Pelco TV Mount C242M C User Manual

C242M-C (11/99)  
MM3000  
Monitor Mount  
®
IMPORTANT SAFEGUARDS AND WARNINGS  
Prior to installation and use of this product, the following WARNINGS should be observed.  
3500 Pelco Way,  
Clovis, CA 93612-5699  
USA  
1. Installation and servicing should only be done by qualified service personnel and conform  
to all local codes.  
In North America & Canada:  
Tel (800) 289-9100  
FAX (800) 289-9150  
2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo-  
sure, it is designed for indoor use only and it must not be installed where exposed to rain  
and moisture.  
International Customers:  
Tel +1 (559) 292-1981  
FAX +1 (559) 348-1120  
3. Use only installation methods and materials capable of supporting four times the maxi-  
mum specified load.  
4. Only use replacement parts recommended by Pelco.  
Please thoroughly familiarize yourself with the information in this manual prior to installation  
and operation.  
DESCRIPTION  
The MM3000 is a ceiling “J” mount designed for use with 9-inch (22.86 cm) and 12-inch (30.48  
cm) CCTV monitors. The mount allows horizontal and vertical adjustment of the monitor.  
U
®
L
LISTED  
INSTALLATION  
To install the MM3000, perform the following steps.  
1. Drill holes in the mounting surface using the mount as a template and attach the mount  
securely with fasteners of a suitable size.  
NOTE: The two fasteners re-  
quired to secure the MM3000 to  
the mounting surface (minimum  
1/4-inch diameter recom-  
mended) and screws to mount  
the monitor are not supplied;  
screws holding feet on bottom of  
monitor may be used to secure  
monitor to mount.  
2. Remove the rubber feet from the bottom of the monitor. Place the monitor on the monitor  
support pan and secure the monitor to the pan. (The screws previously used to secure  
the rubber feet to the bottom of the monitor may be used.)  
3. If the monitor mounting hole pattern does not align with slots in support pan, use exten-  
sion brackets provided and attach them to monitor base (see Figure 1). Then place moni-  
tor and brackets onto support pan and tighten nuts (provided) to secure monitor.  
4. Adjust pan rotation (360°) and tilt angle of monitor support pan (45° down). Lock into po-  
sition by tightening the hex head bolts.  
Figure 1. Attaching Support Pan Extension Brackets  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Peavey Portable Speaker DTH 215b User Manual
Pelonis Electric Heater HC 350 User Manual
Philips Breast Pump SCF332 User Manual
Philips DVR VR 540 User Manual
Philips TV Antenna 19PFL5404H 12 User Manual
Philips Work Light P 5933 User Manual
Polaris Offroad Vehicle X2 500 EFI User Manual
Polaroid Digital Camera DS 34 User Manual
Powermate Portable Generator PC0525304 User Manual
PYLE Audio Automobile Electronics PLTS73FX User Manual