R
RUB
TECH
Fast EthernetSwitch
L2 Managed Switch
Networking & Communications
ES-2310C
ES-2310C:
8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media
Benefits
QoS with four priority queues
Key Features
Standard compliance
The QoS(Quality Of Service) feature provides four internal queues to support
four different classifications of traffic. High priority packet streams experience
less delay inside the switch, which supports lower latency for certain delay-
sensitive traffic. The ES-2310C can classify the packet as one of the four
priorities according to vip port, 802.1p priority tag, DiffServ and/or IP TOS.
The QoS operate at full wire speed. The actual scheduling at each egress
port can be based upon a strict priority, weighted round robin or a mix of both.
Port Mirroring
---IEEE 802.3 10Base-T
---IEEE 802.3u 100Base-TX
---IEEE 802.3ab 1000Base-TX
---IEEE 802.3z 1000Base-X Ethernet
---IEEE 802.3x flow control capability
---ANSI/IEEE 802.3 auto-negotiation
---IEEE 802.1q VLAN
RoHS Compliance
This mechanism helps track network errors or abnormal packet transmission
without interrupting the flow of data. Allow ingress traffic to be monitored by a
single port that is defined as mirror capture port. The mirror capture port can
be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but
can create congestion at the mirror capture port.
Subscriber Interface
---8 are 10/100Mbps and 2 Gigabit
Ethernet ports.
---Port 9,10 are Gigabit TP/SFP Fiber
auto sense
Q-in-Q VLAN for performance & security
---Auto-Negotiation and Auto-MDIX
---Back pressure flow control for half
duplex.
The VLAN feature in the switch offers the benefits of both security and
performance. VLAN is used to isolate traffic between different users and thus
provides better security. Limiting the broadcast traffic to within the same VLAN
broadcast domain also enhances performance. Q-in-Q, the use of double
VLAN tags is an efficient method for enabling Subscriber Aggregation. This is
very useful in the MAN.
---IEEE 802.3x compliant for full duplex
---Connector: 8 RJ-45 and 2 dual media,
RJ-45/SFP
Performance
Isolated Group, provides protection for certain ports
Switching capacity:
The isolated group feature allows certain ports to be designated as protected.
All other ports are non-isolated. Traffic between isolated group members is
blocked. Traffic can only be sent from isolated group to non-isolated group.
Mac-based 802.ad LACP with automatic link fail-over
---Non-blocking switch fabric supports up
to 8 FE+2GbE ports
---8 K MAC addresses
---256K packet buffer and 128K control
memory
Dynamic fail-over means packets will not get assigned to any trunk member
port that has failed. If one of the ports were to fail, traffic will automatically get
distributed to the remaining active ports.
VSM(Virtual Stacking Management)
---Supports 16 devices stacking
---Multiple switches can be managed via
one IP address, just like software
stacking
802.1x Access Control improves network security
802.1x features enable user authentication for each network access attempt.
Port security features allow you to limit the number of MAC addresses per
port in order to control the number of stations for each port. Static MAC
addresses can be defined for each port to ensure only registered machines
are allowed to access. By enabling both of these features, you can establish
an access mechanism based on user and machine identities, as well as
control the number of access stations.
---Low cost and easily to establish
network environment, not extra
hardware require
---Not center on the physical location of
wiring closets
802.1d Compatible & 802.1w Rapid Spanning Tree
VLAN
For mission critical environments with multiple switches supporting STP, you
can configure the switches with a redundant backup bridge path, so
transmission and reception of packets can be guaranteed in event of any
fail-over switch on the network.
---Supports SVL/IVL configuration to
meet your VLAN requirement
---Port-base VLAN
---IEEE802.1q tag-base VLAN, 4094
max, up to 256 active VLANs including
static plus dynamic entry
---IEEE802.1q tag-base VLAN
2 dual media ports for flexible fiber connection
Port 9, 10 dual media ports are provided for flexible fiber connection. You can
select to install optional transceiver modules in these slots for short, medium
Download from Www.Somanuals.com. All Manuals Search And Download.
R
RUB
TECH
Fast EthernetSwitch
L2 Managed Switch
Networking & Communications
---Static mac, to limit which mac
addresses can pass through or not
---Mac addresses learning limit, to set up
the maximum amount of mac that
each port can learn
Snmpv1,v2c Network Management
RFC 1213 MIB (MIB-II)
Interface MIB
Ordering Information
ES-2310C:
8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media
Optional SFP Fiber Module (See note below)
SFP.LC
1000Base-SX GE SFPMulti-Mode Fiber Module 850nm
1000Base-SX GE SFPFiber Module, LC Multi-Mode
1310nm 2km
SFP.LC.M2
Address Translation MIB
IP MIB
SFP.LC.S10 1000Base-LX GE SFPSingle-Mode 10Km Fiber Module
1310nm
ICMP MIB
SFP.LC.S30 1000Base-LX GE SFPSingle-Mode 30Km Fiber Module
TCP MIB
1310nm
UDP MIB
SFP.L5.S50
1000Base-LX GE SFPSingle-Mode 50Km Fiber Module
1550nm
SNMP MIB
RFC 1757 RMON MIB
Statistics Group 1
SFP.BL5.S10 1000Base-LX GE SFPBiDi_LC 10Km Module Single
Fiber 1550nm, Type 1
History Group 2
SFP.BL3.S10 1000Base-LX GE SFPBiDi_LC 10Km Module Single
Fiber 1310nm, Type 2
Alarm Group 3
Event Group 9
SFP.BL5.S20 1000Base-LX GE SFPBiDi_LC 20Km Module Single
Fiber 1550nm, Type 1
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB
SFP.BL3.S20 1000Base-LX GE SFPBiDi_LC 20Km Module Single
Fiber 1310nm, Type 2
Note:
Overview
We recommend the SFP transceiver from the following vendors:
1. Ruby Tech Corporation
2. Agilient Technologies
3. AVAGO Technologies
4. Finisar Corporation
ES-2310C is a Managed Fast Ethernet
switch that supports SNMP, Web UI and
CLI management interface and with 8 10/
100Base-TX (RJ-45 connectors) and 2
Gigabit dual media (RJ-45/SFP or RJ-45/
GBIC) ports. It is a standard switch that
meets all IEEE 802.3/u/x/z Gigabit, Fast
Ethernet specifications. In addition, the
switch implements the QoS (Quality of
Service), VLAN, Mac Filtering Policy, Port
Mirror, VLAN and full L2 protocols. It has
a rich feature set suitable for streaming
VoIP, video, and data traffics for multimedia
applications.
In this switch, Port 9, 10 support two types
of media --- TP and SFP/GBIC Fiber (LC,
BiDi-SC....); both ports support 10/100/
1000Mbps TP or 1000Mbps SFP/GBIC
Fiber with auto-detected function.
1000Mbps SFP/GBIC Fiber transceiver
is used for high-speed connection
expansion.
Ruby Tech Corp.
3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan
TEL:886-2-2785-3961 FAX:886-2-2786-3012
http://www.rubytech.com.tw
E-mail [email protected]
Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.
Download from Www.Somanuals.com. All Manuals Search And Download.
Copyright
c
2008 Ruby Tech Corp. All rights reserved.
2008-07.30 Version A
|