Newcon Optik Binoculars BN 5 User Manual

9. CUSTOMER SUPPORT  
Should you experience any difficulties with your NEWCON OPTIK product,  
consult the enclosed manual. If the problem remains unresolved, contact our  
customer support department at (416) 663-6963. Our operating hours are  
9am-5pm, Monday - Friday, standard Eastern Time.  
Operation Manual  
At no time should equipment be sent back to Newcon without following the  
instructions of our technical support department. Newcon accepts no  
responsibility for unauthorized returns.  
To locate the NEWCON Authorized Dealer call:  
Tel: (416) 663-6963 Fax: (416) 663-9065  
The defective products should be shipped to:  
In USA: 3310 Prospect Ave. Cleveland, OH 44115  
In Canada: 105 Sparks Ave., Toronto, ON M2H 2S5  
10. ACCEPTANCE CERTIFICATE  
NIGHT VISION DEVICE  
Serial Number____________________  
Model:  
BN 5  
Corresponds to technical conditions ADSH 3.807.020 TU and is  
admitted for use.  
Date of production -____________________  
Place for seal  
NIGHT VISION BINOCULAR  
Quality inspector ____________________  
(signature)  
BN 5  
In USA : 3310 Prospect Ave. Cleveland, OH 44115  
In Canada : 105 Sparks Ave., Toronto, ON M2H 2S5  
Tel: (416) 663-6963 Fax: (416) 663-9065  
12  
Download from Www.Somanuals.com. All Manuals Search And Download.  
If the view still does not seem in focus, clean the lenses; they could be  
foggy or dusty.  
NEVER disassemble the unit. This device contains high  
voltage, which may be hazardous to your health!  
Unit flashes  
NEVER expose the opened objective lens of the activated unit  
in daylight. (Note: 1st generation units remain active for a few  
minutes after switching the unit off). If you test the device  
during daytime, caps must cover the objective lenses. There is a  
tiny hole in the lens caps to provide enough light for such  
testing.  
It is normal for the unit to flash within the first 2 minutes of activation.  
If the flashing continues afterwards the following is a possible cause:  
bright environment (even with the caps closed!)  
Condensation accumulates on the parts.  
It is O.K. to use the unit in cold. However, when the unit is brought  
from the cold into a warm environment, it has to warm up for up to 2  
hours (not minutes!). Only then it is allowed to turn it on again.  
NEVER aim active unit at intense light sources (i.e. lights,  
headlamp, campfires, the moon, etc.)  
Visibility decreases and / or disappears.  
NEVER reverse the batteries polarity.  
Bright light sources (moon, projectors or headlights) may cause  
visibility to degrade or even completely disappear. Move the  
binoculars away from the light source immediately. The image should  
be restored in within 2 minutes.  
NEVER connect the unit to external power sources.  
ALWAYS keep the objective lenses covered when not in use  
ALWAYS store in a warm dry place when not in use  
ALWAYS remove battery when not in use for a long period  
Poor atmospheric conditions such as fog, haze or extremely dark  
environments will decrease the visibility distance of the unit.  
8. WARRANTY:  
NEWCON OPTIK warrants this product against defects in material  
and workmanship for one year from the date of the original date of  
consumer's purchase, but no more than 18 months from the date of  
manufacturing. Should your NEWCON product prove defective during  
this period, please bring the product  
THANK YOU  
FOR PURCHASING THE NIGHT VISION BINOCULAR BN 5. PLEASE  
DEMAND TO CHECK THE DEVICE FOR PROPER OPERATION  
WHEN BUYING IT. PLEASE READ ALL THE INSTRUCTIONS  
CAREFULLY BEFORE USING.  
3
10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
6.3 Operation at Night  
2. OVERVIEW  
The night vision binocular BN 5 is observational optico-  
Take off the lens covers (7) from the lenses (6). Turn on the device  
by pushing and holding the “On” button (4). In case of insufficient  
lighting when observing an object which is situated not far from  
the viewer, turn on the infrared illuminator by pushing and holding  
the button (3). As soon as the “I/R On” button is released the  
infrared illuminator turns off.  
electronic device, intended for examining objects and orientation at  
nighttime or under dark conditions. The unit utilizes 2 (two) image  
intensifiers which amplify available moonlight, starlight or man-made  
light. The binocular was designed to be easy to use, and provide many  
years of operation.  
Note: The illuminator will be activated only if the unit has  
been already switched on by the button (4).  
Some of the typical activities where the BN 5 Night Vision  
Binocular can be useful:  
Note: If you look directly at front of the binocular when  
infrared illuminator is on it appears as a red dot at a size of a lit  
cigarette. The illuminator can be also detected using night vision  
device. Therefore, if you need to remain undetected, use the  
illuminator with caution.  
law enforcement  
wildlife observation  
security  
Note: The unit automatically turns off after few minutes. This  
feature can be used to economically utilize the batteries power by  
periodically switching on and off the device during operation.  
If brightness of the screen decreases, replace the batteries. Put  
protective lens caps back on the lenses after operation. If you don’t  
intend to use the device during long time remove the batteries  
from the battery compartments to avoid any damage of the device  
in case of occasional leakage of electrolyte from the batteries.  
search and rescue  
hunting  
Features  
Built-in infrared illuminator allows observations in total darkness  
(i.e. basement, cave or dark room);  
2 (two) image intensifiers, one for each eye; provide stereo vision;  
Independently adjustable eyepieces;  
7. TROUBLESHOOTING  
Interpupilary distance adjustment;  
Lightweight and comfortable;  
Soft rubberized eyepieces make the viewing more comfortable;  
Water-resistant  
The binocular does not work.  
Check if the battery is installed properly.  
Check the charge of the battery. Replace if it is weak.  
Works on standard AA batteries.  
The image does not appear in focus.  
Bring the inspected object to the center of the image. Turning the  
eyepieces (5) adjust to achieve the clearest image on the screen.  
Repeat the steps of focusing if necessary  
9
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Warning! After transportation or keeping the device at  
temperature lower than -25°C (-13°F), the device must be warmed  
up to ambient temperature for at least 2 hours.  
6. OPERATION INSTRUCTIONS  
WARNING!  
NEVER OPERATE YOUR NIGHT VISION DEVICE  
DAYLIGHT AREAS WITHOUT THE LENS COVERS ON!  
IN  
Precautions  
NEVER DIRECT THE LENS IN THE DIRECTION OF BRIGHT  
LIGHT!  
BN 5 is a sophisticated precision optical instrument equipped with  
electronics. Therefore, it should be handled with due care.  
Keep your device away from direct sunlight, impacts, dust,  
moisture, and sudden changes of temperatures.  
6.1 Pre-starting procedures.  
Unpack the device. Open the battery house cover (2), and install the  
battery. Observe the correct polarity indicated on the housing. Close  
the battery house cover.  
Cleaning of optical surfaces is possible only with professional  
camera lens cleaning supplies.  
Do not touch optical surface with fingers. Doing so may  
damage the anti-reflection coating.  
6.2 Daytime testing.  
To clean the exterior of the device, use only a soft clean cloth.  
Do not take the covers off the lenses if not necessary.  
Keep away from heating appliances and central heating.  
Make sure to switch off the unit during periods of non-  
operation and when storing the device for long period of time.  
Do not apply superfluous efforts at work with lens assembly,  
agile elements and thread connections.  
Due to considerable optical magnification of the eyepiece some  
small structures inside the tube coating may be seen in the field of  
view in the form of dark and/or white points, which does not affect  
the serviceability of the device  
The resolving power (resolution) may change in the direction from  
the center towards the perimeter of the field of view. This is an  
inherent feature of the image tube type utilized in the device. We  
would recommend to place the scene of observation in the center  
of the field of view.  
Check the functioning of the device by switching it on (push and hold  
button 4) and looking through the eyepieces (5). (Make sure the lens  
caps are on while operating during the day). If power supply and  
the batteries are O.K., you will see greenish-lit screen. If the screen is  
not lit, check the batteries. Replace the battery if necessary. If  
everything works, now it is a great time to fill the warranty card.  
Note: The unit will remain on for up to several minutes after  
releasing the “On” button. This is normal.  
Direct the device on an object placed within 8-15m from the  
viewer. Turning the eyepieces (5) try to achieve the sharpest image on  
the screen of the image tube. Adjust the distance between the eyes by  
folding the binoculars until two images merge into one. If you wear  
glasses fold the eyepiece rubber guards (5) to obtain closer focus  
distance.  
5
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
3. COMPONENTS  
5. CONSTRUCTION  
BN 5 are supplied with the following components:  
5
5
BN 5  
1
1
2
1
1
2
3
4
Strap  
Lens caps  
Manual  
Warranty registration card  
AA batteries (optional)  
4. SPECIFICATIONS OF BN 5  
Magnification, X  
Field of view, degrees, not less  
Dioptric correction  
2.4  
26°  
± 4  
2
2
6
6
Interpupillary distance  
54-76mm  
Required light levels:  
Without illuminator  
From:0.1 lux  
(cloudy moon less nigh)  
To:1.5 lux (twilight)  
Total darkness  
1
With infrared illuminator  
Operating temperature  
(air humidity 80% at 20°C)  
Battery  
Battery life, hours (0.8 Ah capacity @25±10°C)  
With I/R  
7
7
30°C … +35°C  
Pic.1  
2xAA  
4
1. I/R illuminator  
2. Battery house cover  
Without I/R  
Dimensions, mm  
Weight, kg  
6
165x204x67  
1.2  
3. I/R illuminator “On” button  
4. “Power on” button  
5. Eyepieces  
6. Objective lenses  
7. Lens covers  
NOTE: As the design is being continuously improved some parameters may differ  
from those given above  
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.  

Milan Technology Switch MIL S3580 User Manual
Miller Electric Welder EXTREME 360 User Manual
Miller Electric Welding System Big Blue 402D User Manual
MTD Lawn Mower 111 200 User Manual
MTD Tiller 214 412 000 User Manual
Nikon Camera Lens AFF3AF User Manual
NordicTrack Home Gym NTM58020 User Manual
P3 International Indoor Furnishings P7650 User Manual
P3 International Insect Control Equipment P7880 User Manual
Panasonic All in One Printer KX F1070 User Manual