Remington Electric Shaver TA 4570 User Guide

Use this shaver only for its intended use as  
described in this manual. Do not use attach-  
ments not recommended by the manufacturer.  
IMPORTANT SAFETY  
INSTRUCTIONS  
®
Keep the cord away from heated surfaces.  
Never operate this shaver if it has a damaged  
cord or if it is not working properly, if it has  
been dropped or damaged, or dropped into  
water. Return the shaver to a service  
center for examination and repair.  
Never drop or insert any object into any  
opening.  
Do not use outdoors or operate where aerosol  
(spray) products are being used or where  
oxygen is being administered.  
When using an electric shaver, basic precautions  
should always be observed, including the following.  
Read all instructions before using this shaver.  
How to get a great shave  
from your Remington®  
MicroScreen® 3 Shaver  
Thank you for buying this premium  
shaver from Remington®.  
DANGER  
To reduce the risk of electric shock:  
Inside you'll find tips on using and  
caring for your shaver to get the  
best shave possible.  
Do not reach for a shaver that has fallen into  
water. Unplug immediately.  
Do not use while bathing or in a shower.  
Do not place or store shaver where it can fall or  
be pulled into a tub or sink. Do not place in or  
drop into water or other liquid.  
Except when charging, always unplug this  
shaver from the electrical outlet immediately  
after using.  
Do not use this shaver with a damaged or bro-  
ken cutter or head, as facial injury may occur.  
Always attach plug to shaver, then to outlet.  
To disconnect, turn all controls to “Off,” then  
remove plug from outlet, then detach power  
cord from the shaver for storage.  
Always store your shaver and cord in a  
moisture-free area. Make sure your cord is  
disconnected from the shaver.  
Unplug this shaver before cleaning.  
“Household Use Only”.  
WARNING  
To reduce the risk of burns, fire, electric shock, or  
injury to persons:  
A shaver should never be left unattended when  
plugged in, except when charging your  
rechargeable shaver.  
Close supervision is necessary when this  
shaver is used by, on, or near children  
or invalids.  
SAVE THESE  
INSTRUCTIONS  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Charging: GREEN LED appears when shaver is plugged in and  
charging.  
Every six months, lubricate the trimmer  
teeth by applying a drop of light machine oil  
one-third and two-thirds of the way along  
the blade. Using your finger tip, spread the  
oil along the teeth, and run the trimmer for  
a few seconds.  
Cordless: When the shaver is operating from the battery in a fully charged  
state, the LED will appear GREEN. The LED will gradually change to  
AMBER as the battery is depleted. When approximately two shaves  
remain, the LED will change from AMBER to RED.  
Removing the Headguard  
Before operating your MicroScreen®  
3 Shaver, remove the headguard,  
which protects the foils and cutter  
assembly. It is important to remove  
the headguard correctly to avoid  
damaging the clips that hold it  
firmly to the shaver.  
Troubleshooting  
If your TA-4570/5570 shaver battery is completely discharged or the  
shaver has not been used for an extended period of time, the shaver  
may not start when operated using the cord. If this condition occurs,  
charge the shaver for approximately five minutes before shaving.  
Replacing Foils and Cutters  
Because they are subject to daily use, the cutters and foils of  
your Remington® MicroScreen® 3 Shaver will wear and eventually  
require replacement to maintain a close, comfortable shave.  
Depending on your shaving technique and habits, the foils will  
usually last six months; the cutters, one year. Some signs that  
your foils and cutters need replacing are:  
Press lightly on the top of  
the headguard.  
Your TA-4570/5570 cord/cordless shaver should not be used  
Lift the lower rear edge.  
Pull the headguard away from the shaver.  
strictly as a cord-operated shaver, as continued cord only use will  
result in reduction of battery life.  
In order to preserve the life of the batteries, they should be fully  
discharged every six months and then fully charged for 24 hours.  
Cordless Operation  
Irritation. As foils get worn, you may notice your skin feeling  
more sensitive after a shave, particularly when you apply after-  
shave.  
Pulling. As cutters wear, your shave may not feel as close,  
and you may feel your shaver is pulling at your whiskers.  
Wear-through. You may notice that the cutters have worn  
through the foil.  
The TA-3070/4570/5570 shavers are designed for  
cordless operation and can be recharged easily. For  
cordless operation, just press the locking bar in the  
center of the On/Off button and push the button  
toward the head of the shaver.  
Dual Voltage  
®
You can take your MicroScreen 3 shaver with you when you travel  
®
just about anywhere in the world. your MicroScreen 3 shaver  
features worldwide automatic dual voltage conversion providing AC  
current between 100-240 volts, 50-60 Hz. Just plug it in to the local  
outlet (you may need an adapter plug) and use as usual. Your shaver  
will convert automatically to the local current requirements.  
Charging  
Prior to using your shaver for the first time, put it  
on charge for 24 hours. To charge your shaver:  
To prevent inadvertent damage to the Foils and Cutter  
Assembly, do not attempt to remove them unless you  
are replacing them. To remove the old foil and cutters follow  
the instructions that come with the foil and cutter replacement  
package. It's always a good idea to replace the foils when you  
replace the Cutter Assembly.  
Slide the On/Off button to the “Off” position.  
Connect the cord to the shaver and then to the  
The following procedures should  
be followed for battery removal:  
Make sure your shaver is unplugged from  
any outlets,so you don't risk an electrical  
shock.  
electric outlet. The charging indicator light will glow  
green, indicating your shaver is charging.  
The TA-4570 charging indicator will begin to  
flash slowly as the shaver reaches full charge.  
Your shaver cannot be overcharged, so you can  
leave it plugged in and charging between shaves.  
Use only the cord supplied with shaver. The TA-  
Remove the head assembly by gently lifting  
the assembly away from the shaver.  
To Replace a Cutter  
Assembly That is Removed  
Unintentionally:  
Hold the assembly in the middle  
of the "T."  
Gently place the forked legs into  
the opening at the top of the oscilla-  
tor tips.  
Using a small Phillips head screwdriver, remove the four screws  
from the upper and lower back of the shaver.  
3070 is designed for cordless operation only. Plug-  
ging in the cord will not provide the power to shave.  
Pull or gently pry the shaver halves apart,exposing the battery.  
Lift the rubber Side Panels from their cradles and put  
them aside.  
The TA-4570/5570 on the other hand, comes with a  
special feature that allows you to shave while your  
shaver is being recharged. Just follow the steps  
above to plug in the cord. Turn on the shaver by  
pressing on the locking bar and sliding the On/Off  
button upward. Your shaver will not recharge while  
you are shaving, so after shaving, leave it plugged in  
so it can be recharged.  
Hold each battery in place and very carefully slide the clips  
from the terminals on each battery.  
Lift or pry the battery out of the shaver.  
Do not push downward on the ends of the cutters, as you  
may bend the cutter, reducing its ability to operate smoothly.  
Do not remove cutters from the plastic pieces to which they  
are attached, as you may damage the assembly.  
CAUTION:THESE NICKEL-CADMIUM BATTERIES MUST BE RECY-  
CLED OR DISPOSED IN ACCORDANCE WITH STATE AND LOCAL  
REGULATIONS.Do not burn or mutilate,as they may burst or  
release toxic materials.Do not short-circuit,as it may cause burns.  
The TA-4570/5570 will provide a week’s worth of  
shaving after a one hour charge or a single shave after  
five minutes of charging.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Removal  
Remington® Money-Back Offer  
®
The EPA certified RBRC Battery Recycling Seal on the nickel-cadmium  
(Ni-Cd) battery indicates Remington is voluntarily participating in an  
industry program to collect and recycle these batteries at the end of their  
useful life, when taken out of service in the United States or Canada. The  
You have just bought one of the finest  
shavers available today. If for any reason  
within 30 days from when you purchased  
®
®
®
RBRC program provides a convenient alternative to placing used Ni-  
Cd batteries into the trash or the municipal waste stream, which may be  
illegal in your area. Please call 1-800-8-BATTERY for information on  
Ni-Cd battery recycling and disposal bans/restriction in your area.  
Remington involvement in this program is part of our commitment to  
preserving our environment and conserving our natural resources.”  
your Remington MicroScreen 3 Shaver,  
you are not satisfied with your shaver and  
would like a refund, just return your  
shaver, together with the sales receipt,  
to the retailer from whom you purchased  
it. Remington will reimburse all retailers  
who accept shavers within 30 days of  
purchase. If you have any questions  
regarding this money-back guarantee,  
please call 1-800-736-4648.  
Full One-Year Warranty  
Remington warrants that your product, except as noted below, is,on  
date of purchase, free from defect in material and workmanship.  
Remington will correct any such defect without charge if you return  
the complete product either in person or by mail, postage paid, to a  
Remington Company-owned Service Center or Authorized Service  
Dealer within one year after date of purchase.  
Do not return the product to the retailer from whom the product  
was purchased.  
Re m in g to n M ic r o Sc r e e n ® 3 M o d e ls  
W h ic h m o d e l is yo u r s ?  
This warranty does not cover damage by accident, misuse,abuse or  
by affixing an unauthorized accessory or alteration to the product, or  
by connection of the product to any but the specific current and volt-  
age indicated in an accompanying instruction booklet, or by any  
other conditions beyond our control. REMINGTON SHALL NOT BE  
RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL  
DAMAGES.  
Cordless, rechargeable operation with  
TA-3070  
charging indicator light. Dual voltage  
105-130 volts, AC 60 Hz, 105-240  
volts, AC 50 Hz.  
IN ADDITION,THIS WARRANTY DOES NOT COVER THE FLEXIBLE  
SCREENASSEMBLY ON OUR FOIL TYPE SHAVERS.  
Cord and cordless, rechargeable  
TA-4570  
ALL IMPLIED WARRANTIES INCLUDING BUTNOT LIMITEDTO IMPLIED  
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN  
DURATION TO ONE YEAR FROM DATE OF ORIGINAL PURCHASE.  
operation with charging indicator  
light and quick 5 minute and 1-hour  
charging. Dual voltage 100-240 volts,  
AC 50-60 Hz.  
This warranty gives you specific legal rights, and you may also have  
other rights that vary from state to state. Some states do not allow  
the exclusion limitation of incidental or consequential damages or  
limitations on how long an implied warranty lasts, so that the above  
limitations and exclusions may not apply to you.  
Cord and cordless, rechargeable  
TA-5570  
operation with ColorViewPower  
indicator. Quick 5 minute and one-  
hour charging features. Dual voltage  
100-240 volts, AC 50-60 Hz.  
No responsibility,obligation,or liability is assumed for the installation  
or maintenance of this product.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Warranty service must be performed by a Remington Company-  
owned Service Center or Authorized Service Dealer and damage or  
loss of any kind resulting from servicing by any other person is not  
covered under warranty. Enclosed is a listing of Company-owned  
Service Centers. Authorized Service Center Dealers may be found  
in the yellow pages of your directory. If you wish, you may mail  
the product, postpaid,to Remington Products Company L.L.C., 60  
Main Street, Bridgeport,CT 06604 Attention:Service Department.  
U.S. Warranty Service  
In the United States, service is provided  
by our Company-owned Service Centers  
and over 300 Authorized Service Dealers.  
The addresses of our Company-owned  
Service Centers are enclosed. For the  
address of your nearest Authorized Service  
Dealer, please consult the Yellow Pages  
under “Shaver - Electric - Repair.” If you  
wish, you may mail the product, postpaid,  
to Remington Products Company L.L.C.,  
60 Main Street, Bridgeport, CT 06604,  
Attention: Service Department.  
International Warranty Service  
Service under the Remington warranty can  
be obtained outside the United States by  
Remington-Authorized Distributors and  
Service Dealers. Please consult your local  
telephone directory for the nearest location.  
For questions or comments, please write:  
Remington Products Company, L.L.C.  
P.O. Box 1536,  
Horsham,PA 19044-6536  
Attention:Consumer Affairs  
Questions or Comments: Please call 1-800-736-4648.  
Remington,MicroScreen and  
ShaverSaver are trademarks of  
Remington Corporation,L.L.C.  
P R O D U C T S C O M PA N Y, L . L . C .  
© 1998 RPC, L.L.C.Rev 8/98  
Part No.12640  
60 Main Street Bridgeport, CT 06604  
Download from Www.Somanuals.com. All Manuals Search And Download.  

RAD Data comm Modem HCD E1 User Guide
Rayming GPS Receiver TN 206 User Guide
RCA Projection Television HD61LPW162 User Guide
Roland Musical Instrument PCR 30 User Guide
Sanyo Air Conditioner THS3632 User Guide
SATO Network Card EAP LEAP User Guide
Sealife Digital Camera DC 600 User Guide
Sears Oven 911 47169 User Guide
SECO LARM USA Door SD 71002 V0 User Guide
SECO LARM USA Home Security System SM 407 5T User Guide