INSTALLATION & OPERATION MANUAL for the BG-1T
Horizontal Conveyor Grilling Toaster
The BG-1T Horizontal Conveyor
Grilling Toaster is capable of one-
sided toasting of a variety of bread
products such as: buns, Texas
toast, etc..
The BG-1T has two 5” wide con-
veyor belts. These two conveyor
belts are offset ¼” to accommo-
date the difference in thickness
between bun crowns and heels.
Set the variable conveyor speed
control to desired setting and
operation is nearly automatic. A
convenient loading ramp is
equipped with all models.
NOTE: This manual contains important safety, Installation & Operation Instructions. Require all operators to read
this manual before using this unit. Failure to follow the instructions contained in this manual may cause injury,
damage to the unit, and will void the warranty.
THIS MANUAL SHOULD BE RETAINED FOR FUTURE USE
0101-JDM
07113
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTROL PANEL FEATURES
1. Main Power On/Off Switch – supplies power to the toaster.
2. Power Indicator Light – this red light will illuminate when heating element is energized. Main Power Switch must be
in the “ON” position.
3. Conveyor Speed Control – regulates the speed of the conveyor belt. Rotate this control to a higher number to
increase the speed of the conveyor belt. Rotate to a lower number to decrease speed of the conveyor belt.
OPERATION INSTRUCTIONS
1. Set Main Power On/Off Switch to the “ON” position. Red Power Indicator Light will illuminate.
2. Set Conveyor Speed Controlfor desired setting.
3. PRE-HEAT FOR 30 MINUTES.
4. After pre-heat period has elapsed, load product on loading ramp. Make sure that the CROWNS are placed on the right
side of the conveyor belt and the HEELS are placed on the left side of the conveyor.
ALWAYS PUT CUT SIDE OF BUN FACING THE PLATEN SURFACE.
5. If the product you are toasting is too light, decrease the speed of the conveyor belt. If the product is too dark, increase
the speed of the conveyor belt.
CLEANING INSTRUCTIONS
CAUTION: UNPLUG UNIT AND ALLOW PLATEN TO COOL BEFORE CLEANING.
1. Do not use product such as steel wool on any part of the toaster.
2. The BG-1T conveyor grilling toaster is designed for easy cleaning. The lustrous outer surfaces need nothing more than
a daily wiping with a soft, damp cloth.
3. Daily cleaning of Platen and coated Platen Sheets: After platen has cooled thoroughly, remove the coated platen
sheet. Wipe the sheet with a soft, damp cloth and dry thoroughly. Lay coated platen sheet flat. Do not crinkle. With
platen in the upright position, scrub with an abrasive plastic pad (i.e. ScotchBrite) until platen is “sparkly” clean.
4. Daily cleaning of conveyor belt: With the conveyor belt running, use a stiff bristled brush (NOT METAL) and with side
to side motion, brush away any crumbs that may be present.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
1111 N Hadley Rd.
Fort Wayne, In 46804
Tel. 800-701-2992
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|