PowerVent
Commercial Gas Water Heaters
Available in 75 Gallon Tank-Type Models
ꢀ
75,000 BTU/Hr.
The Rheem-Ruud PowerVent commercial water heater is specifically designed
to fill the need wherever medium quantities of hot water are required. Typical
applications include large residences, small restaurants, apartments up to
6 units and small office buildings.
Construction Features:
• Long life tank design – proprietary
steel formulation with a unique coat
of high temperature porcelain
enamel to maximize corrosion
resistance resulting in a superior
tank design.
Environmentally Friendly Burner
Low NOx design for low nitrous
oxide emissions
•
High Altitude Compliant
Certified for applications
up to 7,700 feet above sea level
•
Guardian System™
Longer Life
Air/fuel shut-off
system offers
•
Patented magnesium anode rod
design incorporates a special
resistor that protects the tank
from corrosion
•
double protection
Maintenance free –
no filter to clean
•
Provides longer tank life than using
standard magnesium anode rods
•
Flammable Vapor
Detection Sensor
75 Gallon
Capacity
Additional Features
Protective control system
that disables the heater in the
presence of flammable
vapor accumulation
•
Durable silicon nitride ignitor (HSI)
Standard 110 volt electrical
connection
•
•
Vents Up To
34 Feet Using
3" PVC Pipe
Exceeds National Appliance Energy
Conservation Act (NAECA) and
ASHRAE requirements
•
Flexible Venting Options
Long venting lengths up to 100 feet
PVC, ABS, or CPVC vent pipe
options
•
And Up To
95 Feet Using
4" PVC Pipe
•
• Durable brass drain valve
Vertical or horizontal termination
• Temperature and pressure
relief valve –
AGA/ASME rated and factory
installed
•
New Quiet Blower
Less noise than ever before
•
Self-Diagnostic System
Integrated self-diagnostic system
control takes the guess work away
•
Certifications and Ratings:
• Efficiency – these models have been tested according to DOE test procedures,
and meet or exceed thermal efficiency and standby loss requirements of current
ASHRAE standards (Part of the Federally mandated Energy Policy Act (EPact)
and NRCAN). Also exceeds energy efficiency codes of all states including
California Energy Commission (CEC).
• Safety and construction – these products are design certified by
CSA Laboratories: a) To meet all safety and construction requirements of
ANSI Z21.10.1. b) As an automatic storage water heater. c) For operation of
combustible floors, in alcove, and closet installations. d) For combination water
heating and space heating applications. All models are North Carolina Code
compliant. Certified for a 150 PSI Maximum Working Pressure.
Continued on reverse.
Download from Www.Somanuals.com. All Manuals Search And Download.
|