Radio Shack Printer Accessories 26 184 User Guide

8"(QQV"75$"VQ"2CTCNNGN"2TKPVGT"%CDNG  
OWNER’S MANUAL —  
Please read before using this equipment.  
26-184  
2#%-#)'"%106'065  
• Installation driver in floppy diskette (for  
Windows 98, Windows 98SE and Windows  
ME. (The driver is pre-installed in Windows  
2000, and Windows XP.)  
USB (Universal Serial Bus)  
Connector  
• 6 ft. USB to Parallel Printer Cable  
• This Owner’s Manual  
Parallel Connector  
Connectors are gold-plated to  
deliver the best signal possible.  
Thank you for purchasing the RadioShack  
Depending on which operating system you  
have, Windows will detect a USB device and  
the corresponding Wizard will be initiated.  
6 ft. USB to Parallel Printer Cable. This  
printer cable lets you connect a printer with a  
traditional IEEE-1284 parallel interface to a  
USB (Universal Serial Bus) interface. This  
cable is compatible with most printers that  
have a 36-pin socket, and fully compatible  
with USB host device drivers. The cable  
uses single chip (ASIC) USB to parallel for  
full speed communication. It supports both  
true bi-directional communication, and  
standard PC parallel port register based  
operation. It is both USB Specification Rev.  
1.1 compliant and IEEE-1284 1994 (bi-  
directional parallel interface) specification  
compliant. Since the cable is powered by the  
USB port, it has a very low power  
9KPFQYU";:  
Windows 98 detects the RadioShack USB to  
Parallel Printer Cable device and runs the  
Add New Hardware Wizard to help you  
installing the driver software for the printer.  
1. Click Next to continue.  
2. Insert the supplied USB to parallel  
printer cable driver diskette into the  
floppy disk drive.  
3. Select Search for the best driver for  
your device (Recommended), and  
click Next to continue.  
consumption.  
4. Select Floppy disk drives, and click  
Next to continue. Windows will detect  
the driver (A:\PARUPL.INF) and shows  
the RadioShack USB to Parallel Printer  
Cable device.  
5;56'/"4'37+4'/'065  
*CTFYCTG  
Your computer must be an IBM  
PC-compatible with an Intel-compatible  
486DX-66 MHz CPU or higher. It must have  
one standard 4-pin USB port with the  
symbol.  
5. Click Next to continue installation.  
6. When Windows reports it has finished  
installing the software required for the  
new RadioShack USB to Parallel  
5QHVYCTG  
Windows 98, Windows 98SE, Windows ME,  
Windows 2000, or Windows XP.±  
Printer Cable device, click Finish.  
±"016'"±"  
You cannot operate this printer cable with  
9KPFQYU"/'  
Windows ME detects the RadioShack  
USB to Parallel Printer Cable device  
Windows 95.  
75$"+056#..#6+10  
1. Turn on your computer.  
Add New Hardware  
and runs the  
Wizard  
to help you installing the driver  
2. Make sure the USB port is enabled and  
works properly.  
software for the printer.  
1. Insert the supplied USB to parallel  
printer cable driver diskette into the  
floppy disk drive.  
3. Plug the USB plug into the USB port.  
"+/2146#06"  
#
#
© 2002 RadioShack Corporation.  
All Rights Reserved.  
RadioShack and RadioShack.com are trademarks used by  
RadioShack Corporation.  
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon  
for pertinent information.  
— Warning  
— Important  
± — Note  
. — Caution  
° — Hint  
#
Rý  
Download from Www.Somanuals.com. All Manuals Search And Download.  

RCA Portable Speaker Ri338 User Guide
Renesas Computer Hardware RSKH8SX1582 User Guide
Roberts Radio Clock Radio CRD 37 User Guide
Samson Computer Monitor 6A User Guide
Samson Headphones Go Mic Direct User Guide
Samsung Microwave Oven M182DN User Guide
Samsung Printer Color and Monochrome Laser Printers and MFPs User Guide
Samsung Stereo System MXF830BZA User Guide
Schumacher Battery Charger SE 1072 User Guide
Sears Lawn Mower 917257643 User Guide