floor panel.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
5. Place the Bench Support panel first and then place the Bench surface panel into the
sauna room.
※ On larger sauna rooms with more than one bench, rotate the wooden bench supports
away from the side walls.
※ Slide the Bench Support Panel down the wooden supports with the heater facing out.
※ Make sure the two side slots of the Bench Support Panel slide completely into the
corresponding grooves of the wooden supports . (Refer to picture 1)
※ Connect the power connector from the back of Bench Support Panel to the floor
Panel. Ensure the connection is completely fastened(Refer to picture 2)
※ Place the Bench Surface Panel on the Bench Support Panel and slide toward the Back
Wall until half. (Refer to picture 3)
※ Connect the power connector from the back of Bench Support Panel to the Right
Wall Panel. Ensure the connection is completely fastened; attach cover with the
provided screws. (Refer to picture 4)
※ Connect the power connector from the back of Bench Support Panel to the left
Wall Panel. Ensure the connection is completely fastened; attach cover with the
provided screws. (Refer to picture 5)
※
Place the Bench Surface Panel on the Bench Support Panel and slide toward the Back
Wall until flush to the Back Wall.
Picture 1
Picture 2
Picture 3
Picture4-5
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
6. Place the front panel in the slot of floor panel.
7. Place the top panel on the four side panels. Make sure the connection wires from the three side
panels protrude through the corresponding holes of the top panel.
※ Make sure the top panel’s arched side is facing to the front.
※ Make sure the wire is through each hole smoothly and completely.
※ Make sure trim of the top panel fits completely around the four side panels.
8. Make sure each of the lead wires on the top of the left, right, back and front panels is
protruding through the top panel; then plug each of the four lead wires into the four
connectors of the top panel.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING: ELECTRIC SHOCK HAZARD
Do not plug cord into electrical outlet before connecting power cord wires to terminal block.
9. Make sure to connect wires in correct location by matching color to correct screw location:
※ Open cover on top side of ceiling panel to see three unconnected power wires (Picture 1)
※ Insert the green wire into “〒” and tighten the screw (Picture 2)
※ Insert the black wire into “L” and tighten the screw (Picture 3)
※ Insert the white wire into “N” and tighten the screw (Picture 4)
※ Visually inspect to ensure the correct connections by color (Picture 5)
10．The power cord is located at the bottom of the back panel. Simply plug into appropriate
household outlet when ready to use the sauna. Notice the plug type of your sauna room:
Sauna models IG-510 & 520 & 570 have a 15 amp/120-volt plug; Models IG-530 & 540 &
580 have a 20 amp/120-volt plug.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTROL PANEL INSTRUCTION
1. Press “POWER”to switch on or off.
2.“TIME”refers to control of operating time and indicates the amount of time remaining.
※Once power is on, the default amount of operating time is at 45 minutes.
※Press “UP” and “DOWN” to adjust and set time of use; pressing once will increase
or reduce in 5 minute increments. The maximum operating time is 60 minutes.
※After time of use is set, the number will flash for about three seconds.
※After the set “Time” stops flashing , the number indicated will show operating time
remaining.
3. “TEMP” refers to control of the “set temperature” and also indicates the “actual
temperature” inside sauna room.
※ “°C/°F” refer to the switching of “°C” and “°F”.
※Once the control is turned on, the indicated temperature of use defaults to 120 degrees
F (50°C).
※Press“HIGH”or“LOW”to adjust and set temperature in sauna room; pressing once
will increase in one degree increments. The maximum set temperature is 150°F/65°C.
※After temperature of use is set, the number of temperature will flash for about 5
minutes.
※After the numbers of the set temperature stop flashing, the number indicated will show
actual temperature inside sauna room.
4. Press “External Light” to switch on or off.
5. Press “Internal Light” to switch on or off.
6. Press “Bench Heater” to switch on or off.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATING INSTRUCTIONS FOR COLOR LIGHT THERAPY SYSTEM
1. To activate the color light therapy system press “ADJUST” on the sauna control panel.
Upon turning the system on, the color light system will go into an automatically cycling
mode, changing color every 8 seconds:
2. Press “ADJUST” 2X: Light system will glow GREEN
3. Press “ADJUST” 3X: Light system will glow RED
4. Press “ADJUST” 4X: Light system will glow BLUE
5. Press “ADJUST” 5X: Light system will glow YELLOW
6. Press “ADJUST” 6X: Light system will glow TURQUOISE
7. Press “ADJUST 7X: Light system will glow VIOLET
8. Press “ADJUST 8X: Light system will turn OFF
9. Color Light System automatically goes off if Power is turned OFF.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNINGS AND SUGGESTIONS FOR USE
Please read carefully the following warnings, to reduce the risk of burns, fire, electric shock, or
injury to persons:
※Do not put the sauna room in a moist environment.
※Place room on level surface.
※Do not repair the product by yourself. Contact the Saunatec National Customer Service
Center toll-free at 1-888-780-4427, or email at techsupport@saunatec.com
※Do not disassemble the product by yourself except as indicated in the manual.
※Do not spray the heater with water.
※Do not use any sharp tools on or near the heaters (severe damage may result).
※Do not use the product for any other purpose than originally designed and intended.
※Do not directly touch the heater with hands or body for extended periods of time.
※Do not use continuously for more than one hour.
SUGGESTIONS FOR USE
※When enjoying a sauna room bath, it is suggested to turn power on at least 15 minutes
beforehand. After 15 minutes of preheating, the temperature inside the sauna room should
reach about 105 degrees F (40°C) ; at this stage most people find the sauna a comfortable
temperature to begin the sauna bath. The temperature will continue to rise to the set
temperature.
※If it feels too hot during use, adjust the temperature down, open the vent or open the door
for fresh air.
CLEANING
Clean the outside and inside with a damp cloth, or clean with a small amount of hand-soap
mixed with warm water if necessary. Do not use benzene, alcohol, or strong cleaning chemicals
on sauna.
Note: Some chemicals can damage wood material and the protection layer that is on the outside
wood surface.
STORAGE
Do not store product in a moist environment or in direct sunlight.
SPECIFICATION
Product Name
Product No.
Product Size
Weight
Infrared Wooden Sauna Room
IG-520
122×111×195(H)cm (48＂×44＂×77＂)
ca. 134kg ( 295lbs.)
Power Supply
AC120V
Power Consumption 1750W
□Canadian Hemlock □Canadian Red Cedar
Wooden Material
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
IG-520-BH-2
5/25/07
Download from Www.Somanuals.com. All Manuals Search And Download.
|
Radio Shack Battery Charger 23 437 User Guide
Radio Shack Camcorder 3Com Bigpicture User Guide
Radio Shack Speaker System 12 1738 User Guide
Revolabs Headphones HDX 9001 User Guide
Roberts Radio Clock CR9919 User Guide
Rosewill Mouse RGM 300 User Guide
Russell Hobbs Cooktop RHGC1 User Guide
Saitek Games X45 User Guide
Samsung DVD Player YP U6 User Guide
Senco Nail Gun 700XL User Guide