Desktop Bracket
INSTALLATION GUIDE
Item No.:PDLB372
Thank you for choosing our products
TV Size Range:10"~24"
Max load capacity:15Kg/33lbs
Integrated Cable management
Angle Adjustable
Pyle Audio
1600 63rd st , Brooklyn, NY, 11204
(718)236-8000
www.pyleaudio.com
MADE IN CHINA
-8-
Important: If don't understand about right install ways,
please consult to normal installing specialist.
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 6 Using Cable Management
Step1 Choose fitting position on the desk.
The mount include a cable management function, where cables can be
routed along the length of the arm assembly.
To install cables, you’ll first need to remove the cable covers and set all
Choose the position that the Base you want installed.
Important: Make sure there is enough space to spread display, considering
the show size.
parts aside.
Cable cover
Step2 Attach Base
The thinkness of the table should be smaller than 55mm.
Fig 5
Fig 6
Route the cables along one side of the Inner Arm (nearest the wall plate).
With cables in place, loosely secure the Inner Arm cable covers back in place.
Next, route the cables along the opposite side of the Outer Arm. Be sure to
leave slack in the cable where it transitions between two sides of the Arm
Assembly. With cables in position, loosely secure the Outer Arm cable
covers back in place.
Fig 1
Note: For best system performance, route the AC power cable separately
from the signal cables.
We are not responsible for any personal injury or
product damage due to mishandling, incorrect
WARNING
With all cables in place, pull the display in and out and check that the
arm assembly moves freely, without stretching or damaging the cables,
and then secure the cable covers.
mounting, incorrect assembly or incorrect use of
this product.
Important: DO NOT use a hex wrench on the cable covers, only apply
pressure with your finger.
-3-
-6-
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 3 Arm Assemble
Step4 Installing the LCD
Remove the Tube Cover. Push the Plastic Button down and assemble the Arm.
Adjust the arm assembly to the desired height then free the Plastic Button.
Recover the tube cover.
According LCD hole's size, deep, position to choose bolts. Using chose
bolts(A-D) and washers(E) to install the LCD on the panel. As shown
in Fig3.
Carefully: Don't force the bolt to LCD hole,
avoiding damage to people and instrument.
Don't use electronics drill to fasten screw
A-D
Plastic Buttom
E
Caution :
This Product LCD /Plasma
Arm
Wall Mount Bracket is intended for use only
with the maximum weights indicated .See
apparatus instructions .Use with products
heavier than the maximum weights indicated
instability causing possible injury .
TV Plate
Fig 3
Step5 Hang the display
Firstly lift up the TV plate installed the LCD, making the trough on the
arm fit to the trough on it ,according trough to embed the TV plate into
the wall plate.
Once the TV is positioned in place,
fasten the Tighten Bolts on Receiving
Tighten bolt
Joint clockwise to secure the display
to the Arm Assembly.
Fig 2
Warning: Some TV require two people
to lift, as we are not responsible for any
personal injury or product damage due
to mishandling.
Fig 4
-4-
-5-
Download from Www.Somanuals.com. All Manuals Search And Download.
|