using your doorstop alarm
using your window alarm
49-1010
Your window alarm comes with four LR44
button-cell batteries installed. Before use,
test the batteries as follows:
The door stop alarm is for indoor use only.
Campus Security Kit
1. Remove battery
compartment
doorstop alarm
window alarm
1. Slide to Lo or Hi.
cover, and insert
one 9V battery (not
supplied) as
trigger anchor
2. Push this button. If
the red LED lights,
the batteries are
shown. Slide
ON/OFF to ON.
ON/OFF
good. If the LED does
not light, replace the
UV proof window decals (2)
2. Insert the alarm
3. Slide off the battery
cover to replace the
batteries.
at the base of your
door, making sure
the non-skid pad
keychain alarm with light
on the bottom
of the alarm is in
firm contact with
the floor. When the door is opened,
the alarm’s metal plate is depressed,
which presses down the trigger
anchor and sounds the alarm.
Mounting your Alarm
1. Mount your window alarm indoors, on
a window pane.
double-sided
adhesive tape (1)
2. Apply the supplied adhesive tape onto
a window pane, with the side labeled
“ACTIVE” facing outside for external
visibility. Then, firmly press the window
alarm onto the adhesive tape.
Thank you for purchasing your Campus
Security Kit from RadioShack.
3. To silence the doorstop alarm, turn it
OFF.
what’s included
4. Press down on the metal wedge so
that it is positioned where it will
depress the trigger anchor.
doorstop alarm
window alarm
keychain alarm
UV proof window decals (2)
double-sided adhesive tape (1)
3. Slide to Hi or Lo to arm. Hi provides
more sensitivity for a larger area; Lo is
suitable for use in a smaller area.
4. Apply the UV proof window decal on
the window.
5. Slide to OFF to disarm the unit.
Please read this user’s guide before
installing, setting up and using your new product
Download from Www.Somanuals.com. All Manuals Search And Download.
|