PYLE Audio Stereo Amplifier PT 1100 PT3300 User Guide

OPERATING MANUAL  
PDF created with pdfFactory trial version www.pdffactory.com  
HYBRID AMPLIFIER  
Audio Digital Amplifier  
Main Channel Power Output  
1
PMPO,8 Ohms, 1KHz test  
1000WX2  
<1%  
3000WX2  
<1%  
2
3
4
THD(1KHz)  
Normal Load Impedance  
8 Ohm  
8 Ohm  
Input Sensitivity Impedance  
CD/DVD AUX TAPE TUNER  
400mV/33k Ohm  
6mV/600 Ohm  
400mV/33k Ohm  
6mV/600 Ohm  
Microphone  
5
6
Signal to Noise Ratio  
Pure Amplifier  
78dB  
76dB  
78dB  
76dB  
7
8
Frequency Range  
Frequency Response(20Hz-20KHz)  
±2dB  
±2dB  
9
±10dB  
±10dB  
Tone Characteristic(100Hz-10KHz)  
Power Requirements  
10  
AC~110V/60Hz AC~220V50Hz  
483(W)X300(D)X140(H)mm  
11  
12  
Dimension  
Weight  
6kg  
6.5kg  
Specifications subject to change without prior notice  
4
3
PDF created with pdfFactory trial version www.pdffactory.com  
1  
2、  
3、  
4、  
5、  
6、  
7、  
8、  
SPEAKER  
Speaker  
A/B  
Selector  
SPEAKER  
1
2
ENGINEERED IN JAPAN  
DESIGNEDIN THE USA  
Speaker  
DVD/CD  
A+BSelector  
WARNI NG  
3
4
DVD/CD Selector  
AUX  
-
5
6
AUX Selector  
TUNER  
TUNER Selector  
TAPE  
7
8
TAPE Selector  
VOL+  
Master Volume Up  
VOL-  
Master Volume Down  
Remote Controller Operation  
1. Remote controller should be operated within 6  
meter and the scope of 30 in front of receiver.  
2. Make sure that there is no big obstacle between  
remote controller and machine.  
3. Remote sensor should be far away  
from the light,high amounts of light can affect itsperformance.  
5
6
PDF created with pdfFactory trial version www.pdffactory.com  
2 MIC  
INPUTS  
ENGINEERED IN JAPAN  
DESIGNED IN THEUSA  
WARNI NG  
1. Make sure that all connections are properly connected and the main  
volume is set to minimum level before turning on the unit.  
2. When more than one pair of speakers are used, (specially the main  
speaker output) make sure that the speakers used are of the same  
wattage and impedance, otherwise the unit may be damaged under  
high power or long term operation.  
-
TAPE  
3. To avoid humming sounds and unwanted noise, make sure that all the  
wires are properly inserted.  
TUNER  
4. For speaker cords, strip off the vinyl coating and twist the wire tip.  
Push down the pink jack or loosen the screw terminal, before inserting  
the wire tip, then fasten it and tighten the screw. Be careful not to let  
the wires stick out of the terminal otherwise this may cause a short  
circuit when wires of different terminal contact each other.  
5. After the unit is turned on, adjust the main volume to the desired level  
same is true with the bass and treble volume, etc.  
DVD/CD  
AUX  
CD Recorder  
Main (A)Speakers  
Main (B)Speakers  
8
7
PDF created with pdfFactory trial version www.pdffactory.com  

Radio Shack Cordless Telephone 43 1088 User Guide
RCA CD Player RS2042 User Guide
Remington Hair Dryer DC 1880 User Guide
Rheem Water Heater STREAMLINE ELECTRIC User Guide
Riccar Sewing Machine RL 603 User Guide
Roland Music Mixer EC2 YF NK User Guide
SBC comm Telephone SBC 116 User Guide
Sears Water Pump 3902508 User Guide
Seidio GPS Receiver G2350 User Guide
Sennheiser Headphones EK 500 User Guide