C912M-A (4/00)
LB2000
Vertical Lock Box
®
DESCRIPTION
3500 Pelco Way,
Clovis, CA 93612-5699
USA
The LB2000 Vertical Lock Box protects tower-type computer disk drives or other vertical-standing
devices from intruders. It is designed for desktop mounting applications only. The enclosure is
constructed from steel and features a smoked acrylic window and tamper-resistant lock.
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
INSTALLATION
The LB2000 Vertical Lock Box is provided with numerous 5/16-inch holes for mounting to solid
surfaces.
International Customers:
Tel +1(559) 292-1981
FAX +1(559) 348-1120
CAUTION: Care should be taken when installing or removing the equipment so that no
weight is applied to the front cover. Be careful not to scratch the cover.
To mount the vertical lock box, perform the following steps:
1. Remove the vertical lock box from the box.
2. Find a suitable mounting surface for the lock box.
3. Unlock the front panel and open the top lid.
4. Drill four pilot holes in the mounting surface.
5. Using appropriate mounting screws, screw the enclosure to the mounting surface.
6. Connect the power cord to a duplex receptacle.
7. Remove one of the rear plugs or knock-outs and run the cables.
8. Place the equipment in the lock box and plug it into the convenience receptacle.
9. Close the top cover.
10. Start the equipment.
11. Close and lock the front cover.
MAINTENANCE
Maintenance performed at regularly scheduled intervals will help prolong life and appearance of
the equipment.
1. Clean the window with a mild non-abrasive detergent in water and a soft cloth regularly to
help maintain picture clarity.
2. Clean or replace the foam filter pad in the rear of the enclosure periodically. To replace or
clean the filter pad, perform the following steps:
a. Pry the grill loose from the filter assembly at the rear of the box.
b. Remove the filter pad from the filter bracket. Clean the pad with water and mild deter-
gent, dry thoroughly, and reinsert or replace with new pads. (Replacement pads, part
number FLTRF450-A/45, are available from Pelco).
SPECIFICATIONS
Dimensions:
See Figure 1
Construction
Rack:
16-gauge cold rolled steel
Front Window:
.25-inch (6.35 mm) thick smoked acrylic
Finish:
Black polyester powder coat
Power Connection:
Cooling:
Internal convenience receptacle
Internal 4-inch (10.16 cm) square fan, 120 VAC, continuous duty
3A, Type 3AG
Fusing:
Cable Entry:
Two .50-inch (1.27 cm) conduit knockouts
Two 1-inch (2.54 cm) grommeted cable ducts
Download from Www.Somanuals.com. All Manuals Search And Download.
|