| RBH INWALL SUBWOOFER INSTALLATION AND INSTRUCTION MANUAL   Congratulations on your purchase of the RBH MCS-88 subwoofer! Your subwoofer is the   result of many years of research and development dedicated to producing high quality   products for home audio and audio/video systems. This manual is designed to give you,   the installer or owner, basic information as to the subwoofers installation and operation.   TECHNOLOGY   At the heart of the MCS-88 is a proprietary aluminum woofer. The special aluminum   cone combines stiffness, low mass and self damping properties in a manner that al-   lows virtually uncolored presentation of program material. A powerful magnet and   extended voice coil give the woofers high excursion capability, which ensures accurate   dynamic reproduction.   CROSSOVER   The MCS-88 utilizes a defeatable crossover network. This crossover is fixed at 100Hz   low-pass when the switch is set to “On”; the subwoofer will then only play frequencies   100Hz and below. All frequencies above 100 Hz will be reduced by 12dB per octave.   When set to “Off”, the subwoofer will play the full range of frequencies. This switch   should be in the “On” position when the signal sent to the subwoofer is ‘full-range’ or   not previously filtered through a crossover. The switch should be set to “Off” when the   signal sent to the subwoofer is coming from a source using a crossover, such as the   subwoofer pre-out from some receivers or pre-amplifiers. Please refer to your receiver   or pre-amplifier owners manual for proper bass management settings information. This   will ensure that the subwoofer is not receiving a signal filtered through two crossovers.   We suggest consulting with your installer, or experimenting with the crossover on and   off to determine which is best for your system.   PAINTING   RBH in-wall subwoofer frames and grilles can be painted any color to match any decor.   A plastic paint shield is supplied and placed inside the grille to protect the speaker from   becoming damaged during painting. PLEASE NOTE:This plastic paint shield must   be removed before operation of the speaker begins.   Download from Www.Somanuals.com. All Manuals Search And Download.   INWALL SUBWOOFER SPECIFICATIONS   Frequency Range: 35-180 Hz   Sensitivity: 90dB 1w/1m   Recommended Amplifier Power: 50-200 Watts   Drive Units: 2- 8” aluminum cone woofers   Crossover Frequency: 100 Hz (low-pass - “On”)   Filter Slope: 12dB per octave   Impedance: 8 Ohms (each driver)   Finished Dimensions: 18ꢀ”H x 10ꢁ”W x 3ꢂ”D   Cutout Dimensions: 17ꢂ”H x 9”D   Weight: 10 Lbs.   Download from Www.Somanuals.com. All Manuals Search And Download.   WARRANTY   Your RBH Sound in-wall subwoofer is covered by a limited warranty against defects in   materials and workmanship for a period of twenty-five (25) years from the original date   of purchase. This warranty is provided by the authorized RBH Sound dealer where   the loudspeaker was purchased. Warranty repair will be performed only when your   purchase receipt is presented as proof of ownership and date of purchase. Defective   parts will be repaired or replaced without charge by your dealer’s store or the location   designated by your dealer that is authorized to service RBH products. Charges for   unauthorized service and transportation cost are not reimbursable under this warranty.   This warranty becomes void if the product has been damaged by alteration, misuse or   neglect. The warrantor assumes no liability for property damage or any other incidental   or consequential damage whatsoever which may result from the failure of this product.   Any and all warranties of merchantability and fitness implied by law are limited to the   duration of this express warranty. Some states do not allow limitations on how long   an implied warranty lasts, so the above limitations may not apply to you. Some states   do not allow the exclusion or limitation of incidental or consequential damages, so the   above limitation or exclusion may not apply to you.   REDEFINING THE WAY YOU EXPERIENCE SOUND   © 2003 • RBH SOUND, INC. • 976 N. MARSHALL WAY • BLDG. 2 UNIT 4 • LAYTON, UT • 84041   Download from Www.Somanuals.com. All Manuals Search And Download.   |