Manfrotto Stereo Amplifier PS1150M User Manual

PS1150M Mono Amp Quick Start Guide  
Need help?  
For technical assistance, call  
the Jensen customer  
support line at 1-800-323-4815.  
RCA Cable  
Remote /  
Power Antenna  
Turn-on Wire  
CAR STEREO /  
SOURCE UNIT  
SPEAKERS  
( )  
( )  
+
AMP  
( )  
BATTERY  
POWER  
REM  
+12V  
GND  
-
( )  
+
Minimum Wire Size:  
+12V - 10 AWG  
Ground - 10 AWG  
CHASSIS GROUND  
Fuse Block or Fuse Holder  
NOTE: An optional wiring kit is required. See  
your local Circuit City store or installation shop.  
1. Disconnect the negative (-) battery terminal.  
difficult to find, an alternative is to cut a piece of 1/2 inch wood slightly larger than  
the amplifier mounting area (covered with automotive type carpeting). Mount the  
piece of wood, and then mount the amplifier to the carpeted wooden mount.  
4. Ground the amplifier using the same AWG wire size used for the power cable. Make  
sure the ground location is a clean, unpainted metal surface.  
NOTE: Check your vehicle's owner's manual before disconnecting the battery.  
Disconnecting the battery in some vehicles may require an anti-theft code when  
reconnecting for stereo operation. Some vehicles may run rough after reconnecting  
the battery and require service to have the on-board computer reset. Check with  
your local dealer if you are uncertain.  
2. Run suitable AWG wire to where the amplifier will be mounted (run 1 foot extra than  
you think you will need). Use rubber grommets where wires will pass through the  
firewall or other areas of the vehicle. Make certain a fuse holder is placed within 18  
inches of the vehicle battery this is mandatory. Do not place a fuse in the fuse  
holder at the battery at this time.  
5. Run the RCA and Remote turn-on lead to the amplifier from the head unit.  
6. Run speaker wires (16 AWG or larger) from your speakers to the amplifier.  
7. Place a suitable size fuse in the fuse holder at the battery.  
8. Ensure that the input level control is set to "MIN".  
9. Turn on the head unit and make appropriate amplifier adjustments.  
3. Mount the amplifier on a flat surface. Since a flat surface in a modern vehicle is often  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Liebherr Kitchen Entertainment Center 7083 103 00 User Manual
Life Fitness Home Gym SU05 User Manual
Linear Smoke Alarm DXT 72 User Manual
Linksys Network Card WPC54A User Manual
Listen Technologies Portable Speaker LR 316 User Manual
Logitech Mouse 910 001919 User Manual
LST Smoke Alarm BEAMLRK User Manual
Lucent Technologies Projection Television 108196197 User Manual
Maytag Washer Dryer Neptune Washer User Manual
Microsoft Video Games X08 40995 User Manual