ENGLISH
Before use
This Ladies Wet/Dry Shaver can be used for wet shaving with shaving
lather or for dry shaving. You can use this watertight shaver in the shower
and clean it in water. Our research has shown that you can enjoy closer
and smoother shaves using warm water and shaving lather. Treat yourself
to wet lather shaves for at least three weeks and notice the difference. And
our popup trimmer will be able to cut longer hairs with ease.
Cleaning is so simple. Just rinse out the shaving head under the tap or
shower. No mess, no fuss!
Wet/Dry Ladies’ Shaver
Operating Instructions
Model No. ES2235
0
Caution
•
•
•
•
•
•
•
•
Do not leave the appliance in places where it will be exposed to high
temperature or direct contact with sunlight.
Do not leave the shaver in direct sunlight to dry with the outer foil
removed.
Wash the shaver with tap water. Do not use salt water or boiling water. Do
not submerge the shaver in the water for a long time.
Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean
it by using a cloth dampened with soapy water.
Do not take the housing apart as this can affect the watertight
construction.
If the shaver is not used for a long time, remove the batteries to prevent
possible leakage.
If the shaver is not working properly, have it inspected at the place of
purchase or an authorized service center.
Before operating this unit, please read these instructions completely.
1
2
A
C
D
B
F
E
G
3
4
Always use your shaver for its intended use, as described in this manual.
Parts identification (Fig. 1)
0
H
I
B
C
D
E
F
Protective cap
Pop-up trimmer
Outer foil
Outer foil frame
Pop-up trimmer switch
Inner blade
G
H
I
J
K
Foil frame release button
Lock button
ON/OFF switch
Battery cover
6
5
K
J
Cleaning brush
Replacing batteries (Fig. 2)
Before replacing the batteries, wipe the shaver free of moisture to prevent
the inside from getting wet. When the blade speed decreases, this
indicates that the batteries should be replaced with new ones. Do not use
this shaver with weak batteries.
8
7
9
Remove the battery cover, and insert two AAA alkaline batteries observing
the (+) and (–) positions indicated inside the battery compartment. (Fig. 2)
Do not use a new battery with an old battery. Also, do not use rechargeable
batteries.
Remove the batteries when not using the shaver for a long time.
Using your shaver
10
11
12
Caution - The outer foil is very thin and can be damaged if the shaver is
dropped or not handled properly. Check that the foil is not damaged before
each use. Do not use the shaver if the foil is damaged as you will cut your
skin.
•
Remove the protective cap, then keep pressing the lock button
slide the ON/OFF switch up to operate.
H
and
•
Hold the shaver blade flat against the skin. Hold the shaver blade so that
it is gently in contact with the skin.
•
•
•
•
Slowly move the shaver against the direction of hair growth.
Use the pop-up trimmer to cut long hairs.
Gently hold the blade in contact with the skin and move slowly.
Underarm: Lift the arm to stretch the skin and shave in various directions.
(Fig. 3)
Legs: Shave from ankles to knees. (Fig. 4)
Arms: Shave from outside to inside. (Fig. 5)
Bikini: Use the trimmer for the bikini line. Pop up the trimmer and cut
excess hair along the desired bikini line. (Fig. 6)
Replacing shaving head components
Service • Assistance • Accessories
800-338-0552 (In USA)
•
•
•
IN USA CONTACT:
EN MEXICO CONTACTE CON:
Panasonic de México, S.A de C.V.
México D.F.
Panasonic Consumer Electronics
Company
It is recommended that you replace the outer foil at least every year and
the inner blade at least every two years to maintain your shaver’s cutting
performance.
Division of Panasonic Corporation of
North America
One Panasonic Way 1H-1 Secaucus, NJ
07094
Moras 313 Col. Tlacoquemecatl Del Valle
Del. Benito Juarez Mexico, D.F.03200
Tel: 54 88 10 00
Replacing the outer foil
EN PANAMA CONTACTE CON:
Panasonic Latin America, S.A.
Apartado 7592 Panamá 5,
República de Panamá
Teléfono: (507) 229-2955 Fax: (507) 229-
3271
IN PUERTO RICO CONTACT:
Panasonic Puerto Rico, Inc.
San Gabriel Industrial Park 65th Infantry
Avenue KM9.5
Press the foil frame release buttons to remove the outer foil frame. (Fig. 7)
Then, squeeze the front and the back side of the foil frame and lift up one
of the two knobs on the outer foil. (Fig. 8)
Carolina, Puerto Rico 00630
Inserting the new outer foil
Slip the foil into the frame and guide the plastic edges onto the hooks in
the foil frame until it clicks into place. (Fig. 9)
Printed in China
No.1 EN ES (U.S.A.)
Download from Www.Somanuals.com. All Manuals Search And Download.
|