1675 MacArthur Blvd., Costa Mesa, CA, 92626 USA
Main Number (714) 754-6175 or toll free (USA only) (800) 854-4079
Customer Service(714) 957-7150 or toll free (USA only) (800) 772-2834
HPR M10 KIT User Manual
This suspension kit is required for vertical suspension of the QSC HPR122i from a solid structure or for the vertical suspension of the QSC HPR122i, HPR152i or
HPR153i from a solid structure. For horizontal suspension of the HPR122i, the HPR SUS KIT 122 is required. Do not suspend the HPR152i or HPR153i enclosures
horizontally.
Contents:
• Eyebolt, M10, steel, 3 each
• Spacer, aluminum, 2 each
• Conical spring washer, 2 each
Important Safety Precautions & Explanation of Symbols
Install in accordance with QSC Audio Product's instructions and under the supervision of a licensed Professional Engineer.
WARNING! The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and mainte-
nance (servicing) instructions in this manual.
•Before placing, installing, rigging, or suspending any speaker product, inspect all hardware, suspension, enclosures,
transducers, brackets and associated equipment for damage. Any missing, corroded, deformed, or non-load rated com-
ponent could significantly reduce the strength of the installation or placement. Any such condition severely reduces
the safety of the installation and should be immediately corrected. Use only hardware which is rated for the loading
conditions of the installation and any possible short-term, unexpected overloading. Never exceed the rating of the
hardware or equipment.
•Consult a licensed, Professional Engineer regarding physical equipment installation. All local, state and national reg-
ulations regarding the safety and operation of equipment are understood and adhered to.
•Use only load rated hardware to attach to the eyebolts or pull-back bar when suspending these products.
•Do not suspend these products from any structural element on the enclosure other than the load rated M10 suspension
points.
•Do not suspend the HPR152i or HPR153i horizontally under any circumstances using this or any other hardware.
Vertical Suspension of the HPR122i
Install Two Top-surface Eyebolts
On the top of the enclosure, near the front corners, are M10 flat-head screws which must be removed and
have an eyebolts installed in their place.
Eyebolt installation loca-
tions for vertical suspension
of the HPR122i loudspeaker.
1- Remove the factory installed M10 flat-head screws from the top of the enclosure using a 6mm hex wrench.
2- Thread an eyebolt into each of the enclosure’s threaded inserts; do not use flat washers or standoffs on the
top eyebolts. Tighten eyebolts.
Install One Pull-back Eyebolt
At the rear of the enclosure, just below the amplifier module, is a M10 flat-head screw which must be
removed and have an eyebolt installed in its place.
1- Remove the factory installed M10 flat-head screw from the enclosure using a 6mm hex wrench.
2- Thread an eyebolt into the enclosure’s threaded insert; do not use a standoff on the pull-back eyebolt.
Tighten eyebolt.
•Do not use the eyebolt spacers when suspending the HPR122i loud-
speaker vertically. They are for use on the HPR152i and HPR153i loud-
speakers.
•Note! Be sure to tighten each eyebolt until shoulder is snug against the
enclosure. Tighten the eyebolts down and then continue to rotate until
they are positioned as desired.
Download from Www.Somanuals.com. All Manuals Search And Download.
|