use attachments not recommended by
Philips Electronics North America
Corporation.
IMPORTANT
SAFETY
3. Never operate this razor if it has a damaged
cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped
into water. Return the razor to an Authorized
Norelco Service Location for examination
and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any
opening.
6. Do not charge or plug in the razor outdoors
or operate where aerosol (spray) products
are being used or where oxygen is being
administered.
INSTRUCTIONS
When using an electric razor, basic
precautions should always be followed,
including the following:
Read all instructions before using this
appliance.
Rota 2
Doubleheader 282XL
Rechargeable
Cord/Cordless Razor
DANGER
To reduce the risk of electric shock:
1. Do not reach for a razor that has fallen
into water. Unplug immediately.
7. Do not use this razor with a damaged or
broken comb, as facial injury may occur.
2. Do not use while bathing or in a shower.
3. Do not place or store razor where it can
fall or be pulled into a tub or sink. Do not
place in or drop into water or other liquid.
4. Always unplug this razor from the electrical
outlet immediately after using, except
when razor is (re)charging.
8. Always attach plug to razor first, then to out-
let. Be certain that plug is inserted firmly
into razor up to mark indicated on plug. To
disconnect, turn ON/OFF switch to “OFF”
position (switch is down), then remove plug
from outlet.
9. To prevent possible damage to the cord, do
not wrap cord around the razor.
10. Never put razor in direct sunlight or store in
pouch at a temperature above 140°F.
5. Unplug this razor before cleaning.
6. When discarding razor, unplug razor
and remove rechargeable batteries. See
enclosed sheet for instructions.
WARNING
SAVE THESE
To reduce the risk of burns, fire, electric
shock, or injury to persons:
INSTRUCTIONS
1. Close supervision is necessary when this
razor is used by, on, or near children or
invalids.
2. Use this razor for its intended household
use as described in this manual. Do not
IMPORTANT: Your razor contains NICKEL-
CADMIUM RECHARGEABLE BATTERIES. See
enclosed instruction sheet for battery disposal
information.
Rota-Action Shaving System
Download from Www.Somanuals.com. All Manuals Search And Download.
1. VOLTAGE
2A. TO CHARGE
2B. TO RECHARGE
3. CORD/CORDLESS
SHAVING
4. POP-OUT SIDEBURN,
BEARD AND MOUS-
TACHE TRIMMER
In North America, Central
America, and South America,
the most common voltage is
between 110V and 130V AC.
When traveling to other coun-
tries, common voltage may
range to 240V AC. Your new
razor will automatically convert
internally to work on 100V to
240V AC systems.
An adaptor plug may be neces-
sary for cord usage in foreign
countries. It is suggested that
you take all adaptor plugs with
you when traveling overseas to
ensure compatibility with most
foreign outlet configurations.
Start with a clean, dry face.
You may choose to use a pre-
shave lotion to set your beard
up for a close, smooth, com-
fortable shave, especially if
you are using an electric razor
for the first time.
CAUTION: It is recommended
that you wash and dry your
hands to remove any remain-
ing lotion before handling
your razor. Some lotions may
cause damage to the exterior
finish of your razor housing.
In addition, clean razor heads
more frequently to prevent
pre-shave lotion build-up.
1. Be certain your razor is
OFF.
7. Keep skin taut using your
fingers to stretch skin so
blades can cut whiskers
off.
8. Easy does it. Gently press
razor to your skin so
floating heads can follow
the contours of your face.
■ After initial 8 hour charge,
recharging will take only 1
hour to (re)charge batter-
ies to full capacity.
1. Push Trimmer Slide Switch
up to pop out trimmer and
turn razor ON.
2. Hold trimmer, as shown,
to exact hairline desired.
Move trimmer downward
with gentle pressure (Fig. 1).
3. Turn razor OFF and brush
out trimmer section using
long bristles of brush.
■ First time charging re-
quires a full 8 hours. For
first time or initial charge,
Green Charge Indicator
Light will light to indicate
razor is (re)charging. For
proper use, charge razor
for the full 8 hours as
directed. A fully charged
razor will give approxi-
2C. FAST 5-MINUTE
QUICK CHARGE
■ When battery is totally
depleted, recharging for 5
minutes gives enough
energy for one 3-5 minute
cordless shave.
■ If razor has not been used
for at least a month, razor
must be recharged for a
full 8 hours (see Section
2A. TO CHARGE).
9. Turn razor OFF and un-
plug.
■ It is not recommended
that this razor be used
exclusively as a corded
razor. Continual use as a
corded razor as well as
continuously recharging
razor will reduce life of
batteries.
4. Close trimmer by pushing
Trimmer Slide Switch down.
mately
2
weeks of
3
■ Lubricate trimmer teeth
twice a year with Norelco
Razor Lubricant, model
AL80, or one drop of light
machine oil.
minute shaves per day.
2. Use only the cord provided.
3. Connect cord to razor and
plug into outlet.
Norelco Travel Adaptor Plug
Kit, model TP5, may be pur-
chased at a store near you or at
a Norelco Service Store.
■ (Re)charge at tempera-
tures between 40°F and
95°F. Charging at lower or
higher temperatures ad-
versely affects lifetime of
batteries.
■ (Re)charging longer than
required period of time
will not harm razor.
However, continuously
charging razor will reduce
life of batteries.
A. CORD
NOTE: Razor does not re-
charge during shaving.
1. Be certain razor is in OFF
position.
2. Connect cord provided to
razor.
B. CORDLESS
1. Charge according to
3. Remove Protective Razor
directions.
Head Assembly Guard.
2. Slide ON/OFF switch ON.
Begin shaving.
4. Plug into 100V to 240V AC
outlet.
5. Slide ON/OFF switch ON.
1
Begin shaving.
■ Even when cord shaving,
if battery is low, wait a few
seconds for razor to go
ON.
6. Shave against direction of
beard growth using a quick,
small, circular motion.
Download from Www.Somanuals.com. All Manuals Search And Download.
5A. ONCE A WEEK
5B. ONCE EVERY 4-8
WEEKS
5. MAINTENANCE
INSTRUCTIONS
IMPORTANT
1. Clean Razor Head Assembly IMPORTANT: Do NOT inter- 2. Squeeze S-formation in 6. Clean razor comb with
Razor Lubricant, model
AL80, or one drop of light
machine oil over floating
heads with your finger.
8. Replace cutter into comb
section, and slide back
into retainer plate.
as shown (Fig. 2).
change the cutters and combs.
They are a matched set and if
interchanged may adversely
affect shaving performance
until cutters reseat them-
selves. Therefore, remove,
clean, and replace each set
individually.
center of retainer plate
and lift out from Razor
Head Assembly (Fig. 6).
long bristles of brush in a
circular motion as shown
(Fig. 10).
■ Always switch razor OFF
and remove plug from 2. Press Razor Head Release
outlet before cleaning.
Button and lift Razor Head
Assembly using thumb
and index finger to re-
move from razor housing
(Fig. 3).
3. Slide one cutter and comb 7. For consistently close and
■ Always store razor with
Protective Plastic Head
Guard on Razor Head
Assembly.
■ Never clean, remove or
replace head assembly
while motor is ON.
■ Do not apply pressure to
combs. Do not touch
razor heads with hard
objects as this may dent
or damage precision-
made slotted combs.
out of frame (Fig. 7).
comfortable shaves, razor
heads should be cleaned
and lubricated every 4-8
weeks. After cleaning
heads in a degreasing liq-
uid (e.g. Norelco Razor
Cleaner, RAZORMATE
Electrosonic Cleaner or
alcohol), and reassem-
bling razor, spread Norelco
4. Each cutter and comb is a
matched set; do not inter-
change them. Separate
9. Repeat procedure for
other cutting head.
3. Clean inside of Razor Head
Assembly and Hair Chamber
with long bristles of brush
(Fig. 4).
1. Remove Razor Head Assem-
bly. Press Razor Head Re-
lease Button and lift Razor
Head Assembly using thumb
and index finger to remove
from razor housing (Fig. 5).
one cutter/comb, at
time, as shown (Fig. 8).
5. Cutter should be held as
shown and brushed in an
upward motion (Fig. 9).
a
10. Replace retainer plate,
with cutting heads in
place, back into Razor
Head Assembly. Press S-
formation until plate
clicks into place (Fig. 11).
4. Press Razor Head Assembly
back on razor housing.
11. Press Razor Head Assem-
bly back on razor housing.
Do not use razor if combs
are damaged or broken.
■
Download from Www.Somanuals.com. All Manuals Search And Download.
FULL TWO YEAR WARRANTY
6. HP1917 REPLACE-
MENT HEADS AND
7. IMPORTANT BATTERY
DISPOSAL
Philips Electronics North America Corporation warrants each new Norelco Product,
Model 282XL (except cutters and combs), against defects in materials or workman-
ship for a period of two years from the date of purchase, and agrees to repair or replace
any defective product without charge.
RAZOR ACCESSORIES
INFORMATION
Replacement Heads:
IMPORTANT: This warranty does not cover damage resulting from accident,
misuse or abuse, lack of reasonable care, the affixing of any attachment not
provided with the product or loss of parts or subjecting the product to any but
the specified voltage.* Use of unauthorized replacement parts will void this war-
ranty.
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY FOR
WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE
AND WILL NOT REIMBURSE THE CONSUMER FOR DAMAGE RESULTING FROM
WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR SERVICE.
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL OR CONSE-
QUENTIAL DAMAGES.
In order to obtain warranty service, simply take or ship the product postage pre-
paid to the nearest Norelco Service Store. Warranty service is available at any
Authorized Norelco Service Location. It is suggested that for your protection you
return shipments of product by insured mail, insurance prepaid. Damage occur-
ring during shipment is not covered by this warranty.
NOTE: No other warranty, written or oral, is authorized by Philips Electronics North
America Corporation.
When discarding your razor:
60-DAY MONEY-BACK GUARANTEE
If you are not fully satisfied with your Norelco Men’s or Women’s Razor,
Women’s Hair Removal System, Home Hair Cutting System or Beard and
Moustache Trimmer, Norelco will refund you the full purchase price. Send the
product back to:
The self-sharpening rotary
blades in your Norelco razor
are precision-made to give
closer shaves. When they
finally do need replacing,
specify only Norelco brand
replacement cutters and
combs, model HP1917.
DO NOT USE shaver sharpen-
ers as this will damage your
blades and cutters and will
adversely affect the shaving
performance.
THIS NORELCO RAZOR CON-
TAINS NICKEL-CADMIUM RE-
CHARGEABLE BATTERIES
WHICH MUST BE RECYCLED
OR DISPOSED OF PROPERLY.
Refer to enclosed instruction
sheet for directions on remov-
ing rechargeable batteries.
Norelco Consumer Products Company
A Division of
Philips Electronics North America Corporation
P.O. Box 1116
Skokie, IL 60076
The product must be shipped prepaid by insured mail, insurance prepaid, have
the sales slip indicating purchase price and date of purchase enclosed, and be
postmarked no later than 60 days after the date of purchase. Norelco reserves
the right to verify the purchase price of the product.
CAUTION:
■ Batteries should be re-
moved only when razor is
to be discarded.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state. Some states do not allow the exclusion or limita-
tion of incidental or consequential damages, so the above exclusion and limita-
tions may not apply to you.
NOTE: It is recommended that
you replace your razor heads
once a year.
Send dated sales slip, your complete name and address as indicated below, and
the product, prepaid to: Norelco Consumer Products Company, A Division of
Philips Electronics North America Corporation, P.O. Box 1116, Skokie, IL
60076. Please allow 4-6 weeks for delivery of check.
■ Make sure razor is un-
plugged before disman-
tling for battery removal.
■ All servicing or battery
replacement should be per-
formed by an Authorized
Norelco Service Location
only.
* Read enclosed instructions carefully.
Razor Cleaners:
Norelco RAZORMATE Electrosonic
Heads Cleaner, model ERC100,
effectively vibrates to remove
hair, stubble, facial oils, accu-
mulated dirt and residue from
heads.
Manufactured for:
NAME
Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd.
Please Print
ADDRESS
CITY
Stamford, CT 06912-0015
MADE IN HOLLAND.
Norelco Razor Cleaner, model
RC1776, removes dirt and
skin oils from razor heads.
Norelco Razor Lubricant,
model AL80, lubricates razor
heads for improved performance.
STATE
ZIP
This symbol on the product’s nameplate means it is listed
by Underwriters’ Laboratories, Inc.
TELEPHONE NO.
(
)
Area Code
Norelco and RAZORMATE are Registered Trademarks of
Philips Electronics North America Corporation.
REASON FOR RETURNING
Rota 2, Rota 2 & Design, and Rota-Action are Trademarks of
Philips Electronics North America Corporation.
Norelco Razor Accessories
may be purchased at a store
near you, a Norelco Service
Store, or by using the handy
order form enclosed.
© Philips Electronics North America Corporation 1995
ROTA-ACTION SHAVING SYSTEM
Download from Www.Somanuals.com. All Manuals Search And Download.
|