User’s Manual
StereoGraphics Corporation
2171 East Francisco Blvd., San Rafael, CA 94901
phone 800-783-2660 (within USA & Canada )
415-459-4500 (all other areas)
fax
415-459-3020
e-mail
Installation & Setup
Each pair of CrystalEyes eyewear includes two fresh batteries, which are installed at the factory. A compatible
stereo computer grapics or video system must be available to check the operation of the eyewear. To activate
the eyewear, unfold the temple pieces; to turn off the eyewear, fold the templepieces. When not in use, fold
your CrystalEyes eyewear with the temples laying flat across the back of the lenses for convenient storage.
Always fold the eyewear when not in use to maximize the battery life.
Installing the StereoGraphics Emitter
StereoGraphics CrystalEyes requires the use of an infrared emitter in order to synchronize the eyewear in
conjunction with the left and right image sequence on screen. The I/R receiver (located in the center of the
eyewear) must be in line of sight and in range of the emitter for successful operation of CrystalEyes. Please
consult the documentation accompanying your emitter for installation and operation details.
In all cases except for non-stereo-ready PCs, the system or graphics card manufacturer requires specific display
settings to enable Stereo3D mode. Please consult the manual or vendor for your specific graphics subsystem to
determine the proper settings for Stereo3D mode. For best results in using CrystalEyes with standard
workstation displays, set the emitter slightly behind the top edge of the monitor, as shown in Figure 1. In
addition:
• For EPRO, ESGI and ELR emitters, make sure the emitter is switched
to the ON position. Depending on the emitter range needed, switch
the emitter to either the high or low setting.
• The ENT emitter will switch on and off automatically whenever a sync
signal is presented by the graphics card.
• Users of the EPC-2 must switch the emitter from BYPASS to STEREO
MODE and set the emitter range separately.
Figure 1. Display and Emitter
Prescription Glasses
If you normally wear prescription eyeglasses, place CrystalEyes over them. The eyewear will fit
comfortably over most prescription eyeglass frames.
Controls
Specifications
On/Off: Eyewear operation is switched on and off
Optics
by unfolding and folding the eyewear temple pieces.
Shutters:
liquid crystal
32% typical
1000:1 typical
Less than 0.2 milliseconds
Less than 3 milliseconds
80 to 160 fields per second
Automatically selected
Bright mode: Both lenses automatically switch to
full transparency for up to 8 minutes when shielded
from infrared signals. Restoring the infrared signal
returns the eyewear to full operation.
Transmittance:
Dynamic Range:
Close Time:
Open Time:
Field Rate:
Bright Mode:
Infrared Sensor
Angle of View:
Batteries
Two 3 V lithium/manganese dioxide
(NEDA 5004L), including:
90 degrees horizontal
140 degrees vertical
Sanyo
Seiko
CR2032
CR2032
Eveready
Maxell
E-CR2032
CR2032
Technacell CR2032
Panasonic CR2032
Ray-O-Vac CR2032
Weight
Varta
Duracell
CR2032
DL2032
3.3 oz. (93 grams)
Saft
LM2032
Download from Www.Somanuals.com. All Manuals Search And Download.
|