Revolabs FusionTM Microphone System — Sony XG-80 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Sony XG-80 video codec.
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Fusion 4 or 8 channel Microphone System
2. Sony XG-80 video codec
3. QTY 1 Female XLR—1/8” mono male cable* (i.e. Calrad 10-144)
4. QTY 1 RCA male — RCA male cable
5. Amplified Speakers
* Optional Item
Download from Www.Somanuals.com. All Manuals Search And Download.
Configuring the Sony XG-80 Video Codec
1. Push the TOOLS button on the remote control
2. Select SETUP
3. Select AUDIO 1
4. Select AUDIO INPUT as MIC
5. Verify that Mic (A1/A3) has a checkmark
6. Turn ECHO CANCELLER to OFF
7. Verify INPUT as MONAURAL
8. Increase Sony volume level on remote to maximum
NOTE: You must use your Fusion remote control to control the room volume
for both the audio and video conference calls. Adjusting the volume in the
video codec will cause echo.
Download from Www.Somanuals.com. All Manuals Search And Download.
|