20-125
installing batteries
Slide to remove the battery compartment cover and insert three AA
alkaline batteries matching the polarity symbols (+ and -) marked inside.
AM/FM/SW with Travel Alarm
To avoid losing memory and alarm settings, turn off the radio before
replacing the batteries and replace the batteries within 30 seconds.
Note
Thank you for purchasing your AM/FM/SW with Travel Alarm
from RadioShack. You can store two clock times and up to 30
preset stations.
FM/AM/SW
SW (shortwave) BAND
SNOOZE
LIGHT
Stand
ANTENNA (for FM and SW)
Slide to select a
band.
When listening to SW, press once or
more to fast tune SW frequencies.
Press to mute the alarm
for about 9 minutes.
Press and hold to turn
on the backlight.
Pull out and place radio
on a level surface.
FM: Fully extend the antenna,
and rotate for best reception.
SW: Position the antenna
vertically for best reception.
AM: This uses a built-in
ferrite rod antenna. Position
your radio for best reception.
DX/LOC SENS
(for FM and SW)
Select for best reception of
distant or local stations. Set
to LOC to receive strong local
signals, or set to DX to improve
reception of a weak station.
VOL MAX-MIN
Turn to adjust the
volume.
LOCK
HIGH/LOW TONE
Slide up to lock all the buttons.
appears.
Switch to HIGH for
normal sound and
to LOW to reduce
high frequencies.
HOUR + – Press or hold to tune
radio frequencies or adjust the
hour digit.
*
MIN - – Press or hold to tune
radio frequencies or adjust the
minute digit.
Connect 3.5mm
headphones (not
supplied) for
private listening.
ENTER – See “direct entry to
stations”.
TIMER – See “setting the timer”.
DUAL TIME
MEM/TIME
Press to enter radio preset
ALARM
using AC power supply (DC 6V
)
POWER
ON/OFF
Press to toggle
between the two
clock times. Hold for 5
seconds to view time
when radio is on.
Press to enter
alarm setting
mode (see
“setting the
alarm”).
SLEEP
Connect one end of an optional AC adapter to DC 6V
jack of
mode/clock time setting
mode. (see “presetting
radio stations” and
your radio and the other end to an standard AC wall outlet.
Press to select a preset period to
automatically turn off the radio (see
“setting the sleep timer”).
Press to
turn on/off
the radio.
“setting the clock time”).
CAUTION: You must use a power source that supplies DC 6V
and delivers at least 300 mA. Its center tip must be set to positive
!
and its plug must fit the radio’s DC 6V
jack. Using an
adapter that does not meet these specifications could damage the
radio or the adapter.
what’s included
•Always connect the AC adapter to the radio before you connect it to AC
power. When you finish, disconnect the adapter from AC power before you
disconnect it from the radio.
Radio
User’s Guide
Please read this user’s guide before
installing, setting up and using your radio.
• The correct orientation for this power unit is in a vertical or floor mount
position.
20-125.indd
1
1/08/2007 11:16:16
Download from Www.Somanuals.com. All Manuals Search And Download.
|