Rimage AutoEverest AutoPrinter™
Setup and Installation Guide
2
Prepare the Everest
Voltage Switch
a. Unpack the Everest printer.
Refer to the label on the
Everest printer box.
Before you begin:
This document is intended for people who are familiar with hardware setup, software
installation, and Windows operating systems.
b. Follow the instructions on the
instruction card on the rear
of the printer.
i.
Set the AC voltage
switch.
If you do not understand the procedures in this document, ask your computer
technician for help.
Instruction Card
Shipping Screw
ii. Move the shipping
screw to the storage
position.
Shipping Screw
Storage Position
This document describes how to set up your Rimage AutoEverest AutoPrinter. If you
are using the Everest printer as a standalone printer or with an autoloader, refer to the
printer or autoloader’s setup and installation instructions.
Documents referenced in this procedure shipped with your product and are also
User Manuals tab.
Side Cover Latches
c. Open the Everest printer.
i.
Press the two side cover latches.
- Important!
ii. Lower the side cover.
•
•
Read all setup instructions thoroughly before you begin.
Save all packing boxes and packing materials for your AutoPrinter and
Everest printer.
ꢀ Note: Your product may not look exactly like the product pictured.
# Required tools: Scissors or side cutters
d. Open latches 1, 2, and 3 as indicated
by the arrows.
1 Prepare the AutoPrinter
a. Cut the plastic tie wraps (Qty. 2) from
Latch 1
Latch 2
Latch 3
the lift arm.
n Caution! Do not cut the belt or
Tie
Wraps
the cable!
e. Remove the plastic packing
pieces (Qty. 2) from inside the
printer.
b. Remove the shipping foam inserted
above the carousel.
Shipping
Foam
f. Install the print ribbon and
retransfer ribbon. Refer to
the instruction label on the side
cover, or refer to the Everest
Printer User Guide.
Plastic Packing Pieces
110660-001_F
Copyright © 2009 Rimage Corporation
Page 1
Download from Www.Somanuals.com. All Manuals Search And Download.
|