Oregon Scientific Clock NAW881EXT User Manual

DESCRIPTION OF PARTS (FIG. 1)  
A. LCD DISPLAY  
B. IN/OUT SWITCH  
C. VENT HOLES  
DIGITAL INDOOR / OUTDOOR  
THERMO CLOCK  
Model : NAW881EXT  
D. WALL MOUNT HOLE  
E. °C/°F SWITCH , H-HOUR BUTTON,  
M-MINUTE BUTTON  
F. STAND  
G. BATTERY DOOR  
H. OUTDOOR SENSOR PROBE  
BATTERY  
The Thermometer uses 1 x UM-4 (AAA)  
battery (1.5V D.C.)  
Follow these steps to install or replace the  
battery:  
1. Slide the battery door in the direction  
of the arrow.  
2. Insert the battery as indicated by the  
polarity symbols (+ and -) marked inside  
the battery compartment.  
3. Replace the battery door.  
CLOCK  
Press H or M to change the Hour or Minute.  
Press and hold to enter fast-setting mode.  
SELECT INDOOR / OUTDOOR  
TEMPERATURE  
The IN/OUT switch on the front of the  
Themo-Clock selects between indoor /  
outdoor temperature. Slide to the IN  
position for indoor temperature. Slide to  
the OUT position for outdoor temperature.  
SELECT MEASUREMENT UNIT  
INTRODUCTION  
The slide switch on the back of unit selects  
between degree Celsius and Fahrenheit.  
To select Celsius units, set the slide to °C.  
To select Fahrenheit units, set the slide  
switch to °F.  
Thank you for your purchase of this  
Digital Thermo-Clock.  
Your Digital Thermo-Clock is an  
example of superior design and  
craftsmanship.  
RESET UNIT  
In order to optimize its functions, be  
sure to read this instruction manual  
carefully before use.  
If your Thermo-Clock doesn’t operate  
property, take out the battery from the unit  
for 4 to 5 seconds, then reinstall the  
battery.  
Keep this manual handy for future  
reference.  
POSITION THE OUTDOOR SENSOR  
PROBE (FIG. 2)  
FEATURES  
Digital LCD Thermometer with Clock.  
I. SCREW  
Temperature/Clock alternate display  
function at 3 seconds cycle.  
J. WIRE ATTACHMENT  
User selectable indoor or outdoor  
temperature measurement.  
Follow these steps to secure the external  
probe.  
User selectable °C or °F temperature  
units of measure.  
1. Drive a screw (not included) into the  
wall at the location you choose for the  
sensor.  
Wall mounting and table standing  
feature.  
2. Hang the outdoor sensor’s wire  
attachment loop onto the screw .  
3. Route the outdoor sensor’s cord  
(3 meters) through the window.  
NAW881EXT lab test R1  
1
1/9/04, 4:40 PM  
Black  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Iron B 890 User Manual
Miller Electric Welder S 75S User Manual
Moulinex Toaster Isilys Express User Manual
MTD Log Splitter 249 610 000 User Manual
MTX Audio Speaker System MONITOR10 MONITOR12 MONITOR6C MONITOR6 User Manual
Murphy Switch EVS S User Manual
Nexus 21 Marine Radio NX WIRELESS WIND TRANSDUCER User Manual
Optoma Technology Projector EP 610 H User Manual
Panasonic Network Cables CA LSR01U User Manual
Panasonic Scanner 4520 User Manual