Introduction
Thank you for purchasing the LINDY PCI Ethernet
UTP/BNC Card. This 32-Bit PCI card supports 10Base-2,
10Base-5 and 10Base-T networks and full-duplex
operation (UTP/STP).
Packing List
PCI Ethernet
UTP/BNC Card
ƒ
ƒ
ƒ
ƒ
32-Bit PCI Ethernet Card
BNC T-Piece
Software Driver Disk
This manual
User Manual
English
Features
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
32-Bit PCI Ethernet Card
BNC and RJ-45 Ethernet connectors
Supports Full-Duplex operation (UTP/STP only)
Plug & Play installation
Auto detects media type – BNC and STP
Complies with IEEE802.3 CSMA/CD, 10Base-2,
10Base-5 and 10Base-T, 10/20Mbps transfer rate
Built-in LED’s to indicate network activity
Diagnostic and driver software included
Supports Netware ODI & IPX, NDIS driver for LAN
manager, Windows 95/98/ME/2000/XP, SCO UNIX
driver & packet driver for TCP/IP
ƒ
ƒ
ƒ
LINDY No. 70939
For Home and Office Use
Tested to Comply with FCC Standards
Hardware Installation
Software Installation
1. Switch off the computer and remove the case cover.
2. Locate an available 32-Bit PCI slot; remove the
expansion slot blanking plate and retain the screw.
3. Carefully insert the card into the PCI slot. Ensure the
card is firmly in place and secure using the retained
screw.
For Windows ME/2000/XP the card will be detected by the
operating system and the software will be installed
automatically.
For Windows 95 and 98 the card will be detected
automatically and you will be prompted to insert the driver
disk. Please also have at hand your operating system CD
in case Windows requires files from it.
4. Replace the case cover.
5. Connect the card to the network using thin or twisted-
pair cable, depending on the connector you are using.
6. If the card is to be used in Full-Duplex mode (UTP or
STP only), it should be connected to a switching hub
that supports Full-Duplex operation.
For all other operating systems refer to the Help program
located on the supplied disk for installation instructions.
Certification
LED Indicators
Note:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules.
This card is equipped with two LED indicators which
display the card status -
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
LINK: When a network link is detected this LED will light
up. If this indicator is OFF, check the cable connections
ACT: This LED lights up to indicate the card is powered
up. It flashes to show network activity.
•
•
•
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
which the receiver is connected
Consult the dealer or an experienced radio/television technician for help
January 2005
Download from Www.Somanuals.com. All Manuals Search And Download.
|