PWMA100
WIRELESS RECHARGEABLE
PORTABLE AMPLIFIER
WWW.PYLEAUDIO.COM
USER'S MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION
OPERATION
Recharging:
1. POWER SUPPLY
a. AC power: Please confirm your current AC power is
same as the voltage marked on the device.
1. Connect amplifier to AC power, charge indicator will light.
The unit starts to charge rechargeable battery. DC power
can not charge the battery.
b.DC power: DC power can be input from DC IN jack. If you
use car battery, the power should be 12V-15V. Please
note the correct polarity.
2. During charging you can use the unit at the same time.
3. When using rechargeable battery, if the unit stops
producing sound, this means the rechargeable battery
power is low. Connect AC power to charge the battery.
Charging time is about 8~10 hours.
C. Built-in rechargeable battery: you can also use built-in
rechargeable battery.
2. Turn on power switch of amplifier, power indicator will light.
3. Open the battery cover of the transmitter. Put a 9V battery
into battery compartment and then close the battery cover.
Keep transmitter at least 1M from the receiver to prevent
feedback. Turn on transmitter, RF indicator on receiver will
light. Adjust wireless microphone volume to suitable level.
The wireless system is now ready to use.
4. Please charge this device every 2 months if you don't use
the device for a long period of time.
5. Unplug th unit from mains power supply if you are not
going to use this device for a long time or after charging.
4. Wired MIC can connect to MIC in jack and its volume can
be adjusted separately. Wire microphone and wireless
microphone can be used at the same time.
5. Adjust TREBLE/BASS to suitable level. When feed-back
comes from amplifier, please reduce TREBLE. If feedback
still exists, reduce the volume slightly.
6. REC OUT can connect to recorder player or external
amplifier.
-3-
-4-
Download from Www.Somanuals.com. All Manuals Search And Download.
SPECIFICATIONS
TROUBESHOOTING
PROBLEM
SOLUTION
AMPLIFIER
1.Push the power switch to "ON"
2.Replace a new battery for transmitter.
3.Please check the frequency of transmitter.
Make sure transmitter frequency is same
as main unit.
Output power:
Frequency Range:
S/N:
20W(MAX)
160-270MHz
60dB
RF indicator
does not light
Power supply:
AC 120V 60Hz
DC 12V-15V
600
1.Rechargeable battery power is low. Please
plug in AC power to charge the battery.
2.Transmitter battery power is low. Please
replace new battery.
RF indicator
flashes
Output Impedance:
Effective Distance:
30M
A howling
Reduce microphone volume or move the
microphone away from the speaker. Keep
microphone 1.5-3M from receiverunit.
noise is heard
from speaker
1. Rechargeable battery may be destroyed.
Please replace a new one. (Contact your
dealer or professionals for battery
replacement)
The charge
indicator
TRANSMITTER
does not light
Frequency Range:
Dynamic Range:
Frequency Response:
Working Temperature:
Power supply
160-270MHz
80dB
2. Check the AC power connection.
1. Check the transmitter power switch is "ON"
2. Check the W/M volume control or MIC
volume is on.
100-10KHz
-10 -45
No sound
9V battery
8-10 hours
Battery life
-5-
-6-
Download from Www.Somanuals.com. All Manuals Search And Download.
|