Warning/Caution
Introduction
to the
Safety Precautions
The following are basic precautions to ensure user safety
Connecting the Cables
DVD Writer
Super-Writemaster
SH-S223F(TS-H653F)
Warning: To warn the user that failure to comply with the instructions may result in
serious injury or death.
Caution:
To caution the user that failure to comply with the instructions may result in
damage to property.
•
Design and specifications are subject to change without prior notice.
and reduce the risk of property damage.
Users Guide - ENGLISH
Connecting the Cables
Disc compartment
Eject Button
When you install the drive
FCC Compliance
Place the drive on a level
surface.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
•
Avoid low- or high-temperature
environments.
•
Avoid high-humidity environments.
•
Do not place the drive in
direct sunlight.
•
Failure to do so may cause the
device to fall onto a hard surface,
resulting in damage or malfunction.
Front
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be deter-mined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
S-ATA Data cable
S-ATA Power cable
• Re-orient or relocate the receiving antenna.
LED
Emergency eject hole
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
If the compartment does not open
when you press the Eject button,
power off the computer, insert a pin
or unfolded paper clip in the hole
and push firmlhy)
which the receiver is connected.
While operating
• Consult the dealer or an experienced radio/TV technician for help.
Do not move the drive while in operation and
do not attempt to open the disc tray byforce.
Make sure to close all working programs before
attempting to open the tray and always use the
open/close button.
Do not use cracked, distorted or
damaged discs.
Do not drop the drive, and pro-
tect it fromsevere shocks.
Handle with caution to prevent
damage from external shock.
CAUTION
Change or modifications not expressly approved by the manufacturer responsible for
Connecting the S-ATA Power cable
compliance could void the user ’s authority to operate the equipment.
1
2
•
It can damage the drive or cause
it to malfunction.
•
The S-ATA Power cable from the internal power unit of your computer must
be connected to the power terminal the rear of the DVD Writer drive.
LASER STANDARD
IEC 60825-1 :1993 +A1 :1997 +A2 :2001
WEEE
Connecting the S-ATA Data cable
Correct Disposal of This Product (Waste Electrical &Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)
S-ATA Power Port
S-ATA Data Port
In particular, a disc with a crack on the
inner tracks may break while in use.
Do not insert a pin into the emergency open-
ing while in operation.
This marking shown on the product or its literature,indicates that it should not be disposed with
other household wastes at the end of its working life.To prevent possible harm to the
environment or human health from uncontrolled waste disposal,please separate this from other
types of wastes and recycle it responsibly to promote the sustainable reuse of material
resources.
S-ATA Data Port
S-ATA Power Port
Rear
Other
1. Check to see that the disc does not have a crack before use.
If the disc has a crack (especially around the center hole),
it is recommended that you make a copy immediately and
use the copy instead.
When a cracked disc is used continuously,the size of the
crack is likely to grow and it will eventually result in irreparable
damage to the disc.
Household users should contact either the retailer where they purchased this product,or their
local government office,for details of where and how they can take this item for environmentally
safe recycling.
Do not disassemble, attempt to repair
or modify the device without express
approval as directed in the manual.
•
Never allow food particles or
foreign substances to enter the
drive casing.
•
To protect against the risk of
fire, do ot spill such liquids as
alcohol and benzene on the
drive.
Business users should contact their supplier and check the terms and conditions of the purchase
contract.This product should not be mixed with other commercial wastes for disposal.
Samsung Eco-mark
The Samsung’s own Eco mark helps consumers to easily understand that
Samsung develops eco-friendly products. This mark represents Samsung’s
continuous effort to develop eco-friendly products.
•
To reduce the risk of damage,
electric shock, and fire.
•
Accessories
2. Do not use low quality discs (i.e., illegal products, scratched or
damaged discs).
User Guide, Screw 4ea
• RoHS
(Restriction of the use of certain hazardous substances in electrical and electronic equipment)
The RoHS, the environment regulation announced by European Union, restricts the use
of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in products put on
the market in The European Union after July 1, 2006.
The type of accessories varies depending on a product model.
and some accessories described herein are subject to change without notice.
•
Any change or modification not expressly approved by designated qualified personnel could
void your authority to operate this device.
Important to read and understand
at all times
Do not disassemble
BG68-01622A REV.00
3
4
1
2
Solving Technical Problems
Using the Drive/Storing and Cleaning
Your Discs
Technical Specifications
Installing the Drive
•
The friction noise generated during SPIN-UP and STOP is caused by the
Automatic Ball Balancing System(ABS) and is not a malfunction.
When using one S-ATA cable
System Requirements
S-ATA supported PC
SH-S223F(TS-H653F)
Using the DVD Writer
Category
DVD Writer
(The compatible motherboard list can be found from the website)
256Mbytes or above
Windows 2000/XP/Vista
DVD : DVD-R, DVD-RW, DVD-RW (Dual), DVD+R, DVD+RW, DVD-
•
•
•
See if the PC on.
Push the power button and boot the computer.
The tray won't open.
Drive
1
ROM, DVD-Video, DVD+R(DUAL) , DVD-R(DUAL), DVD-RAM
Make sure the power cable within the PC is connected properly.
If the tray still won't open with the power on, turn the power off
and insert a pin(paper clip) into the emergency hole to open.
C D : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) CD-MIDI, CD-TEXT,
CD-ROM XA, Mixed Mode CD ‚ CD-I, CD-I Bridge (Photo-CD, Video-
CD), Multisession CD(Photo-CD, CD-EXTRA, Portforio)
Usable Discs
After booting the computer, open the disc
DISC
Installing the DVD Writer
2
partment by pressing the Eject button.
•
Make sure the disc has been inserted properly.
The tray won't close.
How to install the DVD Writer on your PC. First, remove the cover; con-
nect the cable to the DVD Writer and then to the PC.
Disc Diameter
Interface Port
Burst Transfer Rate
CD-ROM
4.72 Inch or 3.15 Inch (120mm or 80mm)
S-ATA
•
•
See if the drive is connected properly to the PC.
See if the device drive program has been installed properly.
The drive is not working properly.
Insert the disc (CD) with the label on the disc
3
Interface
Support
facing upwards and close the disc compartment
S-ATA 1.5Gbps
110ms (Random)
130ms (Random)
•
•
See if the device drive program has been installed properly.
Can be an OS problem. Try reinstalling the Windows OS program.
The Window OS can't detect the
drive.
by pressing the Eject button. The indicator light
comes on.
Play the disc (CD).
If necessary, attach a horizontal bracket
MainBoard
Hard Drive
1
Access time
(Random)
to both sides of the drive.
DVD-ROM
•
You can purchase these accessories separately
from your computer dealer.
•
•
See if the system detects the drive.
Make sure you use the types of discs that are supported
by the drive.
See if the on/off light turns into green.
Make sure you inserted the disc with the label facing up.
Make sure you are using the right program for disc play-
back.
The system won't read the disc.
Media type
DVD+R
Write
Read
4
CAV22X
ZCLV 8X
CAV16X
CAV12X
CAV22X
CLV6X
CAV16X
CAV 12X
CAV 12X
CAV 12X
CAV16X
CAV12X
(Screws for use: M3 X 6 X 4)
Playing CD-DA/Audio CDs
DVD+RW
•
•
•
When you have one ODD and the other ODD products.
•
Run the CD player program supplied with the sound card or play the
Windows Media Player.
DVD+R DUAL
DVD-R DUAL
DVD-R
Playing Video CDs
•
•
•
See if the disc is clean.
S-ATA 1
S-ATA 2
See if any congealing has occurred.
Make sure the region code of the drive matches the disc
number.
•
•
Follow the instructions provided with the disc.
A video card or MPEG software and a sound card need to be installed to view video CDs.
DVD-RW
Data Transfer
Speed(MAX)
DVD-ROM(Single)
DVD-ROM(Dual)
DVD-RAM
-
CAV 16X
CAV12X
PCAV12X
CAV48X
CAV40X
CAV40X
CAV40X
CAV40X
Remove the plate from a free expansion slot and install the
DVD Writer , as shown in the illustration.
•
If the drive is vertically installed, you cannot use an 8 cm Mini Disc
because the disc is movable.
2
-
You can confirm the use of software at the site of our customer support.
PCAV12X
-
•
If you have no free expansion slot, install the drive in place of the
diskette drive.
CD-ROM
Storing Your Discs
CD-R
PCAV48X
ZCLV32X
CLV10X
CLV 4X
- See “ Customer support > Download center > User’s manual(PDF) > Software ”.
- See “ Information > Movie manual > Recording software ”.
•
Make sure to use the standardized screws supplied (M3X6).
•
•
Do not place a disc in direct sunlight.
Store a disc vertically in a well-ventilated and
stable location.
Do not write or attach a label on a disc.
Do not drop a disc or place heavy objects on it.
US-RW
HS-RW
CD-RW
MainBoard
- To use screws other than M3X6 may result in malfunction.
Hard Drive
•
•
2MB
Buffer Memory
Drive Installation
Horizontal / vertical
Temperature
Humidity
41°F ~ 122°F (5°C ~ 50°C)
20 ~ 80% (RH)
Operating
Environment
Cleaning Your Discs
DVD
Plate
5.34 X 1.65 X 6.69 Inch (148.2 X 42 X 170mm)
750 g
Writer
Horizontal
Bracket
Size(Width x Height x Length)
Weight
•
Do not touch the surface
of a disc; hold it by the
edges.
•
To clean a disc, polish lightly
from the inside of the disc to the
outside with a soft cotton cloth.
•
The disc may not function properly if there are fingerprints, foreign substances or
dust on the disc surface.
Download from Www.Somanuals.com7. All Manuals Search And Download.
8
9
6
5
|