Home Automation Systems, Inc. (800) SMART-HOME
11. Unplug this product from the
wall outlet and refer servicing
E. If the product has been
dropped or the cabinet has
been damaged.
F. If the product exhibits a
distinct change in
Important Safety Instructions
to qualified
personnel
When using your telephone
equipment, basic safety
precautions should always be
followed to reduce the risk of fire,
electric shock and injury to
persons, including the following:
surface. This product should
never be placed near or over
a radiator or heat register.
This product should not be
placed in a built-in installation
unless proper ventilation is
provided.
under the following conditions:
A. When the power supply
cord or plug is damaged
or frayed.
B. If liquid has been spilled
into the product.
C. If the product has been
exposed to rain or water.
D. If the product does not
operate normally by
performance.
Avoid using a telephone
12
13
(other than a cordless type)
during an electrical storm
There may be a remote risk of
electric shock from lightning.
1. Read and understand all
instructions.
7
Do not allow anything to rest
on the telephone cord. Do not
locate this product where the
cord will be abused by
2. Follow all warnings and
instructions marked on the
product.
Do not use the telephone to
report a gas leak in the
vicinity of the leak.
following the operating
instructions. Adjust only
those controls, that are
covered by the operating
instructions because
improper adjustment of
other controls may result in
damage and will often
require extensive work by
a qualified technician lo
restore the product to
normal operation.
persons walking on it.
3. Unplug this product from the
wall outlet before cleaning.
Do not use liquid cleaners or
aerosol cleaners. Use a damp
cloth for cleaning.
Do not overload wall outlets
and extension cords as this
can result in the risk of fire or
electric shock.
SAVE THESE
INSTRUCTIONS
9
Never push objects of any
kind into this product through
cabinet slots as they may
touch dangerous voltage
points or short out parts that
could result in a risk of fire or
electric shock. Never spill
liquid of any kind on the
product.
Do not use this product near
water, for example, near a
bath tub, wash bowl, kitchen
sink, or laundry tub, in a wet
basement, or near a
swimming pool.
Do not place this product on
an unstable cart, stand, or
table. The product may fall,
causing serious damage to
the product.
10 To reduce the risk of electric
shock, do not disassemble
this product, but take it to a
qualified serviceman when
some service or repair work is
required. Opening or
Slots and openings in the
cabinet and the back or
are provided for
ventilation, to protect it from
overheating, these openings
must not be blocked or
covered. The openings
should never be blocked by
placing the product on the
bed. sofa, rug, or other
removing covers may expose
you to dangerous voltages or
other risks. Incorrect
reassembly can cause
electric shock when the
appliance is subsequently
used.
, _
Home Automation SyDsotewnmlosad, Ifrnocm.W(w8w0.0So)mSaMnuAalRs.cTo-mH. OAllMMEanu(a9ls4S9e)a2rc2h1A-n9d2D0o0wnlhoatdtp. ://smarthome.com
Thank you for purchasing the Panasonic Telephone.
C onnec tion
Connect as shown.
Table of Contents
Important safety instructions
C o n n e c t i o n
Initial setting
W a l l
m o u n t i n g
To the EMSS control
L o c a t i o n o f c o n t r o l s
Accessory order information
Important information
Included accessories
Handset
one
Telephone line cord one
Handset
cord
- 3 -
Home Automation SystDeomwnslo,aIdnfcro.m(W80w0w).SSomMaAnuRalTs.-cHomO.MAllEMa(n9u4al9s)S2ea2rc1h-9A2nd0D0owhntltopad:.//smarthome.com
Initial setting
Wall mounting
This unit can be mounted on the wall phone plate
Place the stand on the
center of the unit.
HANDSET VOLUME Selector:
To adjust the volume level of the handset.
NORMAL: Normal voice
HIGH: Loud voice
RINGER VOLUME Selector:
To adjust the volume level of the ringer.
HIGH: Loud ringer
Remove the attached stand.
Mount the unit on the wall
phone plate.
LOW: Low ringer
OFF: No ringer
VOLUME Control:
To adjust the volume level of the speaker volume
MAX: Loud voice
MIN: Low voice
Rotate the stand
that the arrow on the stand
shows UP for WALL
turn so
To temporarily place the handset
down during a conversation, hook
as shown.
MEMORY Switch:
Set to “SET’.
For station programming, set to “PROGRAM”
- 5 -
- 6 -
Download from Www.Somanuals.com. All Manuals Search And Download.
@PAUSE Button:
INTERCOM Button and
Indicator:
Used for making or receiving
an intercom call.
Location of controls
Inserts a pause between the
access number and the
phone number.
@AUTO
and Indicator:
Button
Button:
the last number
dialed.
Used for dialing the system
speed dialing/For storing
functions into memory.
@FLASH Button:
Used for sending the hook
flash signal to the CO line.
Button:
Used for speaking with three
parties at the same time.
Programmable Feature Buttons:
Dials or accesses the system
feature with one touch.
MONITOR Button and
Indicator:
Used for making a call without
using the handset.
@Flexible CO Line Buttons and
Indicators’:
Used for dialing via CO line.
Direct Station Selection, or
Programmable Feature
buttons.
HOLD Button:
Places a call on hold.
@Flexible Message Waiting
Button and Indicator:
‘These functions are limited to the
specified EMSS Control Units.
Refer to the Installation manual.
Used for Message
Direct Station Selection, or
Programmable Feature button,
TRANSFER Button:
Transfers a call to any
extension.
KX-T7050 is compatible with the Panasonic
Switching Systems and can perform most
s y s t e m .
Modular
each
_
Download from Www.Somanuals.com. All Manuals Search And Download.
Accessory order information
*Replacement parts and accessories are available through your local
authorized parts distributor.
(cont.)
information
Important
NOTE:
WARNING:
equipment has been
tested and found to comply
with the limits for a Class
digital device. pursuant to Part
15 of the FCC Rules. These
limits are designed to provide
reasonable
harmful Interference In a
installation. This
equipment generates. uses.
and can radiate radio
frequency energy and, if not
installed and used in
accordance with the
may cause
PREVENT
OR
HAZARD, DO NOT
EXPOSE THIS PRODUCT TO
RAIN OR ANY TYPE OF
MOISTURE
Part No.
Picture
Description
Comment
CAUTION:
To assure continued
7
against
Handset cord
compliance with FCC rules, do
not make any unauthorized
When
programming emergency
numbers and/or making test
calls to emergency numbers:
Remain on the line and
briefly explain to the
25
KX-J25W.B
harmful interference to radio
dispatcher the reason for
the call before hanging up.
Perform such activities in
the off-peak hours, such as
early morning hours or late
evenings.
However,
there is no guarantee that
interference will not occur
particular installation. If this
Important information
2
a
*Keep the unit away from heating
appliances and electrical noise
generating devices such as
fluorescent lamps and motors.
unit should be kept free of
dust, moisture and vibration, and
should not be exposed to direct
sunlight.
not use benzine, thinner, or
the like, or any abrasive powder
to clean the cabinet. Wipe it with
a soft cloth.
If there is any trouble, disconnect
the unit from the extension line
and connect a known working
phone. If the known working
phone operates properly, have it
repaired by one of the specified
Panasonic Factory Service
Centers. If the known working
phone does not operate properly,
check the Electronic Modular
Switching System and the internal
wiring.
equipment does cause harmful
Interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user
is encouraged to try to correct
the interference by one or
more of the following
This telephone provides
magnetic coupling to
a i d s
INSTALLATION:
1) Never install telephone
wiring during a
measures:
-Reorient or relocate the
antenna.
-Increase the
storm.
2) Never install telephone jacks
in wet locations unless the
jack IS specifically
not use any handset other
than Panasonic handset.
between
receiver,
and
for wet
-Connect the equipment into
an outlet on a
different from that to which
the receiver is connected.
-Consult the dealer or an
experienced
3) Never touch uninsulated
telephone wires or terminals
the telephone line
has been disconnected at
the network Interface.
4) Use caution when installing
or modifying telephone
technician for
help.
Download from Www.Somanuals.com. All Manuals Search And Download.
|