Lux Products Thermostat WTR064 User Manual

52079  
Part No. WTR064  
Accurately Displays  
Current Outdoor Temperature and  
Enables Dual Fuel* and  
Automatic Humidity* Capability  
on the LUXPRO® Thermostat  
* SELECTED MODELS ONLY  
Before you begin, make sure that the time on the LUXPRO® thermostat is set.  
If not, set the time before starting the installation.  
INSTALLATION INSTRUCTIONS  
1. Install the included 2 AA batteries by removing the 4 screws located at the back of the  
transmitter. The LED on the transmitter will flash every 6 seconds. Do not close the  
battery compartment yet.  
2. Remove the top cover of the thermostat and plug the receiver into the white connector  
located to the bottom left under the touch screen. (A)  
3. Place the antenna wire into the 4th vent as shown (B).  
Clip the receiver into the 1st vent (C).  
4. Press the “RESET” button (D) on the receiver module for 10 seconds to activate the  
transmitter and receiver. The outdoor temperature will appear on your thermostat within  
5 minutes. Make sure that the dot to the left of the outdoor temperature (E) flashes  
approximately every 15 seconds. If after 5 minutes the outdoor temperature is not  
displayed on the thermostat or if the dot to the left of the outdoor temperature (E) is not  
flashing, unplug the receiver module from the thermostat, remove batteries from the  
transmitter and start the installation procedure again.  
5. Close the battery compartment and position the transmitter in a permanent location that  
is sheltered from the elements. After placing the transmitter in a permanent location,  
ensure that the dot to the left of the temperature (E) flashes approximately every 15  
seconds. If the dot to the left of the temperature (E) is not flashing, change the  
transmitter location.  
6. Use the chart below as a reference for the recommended humidity settings.  
WARNING: Adjusting the humidity control higher than the recommended setting may cause  
condensation, resulting in possible damage to the home.  
E
A
D
C
B
HUMIDITY SETTING RECOMMENDATIONS  
At Outside Temperatures Of:  
Humidity Setting:  
-20°F (-29°C)  
-10°F (-23°C)  
0°F (-17°C)  
+10°F (-12°C)  
+20°F (-6°C)  
15 %  
20 %  
25 %  
30 %  
35 %  
40 %  
Over +32°F (0°C)  
Downloa©d f2r0o0m9 LWUwXwPR.SOoDmUaCTnSuaClOs.RcPoOmR.AATIlOl MN.aAnLuLaRlsIGSHeTaSrcRhESAEnRdVEDDownload.  

Land Pride Brush Cutter RCR1660 User Manual
Life Fitness Elliptical Trainer GK61 00002 0047 User Manual
Logitech Webcam C310 User Manual
Lucent Technologies Network Card VPN Firewall Brick 20 User Manual
Lucent Technologies Network Router 20A USB User Manual
Mackie Speaker HD1501 User Manual
Mackie Speaker SA1530Z User Manual
Magellan GPS Receiver 350H User Manual
Marshall electronic Flat Panel Television V R102DP HD User Manual
Meade Binoculars CV 5 User Manual