K00365 ADAPTER KIT
Installation Instructions
1. The K00365 kit is used for installing a Q-0320, Q-0370, Q-0420, S-0322, S-0422 ice machine or a QC/QF flaker on a
B or S-Series 30” (76cm) wide bin or a Q-Series 30” (76cm) wide dispenser.
2. Installation (bin or dispenser must be level before starting):
A. Remove existing foam tape from top of bin or dispenser. When installing a K00365 on a Manitowoc dispenser,
remove the gray side trim pieces on the top sides of the dispenser.
B. Place support angle on bin or dispenser, as shown, prior to adapter installation. Locate foam tape from kit in the
positions on top of bin, as shown. Note locations of narrow and wide tape.
C. Place adapters on bin or dispenser, as shown. Make sure the two holes from the support angle and adapters are
aligned on the side.
D. Using the adapters as templates, drill three 5/32” (4mm) holes, .500” (12.7mm) deep maximum, in bin or
dispenser. Warning: Do not drill through interior liner. Attach with 10-24 x .500” screws provided.
E. Apply foam tape to the edge of the adapters. Note: It is recommended to RTV intersections and along front
inside edge of foam tape (see drawing) to prevent water tracking.
3. Refer to ice machine installation manual for ice machine installation procedures.
17” of
30” of
Wide Tape
Narrow Tape
Adapter
ICE
MACHINE
17” of
Narrow Tape
Wide Foam Tape
(from Kit)
2” of
Wide Tape
Support
Angle
BIN
5” of
Wide Tape
2” of
Wide Tape
5” of
Wide Tape
20” of
Wide Tape
Download from Www.Somanuals.com. All Manuals Search And Download.
|