Continued
2
Step1 Adjusting the length of this Soundbar
It is recommended to use drywall Molly anchors that have a minimum
of 5 lbs. holding strength to use with these brackets. Mount the 2
Mounting Brackets where you marked the six screw holes for the Molly
anchor locations.
Expandable Soundbar Speakers
You can adjust the length of the unit to fit yourTV screen size (from 32 to 46 inch) using rotary knob at rear of this unit.
(The factory default is minimum length of the unit.)
To extend the Soundbar
To shorten the Soundbar
Six screw positions
you marked
•
Turn rotary knob clockwise.
•
Turn rotary knob counter clockwise
Check Soundbar rear jack panel and its layout before you proceed with Step 2.
•
•
Make sure that both brackets are securely mounted to the drywall.
Make sure that the width of this Soundbar fits yourTV screen size
and the power cord / audio cables are securely connected before wall
mounting the Expandable Soundbar.
Hook the Soundbar onto Mounting Brackets.
Step2 Connect to yourTV
If yourTV has an Audio Out L/R
.
If yourTV has no Audio Out L/R, but has a
Headphone jack
(MSB5305 only)
Complete.
Control panel
OR
Please visit our website at WWW.MAGNAVOX.COM
for online Owner’s Manual.
d
a
1
2
3.5mm MP3/Headphone connection cable
b
Analog Audio L/R cable
e
•
If you connect to yourTV through supplied 3.5mm MP3/Headphone
connection cable, make sure that any surround mode, auto volume function
andTV speakers on yourTV are Off. (See reverse page for volume setup.)
TruSurround
TruVolume
WOW
Mute
MAGNAVOX is a registered trademark of Philips Electronics North America Corporation and is used by
Funai Electric Co., Ltd. and Funai Corporation, Inc. under license from Philips Electronics North America.
c
f
Supplied accessories
Step3 Connect to the Power and Subwoofer
Expandable Soundbar
Sub woofer
(MSB5305 only)
a
b
e
d
2 AC pin connector
3 blade connector
Quick Start Guide
Remote Control and Battery
Mounting Bracket
( x 2)
Quick Start Guide
Subwoofer
c
AC-DC
Adapter
AC-DC
Adapter
DC 24V
DC 20V
MSB5305 only
•
Make sure that the Soundbar is not muted after youTurn the unit On.
Speaker feet
for table top
Analog Audio L/R cable 3.5mm MP3/Headphone
connection cable
(3.5mm-3.5mm)
(POWER-ON/STANDBY-ON)
Press toTurn the unit On or go into Standby mode.
Step4 Place the Soundbar
Table top placement
b
AC-DC Adapter and AC power cord AC-DC Adapter and AC power cord
TruSurround HD
TruVolume
WOW
ToTurn On the SRSTrusurround HD.
ToTurn On SRSTruVolume.
ToTurn On SRS WOW.
Wall mounting using brackets
You can use the Wall MountingTemplate on the back of this page to mark the
Top screw positions. (Mounting Bracket Screws are not included)
1
2
for Soundbar
for Subwoofer
(MSB5305 only)
For secure table top placement, affix 2 self-adhesive rubber feet to the
bottom of the expanded part of this unit using the below guide.
c Volume
[Control panel]
To/u) for Soundbar.
[Remote control]
Measure yourTV width to find the center, then 3 15/16 from the center
line mark the 2 top screw positions which are 2”(min.) to 2-½”(max.)
from the bottom edge of theTV. Then mark the other 4 bottom screw
positions using the brackets.
Before you move to Step 1
MAIN
Press to adjust volume up ()/down () for Soundbar.
You must take an insulation sheet out before you use the remote control.
SUB
Press to adjust volume up ()/down () for Subwoofer.
*This function only works for MSB5305.
Your TV
d
e
Source
2”- 2-½”
Press to select source 1 (AUX1) or source 2 (AUX2) of connected
devices to this Soundbar
3-15/16”
3-15/16”
Mute
Bottom view
Center line
Press to mute the sound and recover the sound.
f Infrared sensor
Complete.
Continued in 2 above.
Receives IR signals from remote control.
Download from Www.Somanuals.com. All Manuals Search And Download.
|