PYLE Audio Speaker PASW 15 User Manual

Owner’s Manual  
PASW15  
PASW18  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Connections  
Your PASW series  
speaker has an extremely  
flexible connection panel.  
There are two Speakon jacks  
as well as two ¼” jacks. You  
can also hookup your speaker  
cabinet using the “Quick  
Connect” speaker terminals,  
which accommodate either  
wire leads or a banana plug.  
The jacks are wired in  
parallel, which allows you to  
daisy chain additional  
speakers. Thus you can use one amplifier channel to power multiple  
speakers.  
Make certain that the wires you are using are at least 12 gauge  
unshielded speaker cable (the lower the number, the thicker the wire). Do  
not use shielded “instrument” cables.  
Hooking speakers up in parallel decreases the overall  
impedance, placing a greater load on the amplifier. Check your  
amplifier’s specifications to ensure that you are not overloading  
the channel.  
CAUTION: DO NOT USE MORE THAN ONE JACK AS AN  
AMPLIFIER INPUT. DOING SO WILL DAMAGE THE SPEAKER!  
Operation  
When powering on your equipment, make sure the volume level on  
the amplifier is turned all the way down. This is to avoid the “popping”  
noise, which could damage your speaker.  
High frequencies are unidirectional while low frequencies are omni  
directional. Being that this is a subwoofer, it is not necessary for there to be  
www.pyleaudio.com  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
a direct line-of-site between the sub and the audience. Optimal placement is  
directly on the floor.  
When using more than one loudspeaker, you have to account for  
phase alignment. When the speakers are close together this is not usually an  
issue. However, when they are far apart, the sound from one speaker may  
reach the ear a fraction of a second before the other. This will cause certain  
frequencies to cancel out, resulting in a hollow sound. To avoid this, you  
may have to use a delay processor to align the sound from the speakers.  
Although an active crossover is not required you may choose to use  
one for maximum routing control and increased amplifier efficiency.  
Troubleshooting  
No Sound:  
VCheck connections  
VTry a different speaker cable  
VCheck levels on amplifier  
VConfirm amplifier is getting a signal (check signal LED, or use  
headphone output)  
Intermittent Output:  
VCheck connections  
VTry a different speaker cable  
Weak Bass:  
VCheck the polarity of the speaker connection. It may be reversed.  
VListen with headphones to confirm the amplifier is being sent a good  
signal.  
Distorted Sound:  
VCheck if the amplifier is overdriven. If it is, you will have to turn the  
level down.  
VMake sure you are not exceeding the RMS rating of your speaker.  
www.pyleaudio.com  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Specifications  
Frequency  
Range  
Sensitivity  
(1w/1m)  
Model  
Woofer  
15“  
RMS  
Peak  
Connections  
Dimensions  
W = 18“  
Weight  
48 lb.  
Speakon (2)  
³(2)  
—Quick Connect“  
(Wire Lead & Banana)  
PASW15  
Kapton 20-500 Hz 400W 800W  
Voice Coil  
95 dB  
8Ω D = 15.8“  
H = 23“  
Speakon (2)  
³(2)  
—Quick Connect“  
(Wire Lead & Banana)  
18“  
Kapton  
Voice Coil  
W = 23“  
D = 17.8“  
H = 26.8“  
PASW18  
20-400 Hz 500W 1000W  
97 dB  
8Ω  
70 lb.  
Typical Setup  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Parallel Setup  
Crossover Setup  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Recommended Accessories  
PT Series  
PPJJ30  
Amplifiers  
°30ft. 12 Gauge  
°
°
°
Professional High-Power amplifiers  
8 Models to choose from  
°Professional Speaker Cable  
°³“ to ³“  
All models rack-mountable  
in standard ISO 19“ rack  
PPJJ15  
°Same as above 15ft.  
PZR Series  
Amplifiers  
PPSS30  
°30ft. 12 Gauge  
°
°
°
Professional High-Power amplifiers  
3 Models to choose from  
°Professional SpeakerCable  
°Speakon to Speakon  
All models rack-mountable  
in standard ISO 19“ rack  
PPSS15  
°Same as above 15ft  
PPCX2  
PPSJ30  
°2-Way Stereo Crossover  
°Separate Subwoofer output  
°XLR Inputs ³“ Outputs  
°Rack Mountable  
°30ft. 12 Gauge Professional  
°Speaker Cable  
°Speakon to ³“  
PPCX3  
PPSJ15  
°3-Way Stereo Crossover  
°Separate Subwoofer output  
°XLR Inputs XLR Outputs  
°Rack Mountable  
°Same as above 15ft.  
www.pyleaudio.com  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  

Philips Network Card CPWUA054 User Manual
Philips Router AJL 700 User Manual
Philips TV Receiver WVH111 User Manual
Philips Universal Remote SBC RU 538 00 User Manual
Philips Work Light P 5722 C User Manual
Pioneer MP3 Docking Station IDK 80 User Manual
Planet Technology Network Router VC 204 User Manual
Polaroid Photo Printer GL10 User Manual
Poulan Lawn Mower 186914 User Manual
PVI Industries Electric Heater PV 6113b User Manual