Sanyo Camera Lens LNS S03 User Guide

LCD PROJECTOR LENS  
MODEL NO. LNS-S03  
LENS REPLACEMENT  
AND INSTALLATION PROCEDURES  
NOTES ON REPLACEMENT AND INSTALLATION  
The procedures and the needed pars for lens installation depend on the type of  
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be  
sure to refer to the Installations corresponding with your projector.  
When installing or replacing the lens, make sure the Lens Model No. matches with  
your projector. Refer to the catalog, or contact your sales dealer for the proper Lens  
Model No.  
TYPE OF THE CABINET AND INSTALLATION PROCEDURES  
Refer to the Installation procedure corresponding to your projector and install the lens  
correctly. (See the chart below.)  
Type of the Cabinet (1) See Page 2  
Type of the Cabinet (2) See Page 6  
For use the other models (other than above cabinet), contact your sales dealer.  
1AA6P1P2987-- (IDAJ)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
{Type (1) Cabinet}  
LENS REPLACEMENT AND INSTALLATION PROCEDURE  
Remove Lower Lens Cover. Remove 2 Screws A.  
B
1
Push part B and pull Lower Lens Cover down.  
(See Fig. 1.)  
A
LOWER LENS  
COVER  
Fig-1  
C
Remove 4 Screws C. Pull Upper Lens Cover  
toward front and remove. (See Fig. 2.)  
2
3
UPPER LENS  
COVER  
C
Fig-2  
UPPER LENS  
COVER  
Remove 2 Scres D and Cover Plate on the back of  
Upper Lens Cover. (See Fig. 3.)  
COVER PLATE  
D
Fig-3  
-2-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Replace Lens Cap on the rear (mounting side) of Projection Lens and mount the lens on Lens  
Mouting Bracket with 4 Screws. To mount the lens with Lens Motor on the right. (See Fig. 4.)  
4
GUIDE PIN  
LENS MOUNTING  
BLACKET  
LOCATE MOTOR  
ON RIGHT SIDE  
DRIVER  
IN THE LENS  
Fig-4  
Part No. (610 275 6029)  
Connect Lens Motor Lead to the connector  
"K96T" on the circuit board under the lens.  
5
K96T CON-  
NECTOR  
LENS MOTOR LEAD  
Fig-5  
-3-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Use a Light-Block Sheet (provided with projector) corresponding with lens. (Refer to the Type No.  
below.) Set Light-Block Sheet through the lens.  
6
Make sure the shape of Light-Block Sheet and be sure to set them as shown in the Fig. 6.  
NOTE:  
Be sure to set a Light-Block Sheet as shown in Fig-6.  
Make sure the mark (TOP and BACK) on Light-Block Sheet and set them properly.  
Use light-block sheet Type No.  
TYPE FD1 (PART No. 610 290 9258)  
Fig-6  
LIGHT BLOCK SHEET  
Make sure the sheet figure and put  
on proper position.  
-4-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Replace Upper Lens Cover. Slide Light-Block Sheet into the guide of Upper Lens Cover and set  
them in front of the flap. (See Fig. 7.) Fix Upper Lens Cover with 4 Screws C. (See Fig. 2.)  
7
8
9
Replace Lower Lens Cover. Slide Light-Block Sheet into the guide of Lower Lens Cover and set  
them in front of the flap. (See Fig. 7.) Fix Lower Lens Cover with 2 Screws A. (See Fig. 1.)  
Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheet. If  
Light-Block Sheet interfere with those operations, check Light-Block Sheet is set properly.  
UPPER LENS  
COVER  
Slide upper both side of LIGHT BLOCK  
1
2
SHEET into between 1 and  
.
FLAP  
Slide into front  
of the flap.  
GUIDE  
2
LIGHT-BLOCK  
SHEET  
LOWER LENS  
COVER  
FLAP  
Fig-7  
-5-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
{Type (2) Cabinet}  
LENS REPLACEMENT AND INSTALLATION PROCEDURE  
A
Remove Lens Cover. Remove 2 Screws A. Push  
1
part B and pull Upper Lens Cover up.  
(See Fig. 1.)  
UPPER LENS  
COVER  
B
Fig-1  
C
Remove 4 Screws C. Pull Lower Lens Cover  
toward front and remove. (See Fig. 2.)  
2
3
LOWER LENS  
COVER  
C
Fig-2  
D
Remove 2 Screws D and Cover Plate on the  
back of Upper Lens Cover. (See Fig. 3.)  
UPPER LENS  
COVER  
COVER PLATE  
Fig-3  
-6-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Replace Lens Cap on the rear (mounting side) of Projection Lens and mount the lens on Lens  
Mouting Bracket with 4 Screws. To mount the lens with Lens Motor on the right. (See Fig. 4.)  
4
GUIDE PIN  
LENS MOUNTING  
BLACKET  
DRIVER  
IN THE LENS  
LOCATE MOTOR  
ON RIGHT SIDE  
Part No. (610 275 6029)  
Fig-4  
Connect Lens Motor Lead to the connector  
"K96T" on the circuit board under the lens. Fix  
Lens Motor Lead with the lead holder on the cir-  
cuit board.  
5
LEAD  
HOLDER  
K96T  
CONNECTOR  
LENS MOTOR LEAD  
Fig-5  
-7-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Use 2 Light-Block Sheets (provided with projector) corresponding with lens. (Refer to the Type No.  
below.) Set 2 Light-Block Sheets through the lens.  
6
Make sure the shape of Light-Block Sheets and be sure to set them as shown in the Fig. 6.  
NOTE:  
Be sure to set each Light-Block Sheets as shown in Fig-6.  
Make sure the mark (TOP and BACK) on Light-Block Sheets and set them properly.  
Use light-block sheets Type No.  
TYPE FC1 (PART No. 610 284 2500)  
TYPE FC2 (PART No. 610 284 2494)  
Fig-6  
LIGHT BLOCK SHEETS  
Make sure the sheets figure and  
put on proper position.  
-8-  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Replace Lower Lens Cover. Slide Light-Block Sheets into the guide of Lower Lens Cover and set  
them in front of the flap. (See Fig. 7.) Fix Lower Lens Cover with 4 Screws C. (See Fig. 2.)  
7
8
9
Replace Upper Lens Cover. Slide Light-Block Sheets into the guide of Upper Lens Cover and set  
them in front of the flap. (See Fig. 7.) Fix Upper Lens Cover with 2 Screws A. (See Fig. 1.)  
Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheets. If  
Light-Block Sheets interfere with those operations, check Light-Block Sheets are set properly.  
Slide upper both side of LIGHT BLOCK  
2
SHEETS into between 1 and  
CABINET  
.
1
Slide into front  
of the flap.  
FLAP  
UPPER LNES  
COVER  
GUIDE  
2
LIGHT-BLOCK  
SHEETS  
Slide into front  
of the flap.  
FLAP  
LOWER LENS  
COVER  
Fig-7  
-9-  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Radio Shack Network Cables 273 1687 User Guide
RCA Flat Panel Television J32L637 User Guide
RCA Satellite TV System 15407690 User Guide
Ryobi Drill D45C User Guide
Salton Ultrasonic Jewelry Cleaner JW10 User Guide
Samsung DVD Player DVD V6700 User Guide
Scientific Atlanta Network Card DPC2203 User Guide
Sears Cordless Drill 31511485 User Guide
Sears Lawn Mower 91725004 User Guide
Sears Water Heater 153336331 User Guide