23-416.fm Page 1 Friday, August 6, 1999 3:08 PM
Cat. No. 23-416
OWNER’S MANUAL
Please read before using this equipment.
AC Charger
for Ni-Cd/Ni-MH
RC Battery Packs
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 3 Friday, August 6, 1999 3:08 PM
: To reduce the risk of
WARNING
fire or shock hazard, do not ex-
pose this product to rain or mois-
ture.
CAUTION
RISK OF ELECTRIC SHOCK.
!
DO NOT OPEN.
: TO REDUCE THE RISK OF
CAUTION
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED PERSONNEL.
This symbol is intended to alert you to the presence of un-
insulated dangerous voltage within the charger’s enclosure
that might be of sufficient magnitude to constitute a risk of
electric shock. Do not open the charger’s case.
This symbol is intended to inform you that important oper-
ating and maintenance instructions are included in the liter-
ature accompanying this charger.
!
Not recommended for outdoor use.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 4 Friday, August 6, 1999 3:08 PM
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
: TO REDUCE THE RISK OF FIRE OR ELECTRIC
DANGER
SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS.
This manual contains important safety and operating instruc-
tions for this battery charger. Before you use the battery
charger, read all the instructions and cautionary markings in
this manual and on the battery charger, the battery, and the
product that uses the battery.
: To reduce the risk of injury:
Warning
• Charge only nickel-cadmium and nickel-metal hydride
rechargeable batteries. Other types of batteries could
burst, causing personal injury and damage.
• Unplug the charger from the outlet before attempting any
maintenance or cleaning.
• Do not disassemble the charger; take it to a qualified
service technician when service or repair is required. Im-
proper reassembly may result in a risk of electric shock
or fire.
• Do not use an attachment not recommended or sold by
RadioShack as this could result in a risk of fire, electric
shock, or injury to persons.
: To reduce the risk of damage:
Caution
• Do not expose the charger to rain or excessive moisture.
• Do not operate the charger if it has been dropped or
damaged in any way. Take it to a qualified service techni-
cian for repair.
• Do not operate the charger with a damaged cord or plug
— replace them immediately. To reduce the risk of dam-
age to the electric plug and cord:
–Make sure the cord is not located where it will be stepped
on, tripped over, or otherwise subjected to damage or stress.
–Disconnect the charger by pulling the cord’s plug rather than
the cord.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 5 Friday, August 6, 1999 3:08 PM
OPERATION
Always use a battery pack until it can no longer provide the
necessary power, then recharge it.
:
Cautions
• This charger works only with 4.8-volt, 6.0-volt, 7.2-volt
and 9.6-volt nickel-cadmium/nickel-metal hydride cord-
connected or cartridge battery packs. Charging another
type of battery pack could damage the battery pack or
the charger.
• Avoid charging fully-charged battery packs. Doing so
can damage the battery pack or cause it to lose some of
its storage capacity.
• Use the charger only in an area that is at room tempera-
ture (65–80×F). Charging battery packs in hot areas can
permanently reduce the battery pack’s power capacity.
• To protect battery packs, allow them to cool for 20 min-
utes before recharging them.
• Charge only one battery pack at a time.
CHARGING A CORD-CONNECTED
BATTERY PACK
: Connect or disconnect the battery connector only
Warning
when the charger’s AC cord is disconnected. Otherwise, the
battery connector might arc and burn.
1. Insert the battery connector of the battery pack you want
to charge into CHARGING JACK.
illus of CHARGING
JACK location with
battery pack connector
5
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 6 Friday, August 6, 1999 3:08 PM
Notes:
• If the connector does not fit, turn it over and try again.
Do not force it.
• To charge a 4.8-volt cord-connected battery pack,
plug the small end of the supplied adapter cord fully
into the battery pack’s connector. Then plug the adapt-
er cord’s large end fully into the CHARGING JACK.
illus of 4.8 volt
battery pack connection
2. Insert the battery pack into the charger’s large compart-
ment. Make sure that the battery pack makes contact
with the voltage selector sensor and the two latches at
the bottom of the compartment.
illus of battery pack
insertion
Note: Do not insert a cartridge battery pack while charg-
ing a cord-connected battery pack, otherwise, the cord-
connected battery pack will not charge.
3. Plug the charger’s cord into a standard AC outlet. After a
few seconds, the charger automatically selects the ap-
propriate charging current and charging begins.
Notes:
• The CHARGE indicator lights when the battery pack is
charging and automatically turns off when the battery
pack finishes charging, and flashes if the battery pack
6
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 7 Friday, August 6, 1999 3:08 PM
fails to charge.
illus of CHARGE indicator
location
• If the battery pack you want to charge is a new one or
has not been used for more than 3 months, leave it in
the charger for 24 hours, even if the CHARGE indica-
tor turns off.
• If the CHARGE indicator flashes, check the battery
connection. If it still flashes, the battery pack might
need to be replaced or there might be a short in the
CHARGING JACK. Try charging a different battery
pack. If the charger still does not work, disconnect it
from power and take it to your local RadioShack for
assistance.
• The CHARGE indicator lights flash after five minutes if
a short to the CHARGING JACK is detected.
4. When the CHARGE indicator turns off, unplug the charg-
er’s AC cord from the outlet, then disconnect the battery
pack.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 8 Friday, August 6, 1999 3:08 PM
CHARGING A STANDARD CARTRIDGE
BATTERY PACK
To charge a standard cartridge battery pack, simply insert the
CARTRIDGE
battery pack in the
compartment, then press it
down firmly to ensure the battery pack makes contact with the
metal pins at the bottom of the compartment.
Caution: Do not force the battery pack. If the cartridge does
not fit, turn it over and try again.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 9 Friday, August 6, 1999 3:08 PM
SPECIFICATIONS
Input Voltage ................................... AC 120 V ±10%, 60 Hz
Charging Current for Battery Packs
Cord-Connected 7.2V ........................... DC 1.5 A 10%
±
Cord-Connected 4.8V/9.6V .................. DC 0.8 A 10%
±
Cartridge 4.8V/6.0V/7.2V/9.6V ............. DC 0.8 A 10%
±
Constant Trickle Charge Current
(All Battery Types) .......................................... 30 mA 7 mA
±
Safety Guard Protection Timer ..... 130 minutes 10 minutes
±
Rated Power ................................................................. 60W
Specifications are typical; individual units might vary. Specifi-
cations are subject to change and improvement without no-
tice.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 10 Friday, August 6, 1999 3:08 PM
CARE AND MAINTENANCE
Your RadioShack AC Universal Charger is an example of su-
perior design and craftsmanship. The following suggestions
will help you care for your charger so you can enjoy it for
years.
Keep the charger dry. If it gets wet, wipe it dry im-
mediately. Liquids might contain minerals that
can corrode the electronic circuits.
Use and store the charger only in normal temper-
ature environments. Temperature extremes can
shorten the life of electronic devices, and distort
or melt plastic parts.
Keep the charger away from dust and dirt, which
can cause premature wear of parts.
Handle the charger gently and carefully. Drop-
ping it can damage circuit boards and cases and
can cause the charger to work improperly.
Wipe the charger with a damp cloth occasionally
to keep it looking new. Do not use harsh chemi-
cals, cleaning solvents, or strong detergents to
clean the charger.
Modifying or tampering with the charger’s internal compo-
nents can cause a malfunction and might invalidate its war-
ranty. If your charger is not performing as it should, take it to
your local RadioShack store for assistance.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 11 Friday, August 6, 1999 3:08 PM
NOTES
11
Download from Www.Somanuals.com. All Manuals Search And Download.
23-416.fm Page 12 Friday, August 6, 1999 3:08 PM
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in mate-
rial and workmanship under normal use for ninety (90) days from the date of pur-
chase from RadioShack company-owned stores and authorized RadioShack
franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES
NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR-
POSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN
LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED
HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO
CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH
OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RE-
SULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVE-
NUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or
the exclusion of incidental or consequential damages, so the above limitations or
exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and
the RadioShack sales receipt as proof of purchase date to any RadioShack store.
RadioShack will, at its option, unless otherwise provided by law: (a) correct the de-
fect by product repair without charge for parts and labor; (b) replace the product
with one of the same or similar design; or (c) refund the purchase price. All re-
placed parts and products, and products on which a refund is made, become the
property of RadioShack. New or reconditioned parts and products may be used in
the performance of warranty service. Repaired or replaced parts and products are
warranted for the remainder of the original warranty period. You will be charged for
repair or replacement of the product made after the expiration of the warranty pe-
riod.
This warranty does not cover: (a) damage or failure caused by or attributable to
acts of God, abuse, accident, misuse, improper or abnormal usage, failure to fol-
low instructions, improper installation or maintenance, alteration, lightning or other
incidence of excess voltage or current; (b) any repairs other than those provided by
a RadioShack Authorized Service Facility; (c) consumables such as fuses or bat-
teries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f)
costs of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
RadioShack Customer Relations, Dept. W, 100 Throckmorton St., Suite 600, Fort
Worth, TX 76102
We Service What We Sell
3/97
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
090421114701
10A8
Printed in Hong Kong
Download from Www.Somanuals.com. All Manuals Search And Download.
|